sensor SUZUKI NEXA 2015 1.G User Guide
[x] Cancel search | Manufacturer: SUZUKI, Model Year: 2015, Model line: NEXA, Model: SUZUKI NEXA 2015 1.GPages: 288, PDF Size: 8.02 MB
Page 95 of 288
Downloaded from www.Manualslib.com manuals search engine
% ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
64MS066
If the control lever has on “AUTO” position,
you can change the system’s sensitivity to
rain/snow by turning the knob of the control
lever forward for increased sensitivity or
rearward for decreased sensitivity.
61M0219
(1) Rain sensorNOTE:
• Under the following conditions, the rain
sensor may not be able to sense rain or
snow correctly, and thus the rain-sensing
wiper function may not work or may work
incorrectly. (Use a position other than
“AUTO” under these conditions.)
– Rain or snow does not hit the rain sen-
sor area of the windshield, or the snow
is not of a type that is able to be
detected by the sensor.
– The rain sensor area is covered with
mud, ice or other similar substance.
You should remove any foreign sub-
stance.– There were already raindrops on the
windshield before starting rain-sensing
wiper operation. You should remove
the raindrops by operating the wipers
under manual control.
– The rain sensor is hotter than 80°C
(176°F) in the sun or lower than –10°C
(14°F) in freezing weather. (The wip-
ers do not operate under this condi-
tion.)
– The windshield is coated with a water-
repellent substance, which causes
raindrops to run down quickly. This will
give a clearer view and the wipers
may seem to operate too frequently. In
this case, decrease the system’s sen-
sitivity.
– The sensor area is covered with a
sticker.
– The wiper blades are damaged. You
should replace them.
•
The following conditions may indicate
problems with the rain-sensing wiper
system. If your system exhibits any of
the following conditions, have it
inspected by an D X W K R U L V H G 0 D U X W L
6 X ] X N L Z R U N V K R S.
– Rainfall/snowfall rate varies but the
wiping interval remains constant.
– Rain/snow is falling but the wipers do
not operate. ( ; $ 0 3 / (
(1)
& $ 8 7 , 2 1
Page 117 of 288
Downloaded from www.Manualslib.com manuals search engine
2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
& D Q F H O O D W L R Q R I W K H & U X L V H & R Q W U R OThe “SET” indicator light will go off and the
cruise control will be canceled temporarily
with following procedures:
• Push the “CANCEL” switch (2).
• Depress the brake pedal.
• Depress the clutch pedal.
• The vehicle speed falls more than about
20 percent from the set speed.
• Any time the vehicle speed falls below
40 km/h (25 mph).
To resume the previously set speed, push
the “RES +” switch (3) and turn on the
“SET” indicator light. Besides, the vehicle
speed has to be above 40 km/h (25 mph)
when the vehicle is not in the above condi-
tions.
To turn off the cruise control system, push
the “CRUISE” switch (1) and make sure
the “CRUISE” indicator light is off.
Also, if the malfunction indicator light in the
instrument cluster comes on or blinks, the
cruise control system will be turned off.
NOTE:
If you turn off the cruise control system, the
previously set speed in the memory is
cleared. Reset your cruising speed again.
3 D U N L Q J 6 H Q V R U V L I H T X L S S H G
61MM0A192
(1) Symbol representing an obstacle
detected by parking sensor*
* This symbol represents an obstacle
that is located to the right rear at
the vehicle.
• The parking sensor system uses ultra-
sonic sensors to detect obstacles near
the rear bumper. If obstacles are sensed
while you are parking or moving the
vehicle slowly, the system warns you by
sounding a buzzer and displaying sym-
bols representing the obstacles on the
information display in the instrument
cluster.
• The system emits an ultrasonic wave
and the relevant sensor detects the
return of the wave reflected by an obsta-
cle. The system measures the time
taken by the ultrasonic wave to reach the
obstacle and return from it, from which it
determines the obstacle’s position.
• The parking sensor function can be used
when you press the engine switch tochange the ignition mode to “ON”, the
gearshift lever is in “R” position and the
parking sensor switch is in the “ON”
position. This function is helpful in the
following cases: pulling over to the curb;
parallel-parking the vehicle; steering the
vehicle into a garage; driving along an
alley; and moving slowly in a place with
obstacles.
(1)
: $ 5 1 , 1 *
Page 118 of 288
Downloaded from www.Manualslib.com manuals search engine 2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
6 H Q V R U / R F D W L R Q V 2 Q W K H U H D U E X P S H U
64MS170
(1) Rear center sensors (2 places)
(2) Rear corner sensors (2 places) : R U N L Q J V H Q V R U V
The sensors that work depends on the
position of the gearshift lever as follows:
$ S S U R [ L P D W H D U H D V Z K H U H R E V W D F O H V F D Q
E H G H W H F W H G
64MS007
• Any obstacle within about 20 cm (8 in)
from the sensor or just below the sensor
is not detectable.
• The sensors can detect an obstacle up
to about 1.5 m (5 ft) from the rear of
vehicle.
NOTICE
Page 119 of 288
Downloaded from www.Manualslib.com manuals search engine
2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
NOTE:
• Thin poles or obstacles lower than the
sensors may become undetectable as
the vehicle moves closer to them even if
they have been detected from longer
distances.
• The distance calculated by the system to
a road sign or similar obstacle may be
shorter than the actual distance.
: $ 5 1 , 1 *
(Continued)
Page 120 of 288
Downloaded from www.Manualslib.com manuals search engine 2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
+ R Z W R 8 V H W K H 3 D U N L Q J 6 H Q V R U 3 D U N L Q J V H Q V R U V Z L W F K
61MS403
(1) Parking sensor switch
(2) Indicator
(2)
(1)
• When the ignition mode is “ON” and the indicator light in the parking sensor switch is on,
indicating that the parking sensor is ready for operation under the following conditions:
– The gearshift lever is in the “R” position.
– The vehicle’s forward moving speed is not more than approx. 9 km/h (6 mph) when
decelerating the vehicle such as for parking.
– The vehicle’s forward moving speed is not more than approx. 13 km/h (9 mph) when
accelerating.
• To deactivate the parking sensor, push the parking sensor switch and make sure the
indicator light goes off.
NOTE:
If you push the parking sensor switch from the OFF to ON position when the ignition mode
has been changed to ON by pressing the engine switch, the inside buzzer sounds. 6 Z L W F K S R V L W L R Q 6 W D W H ( ; $ 0 3 / (
ON
• When the indicator light is on and all necessary conditions are
met, system becomes ready for operation.
( ; $ 0 3 / (
OFF
• The system does not operate. Push the switch to turn off the
indicator if you do not wish to use the parking sensor.
Page 121 of 288
Downloaded from www.Manualslib.com manuals search engine
2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
2 E V W D F O H , Q G L F D W L R Q E \ 3 D U N L Q J 6 H Q
V R U
64MS008
(1) Obstacle detected by rear center sen-
sors
(2) Obstacle detected by rear corner sen-
sors
(1) (2) (2)
( ; $ 0 3 / (
Upon detecting an obstacle, the parking sensor causes an interior buzzer to sound and a
symbol representing the obstacle appears on the information display in the instrument
cluster.
• A different symbol is displayed depending on the direction and distance of the obstacle.
• A buzzer located behind the rear seat sounds when a sensor at the rear detects an
obstacle.
• Warnings when obstacles are detected by corner sensors
• Warnings when obstacles are detected by center sensors
NOTE:
• Symbols are displayed with a short delay after the detection of obstacles.
• If the system detects multiple obstacles simultaneously, the display shows all of their
positions using the corresponding symbols. However, the buzzers will sound only for
the nearest obstacles. ' L V W D Q F H D S S U R [ % X ] ] H U 6 \ P E R O
45 – 60 cm
(18 – 24 in)Short beeps at short intervals Three lines
35 – 45 cm
(14 – 18 in)Short beeps at very short intervals Two lines
Less than 35 cm
(14 in)Continuous beep One line
' L V W D Q F H D S S U R [ % X ] ] H U 6 \ P E R O
60 – 150 cm
(24 – 59 in)Short beeps at long intervals
Three lines
45 – 60 cm
(18 – 24 in)Short beeps at short intervals
35 – 45 cm
(14 – 18 in)Short beeps at very short intervals Two lines
Less than 35 cm
(14 in)Continuous beep One line
Page 122 of 288
Downloaded from www.Manualslib.com manuals search engine 2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
6 H W 6 H Q V R U VYou can select either the normal or trailer
mode of the parking sensor via the informa-
tion display. Refer to “Information Display”
in the “BEFORE DRIVING” section.
1 R U P D O P R G H
All sensors operate. Use this mode under
normal conditions.
7 U D L O H U P R G H
The rear corner and rear center sensors are
inhibited from operating. Use this mode
when towing a trailer.
NOTICE
0 D N H V X U H W K H Q R U P D O P R G H L V
V H O H F W H G Z L W K W K H S D U N L Q J V H Q V R U
Z K H Q V W H H U L Q J W K H Y H K L F O H L Q W R D
J D U D J H , I W K H S D U N L Q J V H Q V R U L V O H I W L Q
W K H W U D L O H U P R G H W K H U H D U F R U Q H U D Q G
U H D U F H Q W H U V H Q V R U V D U H Q R W I X Q F W L R Q
L Q J
: D U Q L Q J D Q G , Q G L F D W R U 0 H V V D J H VIf there is a problem or warning regarding the parking sensor system, a message is dis-
played on the information display in the instrument cluster, and a symbol blinks and the
buzzer sounds. If a message is displayed, follow its instruction.
0 H V V D J H 6 \ P E R O % X ] ] H U 3 U R E D E O H F D X V H D Q G U H P H G \
Two blinking
lines in a sen-
sor location.Series of
double
beepsThere may be problem with the
parking sensor system.
Have your vehicle inspected by
an D X W K R U L V H G 0 D U X W L 6 X ] X N L
Z R U N V K R S.
One blinking
line in a sensor
location.Series of
single
beepsThe indicated sensor is contami-
nated.
Wipe it clean with a soft cloth.
Page 169 of 288
Downloaded from www.Manualslib.com manuals search engine
2 7 + ( 5 & 2 1 7 5 2 / 6 $ 1 ' ( 4 8 , 3 0 ( 1 7
0 6 (
• To return the blower speed selector (2),
air intake selector (3), and “MODE”
switch (4) to automatic operation, push
the “AUTO” switch (8).
64MS149
Be careful not to cover the interior tem-
perature sensor (10) located between the
steering wheel and the climate control
panel, or the solar sensor (11) located at
the top of the central part of the dash-
board. These sensors are used by the
automatic system to regulate temperature.
0 D Q X D O R S H U D W L R Q
You can manually control the climate con-
trol system. Set the selectors to the
desired positions.
64MS091
NOTE:
If you need maximum defrosting:
• push the defrost switch (5) to turn on the
defroster (the air conditioning system will
come on and the fresh air position (b)
will be selected automatically),
• set the blower speed selector to HIGH,
• adjust the temperature selector to the
“HI” indication on the display, and
• adjust the side outlets so the air blows
on the side windows.
0 D L Q W H Q D Q F HIf you do not use the air conditioner for a
long period, such as during winter, it may
not give the best performance when you
start using it again. To help maintain opti-
mum performance and durability of your air
conditioner, it needs to be run periodically.
Operate the air conditioner at least once a
month for one minute with the engine
idling. This circulates the refrigerant and oil
and helps protect the internal components.
If your air conditioner is equipped with air
filters, clean or replace them as specified
in the “Maintenance Schedule” in the