engine overheat SUZUKI NEXA 2015 1.G Owners Manual
[x] Cancel search | Manufacturer: SUZUKI, Model Year: 2015, Model line: NEXA, Model: SUZUKI NEXA 2015 1.GPages: 288, PDF Size: 8.02 MB
Page 66 of 288
Downloaded from www.Manualslib.com manuals search engine % ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
7 H P S H U D W X U H * D X J H
64MS046
When the ignition switch is in the “ON”
position or the ignition mode is “ON”, this
gauge indicates the engine coolant tem-
perature. Under normal driving conditions,
the indicator should stay within the normal,
acceptable temperature range between
“H” and “C”. If the indicator approaches
“H”, overheating is indicated. Follow the
instructions for engine overheating in the
³ ( 0 ( 5 * ( 1 & < 6 ( 5 9 , & ( ´ section.
% U L J K W Q H V V & R Q W U R O
61MM0A156
When the ignition switch is turned to the
“ON” position or the engine switch is
pressed to change the ignition mode to
“ON”, the instrument cluster lights come
on.
Your vehicle has a system to automatically
dim the brightness of the instrument panel
lights when the position lights or headlights
are on.
You can change the brightness of the
instrument panel lights regardless of
whether the position lights or headlights
are off or on.
To increase the brightness of the instru-
ment panel lights, turn the indicator selec-
tor knob (1) clockwise.
To reduce the brightness of the instrument
panel lights, turn the indicator selector
knob (1) counterclockwise.NOTE:
•If you do no
t turn the knob for more than
5 seconds while activating the bright-
ness control, the brightness control dis-
play will be canceled automatically.
• When you reconnect the battery, the
brightness of the instrument panel lights
will be reinitialized. Readjust the bright-
ness according to your preference.
NOTE:
If you select the high brightness level when
the position lights or headlights are on, the
instrument panel lights are not dimmed.
NOTICE
& R Q W L Q X L Q J W R G U L Y H W K H Y H K L F O H Z K H Q
H Q J L Q H R Y H U K H D W L Q J L V L Q G L F D W H G F D Q
U H V X O W L Q V H Y H U H H Q J L Q H G D P D J H ( ; $ 0 3 / (
( ; $ 0 3 / (
: $ 5 1 , 1 *
, I \ R X D W W H P S W W R D G M X V W W K H E U L J K W
Q H V V R I W K H L Q V W U X P H Q W S D Q H O O L J K W V
Z K L O H G U L Y L Q J \ R X F R X O G O R V H F R Q W U R O
R I W K H Y H K L F O H
' R Q R W D W W H P S W W R D G M X V W W K H E U L J K W
Q H V V R I W K H L Q V W U X P H Q W S D Q H O O L J K W V
Z K L O H G U L Y L Q J
(1)
Page 130 of 288
Downloaded from www.Manualslib.com manuals search engine ' 5 , 9 , 1 * 7 , 3 6
0 6 (
52D078
5 X Q Q L Q J L Q & D W D O \ W L F & R Q Y H U W H U
80G106
The purpose of the catalytic converter is to
minimize the amount of harmful pollutants
in your vehicle’s exhaust. Use of leaded
fuel in vehicles equipped with catalytic
converters is prohibited, because lead
deactivates the pollutant-reducing compo-
nents of the catalyst system.
The converter is designed to last the life of
the vehicle under normal usage and when
unleaded fuel is used. No special mainte-
nance is required on the converter. How-
ever, it is very important to keep the engine
properly tuned. Engine misfiring, which can
result from an improperly tuned engine,
may cause overheating of the catalyst.
This may result in permanent heat damage
to the catalyst and other vehicle compo-
nents.
: $ 5 1 , 1 *
Page 270 of 288
Downloaded from www.Manualslib.com manuals search engine ( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
, I W K H 6 W D U W H U ' R H V 1 R W 2 S H U D W H1) Try turning the ignition switch to the
“START” position or try pressing the
engine switch to change the ignition
mode to START with the headlights
turned on to determine the battery condi-
tion. If the headlights go excessively dim
or go off, it usually means that either the
battery is flat or the battery terminal con-
tact is poor. Recharge the battery or cor-
rect battery terminal contact as
necessary.
, I W K H ( Q J L Q H L V ) O R R G H GIf the engine is flooded with the fuel, it may
be hard to start. If this happens, press the
accelerator pedal all the way to the floor
and hold it there while cranking the engine.
• For petrol engine model, do not operate
the starter motor for more than 12 sec-
onds.
• For diesel engine model, do not operate
the starter motor for more than 30 sec-
onds.
, I W K H ( Q J L Q H 2 Y H U K H D W VThe engine could overheat temporarily
under severe driving conditions. If the high
engine coolant temperature warning light
comes on as overheating during driving:
1) Turn off the air conditioner, if equipped.
2) Take the vehicle to a safe place and
park.
3) Let the engine run at the normal idle
speed for a few minutes until the high
engine coolant temperature warning
light goes off.
: $ 5 1 , 1 *
, I \ R X V H H R U K H D U H V F D S L Q J V W H D P
V W R S W K H Y H K L F O H L Q D V D I H S O D F H D Q G
L P P H G L D W H O \ W X U Q R I I W K H H Q J L Q H W R O H W
L W F R R O ' R Q R W R S H Q W K H K R R G Z K H Q
V W H D P L V S U H V H Q W : K H Q W K H V W H D P
F D Q Q R O R Q J H U E H V H H Q R U K H D U G R S H Q
W K H K R R G W R V H H L I W K H F R R O D Q W L V V W L O O
E R L O L Q J , I L W L V \ R X P X V W Z D L W X Q W L O L W
V W R S V E R L O L Q J E H I R U H \ R X S U R F H H G
Page 271 of 288
Downloaded from www.Manualslib.com manuals search engine
( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
If the high engine coolant temperature
warning light does not go off:
1) Turn off the engine and check that the
water pump belt and pulleys are not
damaged or slipping. If any abnormality
is found, correct it.
2) Check the coolant level in the reservoir.
If it is found to be lower than the “LOW”
line, look for leaks at the radiator, water
pump, and radiator and heater hoses. If
you locate any leaks that may have
caused the overheating, do not run the
engine until these problems have been
corrected.
3) If you do not find a leak, carefully add
coolant to the reservoir and then the
radiator, if necessary. (Refer to “Engine
Coolant” in the “INSPECTION AND
MAINTENANCE” section.)
NOTE:
If your engine overheats and you are
unsure what to do, contact your D X W K R U L V H G
0 D U X W L 6 X ] X N L Z R U N V K R S.
65D350d
: D U Q L Q J 7 U L D Q J O H
MHO-07-001
In case of vehicle break-down or during
emergency stopping, where, your vehicle
could become a potential traffic hazard,
keep the warning triangle, provided with
your vehicle, on the road free from any
obstacles behind your vehicle so as to
warn the approaching traffic, at an approxi-
mate distance of 50-100 m. The reflecting
side of the triangle should face the on com-
ing traffic. Please activate the hazard
warning lamps before alighting the vehicle
to keep the warning triangle.
: $ 5 1 , 1 *