child restraint TOYOTA 4RUNNER 1998 Owner's Manual

4RUNNER (1998)
CAUTION
A forward- facing child restraint
system should be allowed to put
on the front seat only when it is
unavoidable. Always move the
seat as far back as possible, be-
cause the force of a deploying
airbag could cause death or seri-
ous injury to the child.
1. Sit the child on a booster seat.
Run the lap and shoulder belt
through or around the booster seat
and child following the instructions
provided by its manufacturer and
insert the tab into the buckle taking
care not to twist the belt. Make sure the shoulder belt is cor-
rectly across the child's shoulder and
that the lap belt is positioned as low
as possible on child's hips. See ºSeat
beltsº for details.
CAUTION

4RUNNER (1998)
2. To remove the child restraint sys-
tem, press the buckle- release but-
ton and allow the belt to retract.
If your child restraint system re-
quires the use of a top strap, latch
the hook onto the anchor bracket
and tighten the top strap. See the following instructions to install
the anchor bracket.ÐTop strap anchors and
locations

4RUNNER (1998)
Anchor
bracket
Bolt
Spacer730 mm
(28.7 in.)
380 mm
(15.0 in.)
380 mm
(15.0 in.)
On the filler p anel behind the rear
seat
a. Using the illustration as a guide,
run your fingers across the trim of the
filler p anel itself to locate the position
of the holes underneath.
b. Make a hole in the covering direct-
ly above the hole in the filler p anel.
c. Insert a 15 mm (0.6 in.) spacer
and tighten down the anchor bracket
for your child restraint system with a
bolt. Torque the bolt to 16.5Ð24.7 N Vm (1.68Ð2.52 kgf Vm, 12.2Ð18.2
ft Vlbf). To comply with Canada Motor Vehicle
Safety Standards, vehicles sold in
Canada are provided with a bracket
set in the glovebox, designed for use
with any of the 3 anchor locations
shown in the illustration.
If your child restraint system does not
provide any of the necessary parts,
ask your Toyota dealer. (See ºÐChild
restraint systemº.)
Tilt steering wheel