instrument panel TOYOTA 4RUNNER 1998 Owner's Manual

4RUNNER (1998)
Side vents
Lower vent
If air flow control is not satisfactory,
check the instrument panel vents. The
instrument panel vents may be opened
or closed as shown.

4RUNNER (1998)
The digital clock indicates the time.
The key must be in the ºACCº or
ºONº position.
To reset the hour: Push the ºHº but-
ton.
To reset the minutes: Push the ºMº
button.
If quick adjustment to a full hour is
desired, push the º:00º button.
For example, if the º:00º button is
depressed when the time is between
1:01'1:29, the time will change to
1:00. If the time is between
1:30 '1:59, the time will change to
2:00. Once the electrical power source has
been disconnected from the clock, the
time is automatically set to 1:00 (one
o'clock).
When the instrument panel lights are
turned on, the brightness of the time
indication will be reduced.
Cigarette lighter and ashtray

4RUNNER (1998)
To use the glovebox, do this.
To open: Pull the lever.
To lock: Insert the master key and
turn it clockwise.
On some models, the glovebox light
will come on when the golvebox is
open with the instrument panel lights on.
CAUTION
To reduce the chance of injury in
case of an accident or a sudden
stop, always keep the glovebox
door closed while driving.
Auxiliary holder

4RUNNER (1998)
Keep the back door and back
window closed while driving. An
open or unsealed back door and
back window, may cause ex-
haust gases to be drawn into
the vehicle. If you must drive
with the trunk lid open to ac-
commodate a large object, close
the windows, open all the
instrument panel vents and
have the heating or cooling sys-
tem deliver fresh air into the
vehicle by turning the fan to
high speed with the air intake
control set at the outside air
position.
To allow proper operation of
your vehicle's ventilation sys-
tem, keep the inlet grilles in
front of the windshield clear of
snow, leaves, or other obstruc-
tions.
If you smell exhaust fumes in
the vehicle, drive with the win-
dows open and the back door
and back window closed. Have
the cause immediately located
and corrected.FUNCTIONS OF ENGINE OIL
Engine oil has the primary functions
of lubricating and cooling the inside of
the engine, and plays a major role in
maintaining the engine in proper work-
ing order.
ENGINE OIL CONSUMPTION
It is normal that an engine should
consume some engine oil during
normal engine operation. The
causes of oil consumption in a nor-
mal engine are as follows.
Oil is used to lubricate pistons,
piston rings and cylinders. A thin
film of oil is left on the cylinder
wall when a piston moves down-
wards in the cylinder. High nega-
tive pressure generated when the
vehicle is decelerating sucks some
of this oil into the combustion
chamber. This oil as well as some
part of the oil film left on the cylin-
der wall is burned by the high tem-
perature combustion gases during
the combustion process.
Oil is also used to lubricate the
stems of the intake valves. Some
of this oil is sucked into the com-
bustion chamber together with the
intake air and is burned along with
the fuel. High temperature exhaust
gases also burn the oil used to
lubricate the exhaust valve stems.
The amount of engine oil consumed
depends on the viscosity of the oil,
the quality of the oil and the condi-
tions the vehicle is driven under.
More oil is consumed by high- speed
driving and frequent acceleration and
deceleration.
A new engine consumes more oil,
since its pistons, piston rings and cyl-
inder walls have not become condi-
tioned.
When judging the amount of oil
consumption, note that the oil may
become diluted and make it difficult
to judge the true level accurately.
As an example, if a vehicle is used
for repeated short trips, and consumes
a normal amount of oil, the dipstick
may not show any drop in the oil
level at all, even after 1000 km (600
miles) or more. This is because the
oil is gradually becoming diluted with
fuel or moisture, making it appear that
the oil level has not changed.
Facts about engine oil
consumption

4RUNNER (1998)
Do not place anything on the
filler panel or l uggage cover.
Such items may be thrown
about and possibly injure
people in the vehicle during
sudden braking or an accident.
(secure all items in a safe
place.)
Do not drive with objects left
on top of the instrument panel.
They may interfere with the
driver's field of view. Or they
may move during sharp vehicle
acceleration or turning, and im-
pair the driver's control of the
vehicle. In an accident they may
injure the vehicle occupants.
NOTICE
Do not load the vehicle beyond
the vehicle capacity weight speci-fied in Part 8.
Your Toyota's identificationÐ
ÐVehicle identification numb

4RUNNER (1998)
The vehicle identification number
(VIN) is the legal identifier for your
vehicle. This number is on the left
top of the instrument panel, and
can be seen through the windshield
from outside.
This is the primary identification num-
ber for your Toyota. It is used in reg-
istering the ownership of your vehicle.

4RUNNER (1998)
Cleaning the interior
CAUTION
Do not wash the vehicle floor
with water, or allow water to get
onto the floor when cleaning the
vehicle interior or exterior. Water
may get into audio components
or other electrical components
above or under the floor carpet
(or mat) and cause a malfunction;
and it may cause body corrosion.
Vinyl interior
The vinyl upholstery may be easily
cleaned with a mild soap or deter-
gent and water.
First vacuum over the upholstery to
remove loose dirt. Then, using a
sponge or soft cloth, apply the soap
solution to the vinyl. After allowing it
to soak in for a few minutes to loosen
the dirt, remove the dirt and wipe off
the soap with a clean damp cloth. If
all the dirt does not come off, repeat
the procedure. Commercial foaming-
type vinyl cleaners are also available
which work well. Follow the manufac-
turer's instructions.
NOTICE
Do not use solvent, thinner, gaso- line or window cleaner on the in-terior.
Carpets
Use a good foam- type shampoo to
clean the carpets.
Begin by vacuuming thoroughly to re-
move as much dirt as possible. Sever-
al types of foam cleaners are avail-
able; some are in aerosol cans and
others are powders or liquids which
you mix with water to produce a foam.
To shampoo the carpets, use a
sponge or brush to apply the foam.
Rub in overlapping circles.
Do not apply waterÐthe best results
are obtained by keeping the carpet as
dry as possible. Read the shampoo
instructions and follow them closely.
Seat belts
The seat belts may be cleaned with
mild soap and water or with luke-
warm water.
Use a cloth or sponge. As you are
cleaning, check the belts for exces-
sive wear, fraying, or cuts.
NOTICE
Do not use dye or bleach on the
beltsÐit may weaken them.
Windows
The windows may be cleaned with
any household window cleaner.
NOTICE
When cleaning the inside of thewindows, be careful not toscratch or damage the heaterwires on the rear window.
Air conditioning control panel, car
audio, instrument panel, console
panel, and switches
Use a soft damp cloth for cleaning.
Soak a clean soft cloth in water or
lukewarm water then lightly wipe off
any dirt.

4RUNNER (1998)
Parts and tools
Here is a list of parts and tools you
will need on performing do- it- yourself
maintenance. Remember all Toyota
parts are designed in metric sizes, so
your tools must be metric.
Checking the engine oil level
Parts (if level is low): Engine oil API grade SH, ºEnergy-
Conserving IIº or SJ, ºEnergy-
Conservingº multigrade or ILSAC
multigrade having viscosity proper
for your climate
Tools: Rag or paper towel
Funnel (only for adding oil)
Checking the engine coolant level
Parts (if level is low): Ethylene- glycol antifreeze
Demineralized or distilled water
Tools: Funnel (only for adding coolant)
Checking brake fluid
Parts (if level is low): SAE J1703 or FMVSS No. 116
DOT 3 brake fluid
Tools: Rag or paper towel
Funnel (only for adding fluid) Checking power steering fluid
Parts (if level is low):
Automatic transmission fluid DEXRON II or III
Tools: Rag or paper towel
Funnel (only for adding fluid)
Checking battery condition
Tools: Warm water
Baking soda
Grease
Conventional wrench (for terminal
clamp bolts)
Checking and replacing fuses
Parts (if replacement is necessary): Fuse with same amperage rating
as original
Tools: Conventional wrench (for instrument
lower panel nut)
Adding washer fluid
Parts: Water
Washer fluid containing antifreeze
(for winter use)
Tools: Funnel Replacing light bulbs
Parts:
Bulb with same number and watt-
age rating as original (See charts
in ºReplacing light bulbsº in Chap-
ter 7- 3.)
Tools: Screwdriver

4RUNNER (1998)
J80003
Instrument panel
14. HEAD(LH) 10 A: Left- hand head-
light
15. DRL 7.5 A: Daytime running light
system
16. HEAD (LO RH) 10 A: Right- hand
headlight(low beam)
17. HEAD (LO LH) 10 A: Left- hand
headlight(low beam)
18. HEAD (HI RH) 10 A: Right- hand
headlight(high beam)
19. HEAD (HI LH) 10 A: Left- hand
headlight(high beam)
20. ACC 15 A: Car audio system, pow-
er antenna, clock, power rear view
mirror control 21. ECU- B 7.5 A:
SRS airbag warning
light
22. 4WD 20 A: A.D.D. control system,
four- wheel drive control system,
rear differential lock system
23. TURN 10 A: Turn signals lights,
emergency flashers
24. GAUGE 10 A: Gauges and meters,
back window defogger, daytime
running light system, air condition-
ing system, electric moon roof
25. ECU- IG 10 A: cruise control sys-
tem, anti- lock brake system, elec-
tronically controlled automatic
transmission system, power anten-na
26. WIPER 20 A: windshield wipers
and washer, back window wiper 27. IGN 7.5 A:
SRS airbag system,
multiport fuel injection system / se-
quential multiport fuel injection sys-
tem, discharge warning light