RS0IW–01
H11615
(5)(7)
(4)
(6)
(1)(2)(3)
H11613
(1)(2)(3)(4)
(5)
RS–32
– SUPPLEMENTAL RESTRAINT SYSTEMCURTAIN SHIELD AIRBAG ASSEMBLY
INSTALLATION
NOTICE:
Never use airbag parts from another vehicle. When
replacing parts, replace them with new parts.
Make sure that the curtain shield airbag assembly is
installed with the specified torque.
If the curtain shield airbag assembly has been
dropped, or there are cracks, dents or other defects
in the case or connector, replace the curtain shield
airbag assembly with a new one.
When installing the curtain shield airbag assembly,
take care it is not pinched between other parts.
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Connect the connector of the curtain shield airbag sub
wire harness then lock it.
(b) In order shown in the illustration, install the curtain shield
airbag with the bolts and grommets.
Torque:
Nuts: 9.8 N·m (100 kgf·cm, 87 in.·lbf)
Bolts: 5 N·m (51 kgf·cm, 44 in.·lbf)
CAUTION:
Pay attention for not causing twisting.
(c) Install the instrument panel assembly. (See page
BO–19)
2. INSTALL CURTAIN SHIELD AIRBAG
(IN CASE WITHOUT INSTALLING INFLATER)
In order shown in the illustration, install the deployment section
of the curtain shield airbag with the bolts and grommet.
Torque: 5 N·m (51 kgf·cm, 44 in.·lbf)
CAUTION:
Pay attention for not causing twisting.
3. INSTALL ROOF HEADLINING
Sedan model (See page BO–25)
Liftback model (See page BO–30)
Wagon model (See page BO–36)
BO199–02
H03711
H03642
H03643
– BODYSLIDING ROOF
BO–11
SLIDING ROOF
REMOVAL
1. REMOVE ROOF HEADLINING
(See page BO–23 , BO–28 or BO–33)
2. REMOVE SLIDING ROOF GLASS
(a) Using a torx wrench, remove the 4 screws.
(b) Pull the glass upward to remove it.
3. REMOVE DRIVE GEAR
(a) Disconnect the connector.
(b) Remove the 2 screws and drive motor.
4. REMOVE SLIDING ROOF HOUSING
(a) Disconnect the 4 drain hoses from the housing.
(b) Remove the 8 bolts and 4 brackets.
(c) Remove the 2 bolts, 5 nuts and housing.
BO2J2–01
H03643
H03642
H03711
BO–12
– BODYSLIDING ROOF
INSTALLATION
1. INSTALL SLIDING ROOF HOUSING
(a) Install the housing with the 2bolts and 5nuts.
(b) Install the 4 brackets with the 8 bolts.
(c) Connect the 4 drain hoses to the housing.
2. INSTALL DRIVE GEAR
(a) Install the drive motor with 2 screws.
(b) Connect the connector.
3. INSTALL SLIDING ROOF GLASS
(a) Push the glass upward to remove it.
(b) Install the 4 screws.
4. INSTALL ROOF HEADLINING
(See page BO–23, BO–28 or BO–33)
