TOYOTA C-HR 2020 (in English) User Guide
C-HR 2020
TOYOTA
TOYOTA
https://www.carmanualsonline.info/img/14/42415/w960_42415-0.png
TOYOTA C-HR 2020 (in English) User Guide
Page 394 of 536
3946-3. Do-it-yourself maintenance
C-HR_OM_USA_OM10634U■
Rear
Rear side marker lights
Rear turn signal lights
Back-up lights
License plate lights
Page 395 of 536
3956-3. Do-it-yourself maintenance
6
Maintenance and care
C-HR_OM_USA_OM10634U■
Front side marker l
ights (bulb type)
Turn the bulb base counter-
clockwise.
Remove the light bulb.
When installing, reverse the steps listed.
■Front turn signal lights (bulb type) Turn the bulb base counter-
clockwise.
Remove the light bulb.
When installing, reverse the steps listed.
Replacing light bulbs
1
2
3
1
2
3
Page 396 of 536
3966-3. Do-it-yourself maintenance
C-HR_OM_USA_OM10634U■
Rear turn signal lights and
rear side marker lights
Open the back door and
remove the cover.
To prevent damaging the vehi-
cle, wrap the flathead screw-
driver with a tape.
Remove the 2 screws and
pull the light unit toward the
rear of the vehicle to remove
it.
Turn the bulb base counter-
clockwise. Rear turn signal lights
Rear side marker lights
Remove the light bulb. Rear turn signal lights
Rear side marker lights
When installing the light bulb, install by conducting and
with the directions reversed.
1
2
3
4
534
Page 400 of 536
4006-3. Do-it-yourself maintenance
C-HR_OM_USA_OM10634U■
Side turn signal lights
Insert a flathead screwdriver
and release the claw for the
outside rear view mirror
cover.
To prevent damaging the vehi-
cle, wrap the flathead screw-
driver with a tape.
Release the cover claws
spanning over the entire
perimeter.
Release the claw of the bot-
tom part of the cover and
then remove the cover.
1
Claw
O
P
Page 401 of 536
4016-3. Do-it-yourself maintenance
6
Maintenance and care
C-HR_OM_USA_OM10634U
Insert a flathead screwdriver
and remove the lens to the
outside.
Remove the socket from the
side turn signal light housing.
Remove the bulb.
Replace the bulb and install
the socket to the side turn
signal light housing.
Align the grooves of the socket
to the side turn signal light hous-
ing.
4
5
6
7
Page 403 of 536
4036-3. Do-it-yourself maintenance
6
Maintenance and care
C-HR_OM_USA_OM10634U
Attach the cover claws span-
ning over the entire perime-
ter.
Finally, confirm that the outside
claw is securely fitted.
■
Replacing the following bulbs
If any of the lights listed below has burnt out, have it replac ed by
your Toyota dealer.
● Headlights
● Parking lights/daytime running lights
● Front turn signal lights (vehicles with LED type)
● Front side marker lights (vehicles with LED type)
● Front fog lights
● Stop/tail lights
● High mounted stoplight
● Outer mirror illumination (if equipped)
11
Page 404 of 536
4046-3. Do-it-yourself maintenance
C-HR_OM_USA_OM10634U
■LED light bulbs
The following lights consist of a number of LEDs. If any of the LEDs burns
out, take your vehicle to your Toyota dealer to have the light replaced.
● Headlights
● Parking lights/daytime running lights
● Front turn signal lights (vehicles with LED type)
● Front side marker lights (vehicles with LED type)
● Front fog lights
● Stop/tail lights
● High mounted stoplight
● Outer mirror illumination (if equipped)
■ Condensation build-up on the inside of the lens
Temporary condensation build-up on the inside of the headlight lens does not
indicate a malfunction.
Contact your Toyota dealer for more information in the followin g situations:
● Large drops of water have built up on the inside of the lens.
● Water has built up inside the headlight.
■ When replacing light bulbs
P. 390
Page 408 of 536
4087-1. Essential information
C-HR_OM_USA_OM10634U
Emergency flashers
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch
once again.
■Emergency flashers
If the emergency flashers are used for a long time while the en gine is not
operating, the battery may discharge.
The emergency flashers are used to warn other drivers when the
vehicle has to be stopped in the road due to a breakdown, etc.
Page 471 of 536
4718-1. Specifications
8
Vehicle specifications
C-HR_OM_USA_OM10634U
Light bulbs
Light bulbsBulb No.WTy p e
ExteriorFront side marker lights
(bulb type)
―5 A
Front turn signal lights
(bulb type) ―21 B
Side turn signal lights ― 5 B
Rear side marker lights ― 5 A
Rear turn signal lights ― 21 B
Back-up lights 921 16 A
License plate lights ― 5 A
InteriorVanity lights
*―8 A
Front interior lights/
front personal lights ―5 A
Rear interior light ― 8C
Luggage compartment
light ―5 A
A: Wedge base bulbs (clear)
C: Double end bulbs
*: If equipped B: Wedge base bulbs (amber)
Page 494 of 536
4948-2. Customization
C-HR_OM_USA_OM10634U■
Power windows (
P. 155)
*1: Vehicles without a smart key system
*2: Vehicles with a smart key system
■
Turn signal lever ( P. 193)
FunctionDefault settingCustomized
setting
Key*1 or mechanical
key
*2 linked operation
(open)OffOn——O
Key*1 or mechanical
key
*2 linked operation
(close)OffOn——O
Wireless remote con-
trol linked operation
(open only)
OffOn——O
Key*1 or mechanical
key
*2, wireless
remote control linked
operation signal
(buzzer)
OnOff——O
FunctionDefault settingCustomized setting
Times of flashing of
the lane change sig-
nal flashers
3
Off
——O5
7