run flat TOYOTA CAMRY HYBRID 2012 XV50 / 9.G Quick Reference Guide

24
SAFETY AND EMERGENCYFEATURES
System reset initialization
1. Push and hold “SET” button
until the indicator blinks three times.
2. Wait a few minutes to allow initialization to complete.
Se
Sp
Trunk-Internal release
Pull up
Tire Pressure Monitoring (warning)
System
After adjusting tire pressures, or after tires have been rotated or replaced,\
turn
the POWER switch to “ON” mode, and press and hold the “ SET” button until
indicator blinks three times. Let the vehicle sit for a few minutes to allow
initialization to complete.
Refer to the load label on the door jamb or the Owner’s Manualfor tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then r\
emains
on, take the vehicle to your local Toyota dealer.
NOTE : The warning light may come on due to temperature changes or changes in
tire pressure from natural air leakage. If the system has not been initializ\
ed
recently, setting the tire pressures to factory specifications should turn off th\
e
light.
To o
Rem
(1)
Refe
resize-camry.qxd 10/12/11 4:58 AM Page 24