steering TOYOTA CAMRY V20 1986 Service Information

Drive Pinion Front
Bearing Cup Replacer
(Handle)
(Drive Pinion Front
Bearing Cup Repiacer
Drive Pinion Rearing
Bearing Cup Replacer
Axle Hub &
Drive Pinion Bearing
Tool Set
(Handle)
Front Hub Outer
Bearing Cup Replacer
Rear Hub Inner
Bearing Cup Replacer
SST (SPECIAL SERVICE TOOLS) (Cont'd)
Remarks:
* 1 4WD only
* 2 Rear axle hub inner oil seal (4W0 only)
* 3 Rear axle hub (4WD only)
* 4 E56F5 only
* 5 Dust deflector Front Hub Bearing
Replacer Set
(Replacer)
(Handle)
Steering Knuckle oil
Seal Replacer
Steering Knuckle Oil
Seal Replacer
IllustrationPart Name
Part No. Section
EM
MTCO
CHFl
FA PR ST
SR
± SST AND SSMSST (Special Service Tools)C±13

Steering Gear
Housing Overhaul
Tool Set
(Hexagon Wrench)
Steering Pinion
Bearing Replacer
(Steering Rack Wrench)
Remarks:
* 1 Dust deflector
* 2 E56F5 only
* 3 Tie rod end (FWDlSV21 and 4WD)
* 4 No. 3 hub sleeve assembly (S51
only)
* 5 Cylinder end stopper
SST (SPECIAL SERVICE TOOLS) (Contºd)
Steering Gear Housing
Overhaul Tool Set
Ball Joint Lock Nut
WrenchDrive Pinion Rear
Bearing Cup Replacer
Rear Axle Bearing
Replacer
Rack & Pinion
Steering Rack
Housing Stand
Tilt Handle Bearing
ReplacerSteering Wheel
Puiler
Pitman Arm Puller.
Illustration Part Name
Part No. Section
SR
± SST AND SSMSST (Special Service Tools)C±14

Remarks:
* 1 Rack guide spring cap lock * 5 Power steering drive
nut and bearing guide lock nut pulley (SV series)
* 2 Input shaft front bearing * 6 Rack housing oil seal
(E52 and E56F5) and * 7 E56FS only
differential side bearing * 8 3S±FE only
outer race * 9 Control shaft cover oil
* 3 Power steering drive pulley seal (E52 and E56F5)
(VZV series) *10 Tie rod end
* 4 Oil pump pulley for 2VZ±FE (FWD/VZV21)Steering Gear Box
Repiacer Set
Steering Sector Shaft
Oil Seal Replacer
Steering Main
Shaft Bearing
Replacer
(Steering Sector Shaft
Bushing Replacer
(Handle)
SST (SPECIAL SERVICE TOOLS) (Contºd)
Steering Pinion Bearing
Adjusting Screw
Lock Nut Wrench
Steering Worm
Bearing Adjusting
Screw WrenchSteering Worm
Bearing Adjusting
Socket
Steering Worm
Bearing Adjusting
Screw Wrench
Steering Worm
Bearing Adjusting
Screw WrenchSteering Worm
Bearing Puller
Illustration Part Name
Ball Joint PuIler
Part No.SectionBOSR RAEM
± SST AND SSMSST (Special Service Tools)C±15

Steering Rack Oil
Seal Tool Set
Valve Cup Oil Seal
Remover
Valve Cup Oil Seal
Reptacer
Valve Cup Bearing
Replacer
SST (SPECIAL SERVICE TOOLS) (Cont'd)
Power Steering
Hose Nut 14 x 17 mm
Wrench SetSteering Rack Oil
Seal Test Tool
Oil Seal Replacer
Remark:
* 1 Fuel line Steering Rack
Cover ºCº Oil Seal ºBº Remover
Illustration
Seal Ring Guide
Seal Ring Tool
Part Name
Part No. Section
Handle
SR
BO EM
± SST AND SSMSST (Special Service ToolsC±16

SST (SPECIAL SERVICE TOOLS) (Cont'd)
Remarks:
* 1 Rear axle shaft
* 2 Dust deflector
* 3 Differential (4WD only)
* 4 Differential case LH side bearing Front Suspension
Bushing Tool Set
Upper Arm Bushing
Replacer
Front Suspension
Bushing Tool Set
(Bushing Replacer) Rear Suspension
Bushing Tool Set
(Handle)Upper Ball Joint
Dust Cover ReplacerPower Steering Hose
Nut Wrench
Brake Shoe Return
Spring Tool
Brake Shoe Return
Spring RemoverHub Bolt Remover
LSPV Gauge Set
IllustrationPart Name
Part No. Section
± SST AND SSMSST (Special Service TootsC±17

STEERING
± STEERINGSR±1

Inflate tires to proper pressure
lubricate suspension and steering
linkage
Check front wheel alignment
Replace steering system joints
Replace lower arm ball joints
Inspect steering column
Adjust or repair steering gear
Adjust belt
Check reservoir
Check power steering unit
PRECAUTIONS
Care must be taken to replace parts properly because they
could affect the performance of the steering system and
result in a driving hazard.
TROUBLESHOOTING
Hub bearing worn
Main shaft yoke or intermediate shaft yoke
worn
Lower arm ball joints wo¿n
Steering system joints worn
Steering gear out of adjustment or brokenExcessive caster
Steering system joint worn
Lower arm ball joints worn
Steering column binding
Steering gear out of adjustment or broken
Replace hub bearing
Replace main shaft or intermediate
shaft
Replace lower arm ball joints
Replace steering system joints
Adjust or repair steering gearInflate tires to proper pressure
Lubricate suspension and steering
linkage
Check front wheel alignment
Inspect steering column
Adjust or repair steering gear Wheel alignment incorrect
Steering column binding
Steering gear out of adjustment or brokenFA±3
SR±43,45,
48
FA±57
SR±4
SR±43,45,
48
SR±22
SR±22
SR±22 Power steering beh loose
Fluid level i n reversoi r low
Power steering unit faulty
Tighten steering linkage
Replace steering system joints Steering linkage loose
Steering system joints wornFA±57
SR±43,45,
48
SR±43,45
48 Tires improperly inflated
Insufficient lubricantTires improperly inflated
Insufficient lubricant
Steering gear out of adjustment or broken
FA ± 3
SR±4
SR±43,45,
48
SR±43,45,
48
SR±43,45
48 Adjust or repair steering gear Abnormal noiseExcessive play
Possible cause
Hard steering
Poor return
Remedy Problem
Page
FA ± 7FA ± 3
FA ± 3
± STEERINGPrecautionsSR±2

Inflate tires to proper pressure
lubricate suspension and steering
linkage
Check front wheel alignment
Replace steering system joints
Replace lower arm ball joints
Inspect steering column
Adjust or repair steering gear
Adjust belt
Check reservoir
Check power steering unit
PRECAUTIONS
Care must be taken to replace parts properly because they
could affect the performance of the steering system and
result in a driving hazard.
TROUBLESHOOTING
Hub bearing worn
Main shaft yoke or intermediate shaft yoke
worn
Lower arm ball joints wo¿n
Steering system joints worn
Steering gear out of adjustment or brokenExcessive caster
Steering system joint worn
Lower arm ball joints worn
Steering column binding
Steering gear out of adjustment or broken
Replace hub bearing
Replace main shaft or intermediate
shaft
Replace lower arm ball joints
Replace steering system joints
Adjust or repair steering gearInflate tires to proper pressure
Lubricate suspension and steering
linkage
Check front wheel alignment
Inspect steering column
Adjust or repair steering gear Wheel alignment incorrect
Steering column binding
Steering gear out of adjustment or brokenFA±3
SR±43,45,
48
FA±57
SR±4
SR±43,45,
48
SR±22
SR±22
SR±22 Power steering beh loose
Fluid level i n reversoi r low
Power steering unit faulty
Tighten steering linkage
Replace steering system joints Steering linkage loose
Steering system joints wornFA±57
SR±43,45,
48
SR±43,45
48 Tires improperly inflated
Insufficient lubricantTires improperly inflated
Insufficient lubricant
Steering gear out of adjustment or broken
FA ± 3
SR±4
SR±43,45,
48
SR±43,45,
48
SR±43,45
48 Adjust or repair steering gear Abnormal noiseExcessive play
Possible cause
Hard steering
Poor return
Remedy Problem
Page
FA ± 7FA ± 3
FA ± 3
± STEERINGTroubleshootingSR±2

ON±VEHICLE INSPECTION
1. CHECK THAT STEERING WHEEL FREEPLAY IS
CORRECT
With the vehicle stopped and tires pointed straight ahead,
rock the steering wheel gently back and forth with light fin-
ger pressure.
Freeplay should not exceed the maximum limit.
Maximum freeplay: 30 mm (1.18 in.)
If incorrect, repair.
2. CHECK STEERING LINKAGE AND GEAR HOUSING
(a) Check the steering linkage for looseness or dam-
age.
Check that:
wTie rod ends do not have excessive play.
wBoots are not damaged.
wBoot clamps are not loose.
(b) Check gear housing for grease leakage or oozing.
± STEERINGOn±Vehicle InspectionSR±3

(MAIN POINTS OF REMOVAL AND
INSTALLATION)
1. REMOVE UNIVERSAL JOINT
(a) Remove the two set bolts.
(b) Place matchmarks on the universal joint and control
valve shaft.
(e) First pull the universal joint from the gear housing,
and then pull it out from the main shaft.
STEERING COLUMN
REMOVAL AND INSTALLATION OF
STEERING COLUMN
Remove and install the parts as shown.
2. REMOVE STEERING WHEEL
Using SST, remove the steering wheel.
SST 09609±20011
3. CHECK STEERING WHEEL CENTER POINT AFTER
INSTALLING STEERING COLUMN
± STEERINGSteering ColumnSR±4