remote control TOYOTA CAMRY V20 1986 Service Information

Remote Control Mirror
INSPECTION OF MIRROR
INSPECT MIRROR OPERATION
(a) Connect the positive (+) lead from the battery to ter-
minal 1 and negative lead to terminal 2, check that
the mirror moves upward.
Then, reverse the polarity, check that the mirror
operation is reversed.
(b) Connect the positive (+) lead from the battery to ter-
minal 2 and negative(±) lead to terminal 3, check that
the mirror moves to the right.
Then, reverse the polarity, check that the mirror
operation is reversed.
If there is no mirror operation, replace the mirror.
REMOTE CONTROL MIRROR
Mirror Switch
INSPECTION OF SWITCH
INSPECT SWITCH CONTINUITY
Inspect the switch continuity between terminals.
If continuity is not as specified, replace the switch.Switch
position
Terminal
Mirror
RIGHTRight
DOWN
LEFT
Left
± BODY ELECTRICAL SYSTEMRemote Control MirrorBE±63

KEY±LESS TYPE SYNCHROMESH
FUNCTION
* HUB SLEEVE
There are three protrusions on the inside of the hub sleeve to
push the key spring.
* CLUTCH HUB
Three apertures are located around the clutch hub to secure the
synchronizer ring and key spring in place.
* KEY SPRING
The key spring has four claws. One claw is to secure the key spring
in place. Three claws also act as shifting keys as well as key
springs.
SYNCHRONIZER RING
A chamfered ledge is provided at three points along the outer pe-
riphery and a bolt is provided in each to secure a key spring. wThe oil used in each transaxle is as follows:
Transaxle oil E50 (08885±80206)
Recommended oil
Oil grade: AN GL±5
Viscosity: SAE 75W±90 or 80W±90
Above ±18
°C (0°F) SAE 90
Above ± 1 8°C (0°F) SAE 84W
wOil capacity: 5.0 Liters (s.3 Us qts, 4.4 Imp. qts)
OIL PUMP
The oil pump is of the trochoid type, and is driven by
the differential ring gear and the pump drive gear. It is
located at the bottom of the transaxle case.
Floor shift vehicles are provided will
push±pull type remote control
Forward: Constant mesh
Reverse: Sliding mesh
Type of differential control mechanismDifferential side (Gear type) Reduction side (Gear type) Transmission typeOperation method
Center differential. Helical gear
Differential lock Transaxle type
Hypoid Gear Transmission
Bevel gear
Gear type
TransferE56 F5
± MANUAL TRANSAXLEDescriptionMT±110