fuel tank removal TOYOTA CELICA 1987 Service Repair Manual

?I-78 EFI SYSTEM - Fuel Systeti
-_
REMOVAL OF FUEL PUMP
._
Fuel Pump Bracket
Filter
. i’
@-Rubber Cushion
+ Non-reusable part
FI166
1. DISCONNECT CABLE FROM NEGATIVE TERMINAL
OF BATTERY
2. DRAIN GASOLINE FROM FUEL TANK
WARNING: Do not smoke or work near an open
flame when working on the fuel pump.
3.
4. REMOVE FUEL TANK
REMOVE FUEL PUMP BRACKET FROM FUEL TANK
(a) Remove the screws.
(b) Pull out the fuel pump bracket.
REMOVE FUEL PUMP FROM FUEL PUMP BRACKET
(a) Remove the two nuts and disconnect the wires from
the fuel pump.
(b) Pull off the lower side of the fuel pump from the
bracket.
(c) Remove the fuel pump from the fuel hose.

ENGINE MECHANICAL - Cylinder Head
EM-&j
REMOVAL OF CYLINDER HEAD
1. (See pages EM-37, 38)
REMOVE AiiERNATOR
(a) Disconnect the No.3 PCV hose.
(b) Remove the drive belt.
(c) Remove the alternator and adjusting bar.
2.
3.
4. (7M-GTE)
REMOVE PS RESERVOIR TANK
Remove the two bolts, nut and, reservoir tank with bracket.
(‘IM-GTE),
REMOVE CAM POSITION SENSOR
REMOVE AIR INTAKE CHAMBER WITH CONNECTOR
(a) Remove the PCV pipe.
(b) Disconnect following connectors:
. (7M-GE)
Cold start injector connector
l Throttle position sensor connector
l ISC valve connector
(c) Disconnect following hoses: aI
l BVSV hose from throttle body
l EGR hoses from throttle.boby
l Vacuum transmitting p.ipe hose from intake cham-
ber
0 Pressure regulator hose
;, I
l VSV (for fuel pressure up) &es
. (7 M-GE)
Diaphragm hose
(d) Disconnect following hoses:
-
0 (7M-GTE)
Auxiliary air pipe hose from vacuum transmitting
pipe hose
l No.1 water by-pass hose from ISC valve
. (7M-GE)
No.3 water by-pass hose from throttle body ,
0 (-/M-GTE)
No.3 water by-pass hose from water by-pass pipe
(e) (w/ EGR)
Remove the EGR pipe mounting bolts.
(f) Remove the manifold stay mounting bolts.