lights TOYOTA CELICA 1998 Owner's Manual

CELICA U
186
Replacing light bulbs—
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
Light bulbsBulbNo.WType
Headlights (low beam)900655A
Headlights (high beam)900565B
Front fog light—55C
Light bulbsBulbNo.WType
Parking and front turn
signal lights115727/8C
Front side marker
lights1943.8D
Rear side marker,
stop and tail lights
(coupe)
115727/8C
Rear side marker
lights (liftback)1943.8D
Rear turn signal lights115627C
Stop and tail lights115727/8C
Back −up lights115627C
License plate lights1685D
High mounted stoplight92118C
Interior light
(with moon roof)—10C
Interior lights
(without moon roof)—8C
Light bulbsBulb
No.WType
Personal lights—5E
Glovebox light—1.2D
Door courtesy lights—3.8D
Luggage compartment
light—5E
Trunk light—3.8D
A: HB4 halogen bulbs
B: HB3 halogen bulbs
C: Single end bulbs
D: Wedge base bulbs
E: Double end bulbs
ProCarManuals.com

CELICA U
187
—Headlights
1. Unplug the connector while depress-ing the lock release.
If the connector is tight, wiggle it.2. Turn the bulb and remove it.3. Install a new bulb and the connector into the mounting hole.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
ProCarManuals.com

CELICA U
188
—Front fog lights
1. Loosen the retainer screw and takeout the beam unit.2. Turn the cover counterclockwise andremove it.3. Disconnect the cords.
ProCarManuals.com

CELICA U
189
4. Release the bulb retaining springand remove the bulb. Install a new
bulb and the bulb retaining spring.
To install the bulb, align the cutouts of the
bulb with the protrusions of the mounting
hole.5. Connect the cords, install the cover and turn it clockwise so that two
triangle marks are aligned. Plug the
connector together. Install the beam
unit and tighten the screw.Use a Phillips −head screwdriver.
—Parking and front turn
signal lights
ProCarManuals.com

CELICA U
190
—Front side marker lights
Use a Phillips−head screwdriver.
ProCarManuals.com

CELICA U
191
a: Rear turn signal light
b: Rear side marker, stop and tail lightc: Stop and tail light
d: Back−up light
—Rear side marker, rear turn
signal, stop and tail, and back −up
lights (coupe and convertible)
ProCarManuals.com

CELICA U
192
a: Rear side marker light
b: Rear turn signal light
c: Stop and tail light
d: Back−up light
—Rear side marker, rear turn
signal, stop and tail, and
back− up lights (liftback)
ProCarManuals.com

CELICA U
193
—License plate lights
Use a Phillips−head screw driver.
—High mounted stoplight
(coupe)
ProCarManuals.com

CELICA U
198
Oil grade:API grade SH, ”Energy −Conserving II”
or SJ, ”Energy −Conserving” multigrade
engine oil or ILSAC multigrade engine
oil is recommended.
Recommended oil viscosity (SAE):COOLING SYSTEM
Total capacity, L (qt., Imp. qt.): With manual transaxle 6.7 (7.1, 5.9)
With automatic transaxle
7.1 (7.5, 6.2)
Coolant type: With ethylene −glycol antifreeze
(Do not use alcohol type.)
BATTERY
Open voltage
∗ at 20 °C (68 °F):
12.6—12.8 V Fully charged
12.2—12.4 V Half charged
11.8—12.0 V Discharged
∗: Voltage that is checked 20 minutes af-
ter the key is removed with all the lights
turned off
Charging rates:
5 A max .
CLUTCH
Pedal freeplay, mm (in.): 5—15 (0.2—0.6)
Fluid type: SAE J1703 or FMVSS No. 116 DOT 3 MANUAL TRANSAXLE
Oil capacity, L (qt., Imp. qt.):
2.2 (2.3, 1.9)
Oil type: Gear oil API GL −4 or GL −5
Recommended oil viscosity: SAE 75W −90
AUTOMATIC TRANSAXLE
Automatic transmission Fluid capacity (drain and refill),
L (qt., Imp. qt.): Up to 2.5 (2.6, 2.2)
Differential Fluid capacity, L (qt., Imp. qt.): 1.6 (1.7, 1.4)
Fluid type: Automatic transmission fluid D −II or
DEXRON
®III (DEXRON®II)
BRAKES
Minimum pedal clearance when depressed
with the pressure of 490 N (50 kgf, 110
lbf) with the engine running, mm (in.): 80 (3.1)
Pedal freeplay, mm (in.): 1—6 (0.04—0.24)
Pad wear limit, mm (in.): 1.0 (0.04)
ProCarManuals.com

CELICA U
200
Engine compartment—Canada
Engine compartment (front)—Canada only
Fuses (type A)1. AM2 30 A: Starting system
2. HAZARD 10 A: Emergency flashers
3. HORN 7.5 A: Horns
4. RADIO NO.1 20 A: Car audio system
5. ECU −B 15 A: Anti−lock brake system,
cruise control system
6. DOME 10 A: Interior lights, personal
lights, luggage compartment light, trunk
light, door courtesy lights, clock
7. HEAD (LH) 15 A: Left−hand headlight
8. HEAD (RH) 15 A: Right−hand headlight
Instrument panel
9. SPARE: Spare fuse
10. SPARE: Spare fuse
11. SPARE: Spare fuse
12. ALT− S 7.5 A: Charging system
13. SRS WRN 7.5 A: SRS airbag warning
light
14. EFI 15 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system
15. HEAD (LH) LO 15 A: Left−hand head-
light (low beam)
16. HEAD (RH) LO 15 A: Right −hand
headlight (low beam)
ProCarManuals.com