dead battery TOYOTA HIGHLANDER 2001 Service Repair Manual

05-1970
- DIAGNOSTICSWIRELESS DOOR LOCK CONTROL SYSTEM
2160 Author
: Date
:
2005 HIGHLANDER REPAIR MANUAL (RM1144U)
ONLY WIRELESS CONTROL FUNCTION IS INOPERATIVE
CIRCUIT DESCRIPTION
The door control receiver receives a signal from transmitter and sends it to body ECU by line.
And the body ECU transmits the signal to the door lock assembly to control the door lock/unlock operation.
NOTICE:
The wireless door lock control system has a function with a large-scale multiplex communication
system. First of all, inspect the communication function depending on the ºHOW TO PROCEED WITH
TROUBLESHOOTINGº, and check that the communication system has no malfunction. Then finally
proceed with the troubleshooting. Also, in case that the wire harness between the body ECU and door
control receiver has been short-circuited, diagnostic code 42 will be output and the wireless control
will not function.
INSPECTION PROCEDURE
HINT:
The initial condition that the customizing function by the hand-held tester is not chosen is shown.
1. VEHICLE'S INITIAL CONDITION (CONDITION OF WIRELESS CONTROL POSSIBLE)
(a) No key in the ignition key cylinder.
(b) All doors closed (door open indicator off).
(c) All doors locked.
HINT:
The switch described in this text is a LOCK/ UNLOCK switch for transmitting, and it is built in the door control
transmitter.
1 CHECK TRANSMITTER BATTERY SIMPLY
(a) Check that the LED of the transmitter lights up 3 times when the switch has been pressed 3 times.
HINT:
If the LED does not light up when the switch has been pressed 3 times or more, it may be caused by the
dead battery. Replace the battery with a new or normal one, and then check that doors will be locked or un-
locked by the standard operation.
NOTICE:
Standard operation means to press and hold the transmitter switch for 1 second, facing the transmit-
ter to the vehicle, in 1 m (3.28 ft) away from the driver's door outside handle in the right direction.
NG REPLACE TRANSMITTER (LITHIUM) BATTERY
OK
2 CONFIRM ROOM LAMP ON
(a) Check that the room lamp comes on.
HINT:
When the lamp does not come on, proceed with the self-diagnostic mode after repairing the room lamp.
0526W-03

I40585
Infrared Ray Emitted Portion
05-1748
- DIAGNOSTICSREAR SEAT ENTERTAINMENT SYSTEM
1938 Author
: Date
:
2005 HIGHLANDER REPAIR MANUAL (RM1144U)
A REMOTE CONTROL SYSTEM DOES NOT OPERATE
INSPECTION PROCEDURE
1 CHECK BATTERY(SWITCH & VOLUME ASSY)
(a) Check battery.
(1) Check that the dry-cell battery used for the switch & volume assy is not dead.
Standard: It is not dead
NG BATTERY IS DEAD
OK
2 CLEAN THE INFRARED RAY EMITTED PORTION
(a) Clean the infrared ray emitted portion.
(1) Clean the infrared ray emitted portion on the televi-
sion display assy.
(2) Check whether the same malfunction occurs.
Standard: The function returns to normal.
NG PROCEED TO NEXT CIRCUIT INSPECTION
SHOWN IN PROBLEM SYMPTOMS TABLE
(See page 05-1704)
OK
NORMAL
05AU5-04

010QO-02
- INTRODUCTIONTERMS
01-41
41 Author
: Date
:
2005 HIGHLANDER REPAIR MANUAL (RM1144U)
TERMS
ABBREVIATIONS USED IN MANUAL
AbbreviationsMeaning
ABSAnti-Lock Brake System
A/CAir Conditioner
ACAlternating Current
ACCAccessory
ACISAcoustic Control Induction System
ACSDAutomatic Cold Start Device
A.D.D.Automatic Disconnecting Differential
A/FAir-Fuel Ratio
AHCActive Height Control Suspension
ALRAutomatic Locking Retractor
ALTAlternator
AMPAmplifier
ANTAntenna
Approx.Approximately
ASSYAssembly
A/T, ATMAutomatic Transmission
AT FAutomatic Transmission Fluid
AUTOAutomatic
AUXAuxiliary
AV GAverage
AV SAdaptive Variable Suspension
B+Battery Voltage
BABrake Assist
BACSBoost Altitude Compensation System
BATBattery
BDCBottom Dead Center
B/LBi-Level
B/SBore-Stroke Ratio
BTDCBefore Top Dead Center
BVSVBimetallic Vacuum Switching Valve
CANController Area Network
CBCircuit Breaker
CCoCatalytic Converter For Oxidation
CDCompact Disc
CFCornering Force
CGCenter Of Gravity
CHChannel
CKDComplete Knock Down
COMB.Combination
CPECoupe
CPSCombustion Pressure Sensor
CPUCentral Processing Unit
CRSChild Restraint System
CTRCenter
C/VCheck Valve
CVControl Valve
CWCurb Weight
DCDirect Current