TOYOTA HILUX 2013 Owners Manual (in English)

541 4-3. Do-it-yourself maintenance
4
Maintenance and care
HILUX_OM_OM0K189E_(EE)Side turn signal lights (fender-mounted type) (if equipped)
Remove the unit.
Turn the bulb base counterclock-
wise.
Remove the light bulb.
STEP1
Front
STEP2
STEP3

542 4-3. Do-it-yourself maintenance
HILUX_OM_OM0K189E_(EE)Stop/tail lights, rear turn signal lights, back-up lights and rear
fog light
Remove the securing bolts and
remove the unit.
Turn the bulb base counterclock-
wise.
Stop/tail light
Rear turn signal light
Back-up light or rear fog light
Remove the light bulb.
Stop/tail light
Rear turn signal light
Back-up light or rear fog light
STEP1
STEP2
STEP3

543 4-3. Do-it-yourself maintenance
4
Maintenance and care
HILUX_OM_OM0K189E_(EE)License plate lights
Remove the unit.
Turn the bulb base counterclock-
wise.
Remove the light bulb.
STEP1
STEP2
STEP3

544 4-3. Do-it-yourself maintenance
HILUX_OM_OM0K189E_(EE)Replacing the following bulbs
If any of the lights listed below has burnt out, have it replaced by
any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional.
Side turn signal lights (mirror-mounted type) (if equipped)
High mounted stoplight (if equipped)
When installing the rubber cover of the headlight
Ensure the rubber cover is securely attached.
LED light bulbs
The high mounted stoplight consists of a number of LEDs. If any of the LEDs
burn out, take your vehicle to any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional to have the light replaced.
Condensation build-up on the inside of the lens
Contact any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional for more information in the following situations.
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction.
Large drops of water have built up on the inside of the lens.
Water has built up inside the headlight.
Fit the rubber cover outer circumfer-
ence in firmly.
Fit the rubber cover around the light
bulb in until the light bulb plug can be
seen.

545 4-3. Do-it-yourself maintenance
4
Maintenance and care
HILUX_OM_OM0K189E_(EE)
CAUTION
Replacing light bulbs
Turn off the lights. Do not attempt to replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. Hold the
bulb by the plastic or metal portion.
If the bulb is scratched or dropped, it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
To prevent damage or fire
Make sure bulbs are fully seated and locked.
Check the wattage of the bulb before installing to prevent heat damage.

546 4-3. Do-it-yourself maintenance
HILUX_OM_OM0K189E_(EE)

5When trouble arises
547
HILUX_OM_OM0K189E_(EE)
5-1. Essential information
Emergency flashers .......... 546
If your vehicle needs
to be towed ..................... 547
If you think something is
wrong .............................. 553
Fuel pump shut off
system ............................ 554
5-2. Steps to take in
an emergency
If a warning light turns
on or a warning
buzzer sounds ................ 555
If you have a flat tire ......... 563
If the engine will not
start................................. 582
If the shift lever cannot
be shifted from P ............ 583
If you lose your keys ......... 584
If the vehicle battery is
discharged ...................... 585
If your vehicle
overheats ........................ 590
If you run out of fuel
and the engine stalls....... 593
If the vehicle becomes
stuck ............................... 594
If your vehicle has
to be stopped in
an emergency ................. 596

548
HILUX_OM_OM0K189E_(EE)
5-1. Essential information
Emergency flashers
NOTICE
To prevent battery discharge
Do not leave the emergency flashers on longer than necessary when the
engine is not running.
Use the emergency flashers if the vehicle malfunctions or is
involved in an accident.
Vehicles without automatic air conditioning system
Press the switch to flash all
the turn signal lights. To turn
them off, press the switch
once again.
Vehicles with automatic air conditioning system
Press the switch to flash all
the turn signal lights. To turn
them off, press the switch
once again.

5
549
5-1. Essential information
When trouble arises
HILUX_OM_OM0K189E_(EE)
If your vehicle needs to be towed
Before towing
The following may indicate a problem with your transmission. Contact
any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional, before towing.
The engine is running but the vehicle will not move.
The vehicle makes an abnormal sound.
If towing is necessary, we recommend having your vehicle towed by
any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional, such as or a commercial towing service,
using a lift-type truck or flatbed truck.
Use a safety chain system for all towing, and abide by all state/pro-
vincial and local laws.

550 5-1. Essential information
HILUX_OM_OM0K189E_(EE)
Emergency towing
If a tow truck is not available in
an emergency, your vehicle may
be temporarily towed using a
cable or chain secured to the
emergency towing eyelet(s).
This should only be attempted
on hard surfaced roads for short
distances at low speeds.
A driver must be in the vehicle to
steer and operate the brakes.
The vehicle’s wheels, drive train,
axles, steering and brakes must
be in good condition.