fuel type TOYOTA LAND CRUISER 1986 Factory User Guide

SF-26
- SFIINJECTOR
1725 Author
: Date
:
2004 LAND CRUISER (RM1071U)
(b) Turn the ignition switch OFF.
(c) Disconnect the negative (-) terminal cable from the bat-
tery.
(d) Remove SST and fuel tube connector.
SST 09268-41047, 09842-30070
(e) Disconnect the TOYOTA hand-held tester or OBD II scan
tool from the DLC3.
(f) Reconnect the fuel inlet pipe (fuel tube connector) to the
fuel filter.
CAUTION:
Perform connecting operations of the fuel tube connector
(quick type) after observing the precautions (See page
SF-1).

B04939
Delivery
Pipe
Lower
Intake
Manifold O-Ring
Grommet
Injector
Insulator
B04898B05006B04991
Type A
Type BPush
Pull Push
Pull
Disconnect
B05012
Type A Type B
S05382
RetainerType A only SF-4
- SFISFI SYSTEM
1703 Author
: Date
:
2004 LAND CRUISER (RM1071U)
(e) Install the injector to the delivery pipe and lower intake
manifold as shown in the illustration.
Before installing the injector, spindle oil or gasoline must
be applied on the place where the delivery pipe or the in-
take manifold touches the O-ring of the injector.
(f) Take following precautions to disconnect the fuel tube
connector (quick type):
(1) Check that there is no dirt on the pipe and around
the connector before disconnecting them. If there
is, clean the dirt away.
(2) Be sure to disconnect it with hands.
(3) Type A:
When the connector and the pipe are stuck, push
the clicks of the retainer and pull the connector to
free to disconnect and pull it out. Do not use any tool
at this time.
Type B:
When the connector and the pipe are stuck, turn
and pull the connector to disconnect. Do not use
any tool at this time.
(4) Inspect if there is any dirt or the likes on the seal sur-
face of the disconnected pipe and clean it away.
(5) Prevent the disconnected pipe and connector from
damaging and getting foreign objects by covering
them with a vinyl bag.
(g) Take following precautions to connect the fuel tube con-
nector (quick type):
(1) Do not reuse the retainer removed from the pipe.
(2) Do not use any tool. Use hands to connect the re-
tainer to the pipe.
(3) Check if there is any damage or foreign objects on
the connected part of the pipe.