TOYOTA LAND CRUISER 1998 Factory Repair Manual

INSTALLATION
Butt Weld
Butt Weld
Lift-Up Type Back Door Only:
Lift-Up Type Back Door Only:
Butt Weld
Butt Weld
1. Temporarily install the new parts and check the
fit of the tail gate or back door.
BODY PANEL REPLACEMENTRE-47

mm in.
220
908.66
3.54
BODY LOWER BACK PANEL (CUT)
REMOVAL (With the quarter panel rear extension
removed.)
Lift-Up Type Back Door Only:
220 mm
Cut and Join Location
90 mm
Cut and Join Location
1. Cut and join the parts at the locations as shown
above.
BODY PANEL REPLACEMENTRE-48

BODY PANEL REPLACEMENTRE-49

INSTALLATION
Butt Weld
Lift-Up Type Back Door Only:
Butt Weld
BODY PANEL REPLACEMENTRE-50

Back Door Opening
Lower Reinforcement
BODY PANEL REPLACEMENTRE-51

mmin.
2208.66
BODY LOWER BACK OUTER PANEL (CUT)
Door Only:
REMOVAL
Swing Type Back
Cut and Join Location
Cut and Join Location
220 mm
220 mm
Lift-Up Type Back Door Only:
Lift-Up Type Back Door Only:
2. Leave the body lower back inner panel to the
vehicle side. 1. Cut and join the parts at the locations as shown
above.
BODY PANEL REPLACEMENTRE-42

INSTALLATION
Swing Type Back Door Only:
Butt Weld
Butt Weld
Lift-Up Type Back Door Only:
Lift-Up Type Back Door Only:
1. Temporarily install the new parts and check the
fit of the tail gate or back door.
BODY PANEL REPLACEMENTRE-43

mm in.
220 8.66
BODY LOWER BACK OUTER PANEL (CUT)
REMOVAL (With the quarter panel rear extension
removed.)
Swing Type Back Door Only:
Cut and Join Location
220 mm
Lift-Up Type Back Door Only:
Lift-Up Type Back Door Only:
Rear Floor Side Panel
2. Leave the body lower back inner panel and rear
floor side panel to the vehicle side and remove
the body lower back outer panel. 1. Cut and join the parts at the location as shown
above.
BODY PANEL REPLACEMENTRE-44

INSTALLATION
Swing Type Back Door Only:
Butt Weld
Lift-Up Type Back Door Only:
Lift-Up Type Back Door Only:
Back Door Opening
Lower Reinforcement
BODY PANEL REPLACEMENTRE-45

mm in.
50
140
1501.97
5.51
5.91
CENTER BODY PILLAR (CUT)
REMOVAL
Cut and Join Location
(Cut Location for Supply Parts)
[Cut and Join Location]
50 mm
150 mm
140 mm
Cut and Join Location
Cut and Join Location
[Cut and Join Locations]
50 mm
50 mm
1. Cut and join the parts at the locations as shown
above.
2. Cut and join the outer pillar and pillar reinforce-
ment at position shifted about 50 mm (1.97
in.)3. Cut and join the rocker outer panel and rocker
panel reinforcement at position shifted about
50 mm (1.97 in.)
BODY PANEL REPLACEMENTRE-18