bolt pattern TOYOTA LAND CRUISER 1998 Factory Repair Manual

F05229
F05212
FRONT REAR
SST
SST
- SUSPENSION AND AXLEFRONT DIFFERENTIAL CARRIER
SA-49
1999 Author
: Date
:
2004 LAND CRUISER (RM1071U)
4. CHECK RING GEAR RUNOUT
(a) Place the bearing outer races on their respective bear-
ings. Check that the left and right outer races are not inter-
changed.
(b) Install the assembled plate washers onto the side bear-
ing.
(c) Install the differential case in the differential carrier.
HINT:
If it is difficult to install the differential case into the carrier, re-
place the plate washer with a thinner one.
However, select a plate washer that allows no clearance be-
tween it and the carrier.
(d) Align matchmarks on the bearing cap and differential car-
rier.
(e) Install and uniformly tighten the 4 bolts a little at a time.
(f) Using a dial indicator, measure the ring gear runout.
Maximum runout: 0.07 mm (0.0028 in.)
(g) Remove the differential carrier.
5. INSTALL DRIVE PINION FRONT AND REAR BEARING
OUTER RACES
(a) Using SST and a press, install the front bearing outer
race.
SST 09950- 60020 (09951- 00780), 09950- 70010
(09951-07150)
(b) Using SST and a press, install the rear bearing outer race.
SST 09950- 60020 (09951- 00710), 09950- 70010
(09951-07150)
6. INSTALL DRIVE PINION FRONT BEARING
(a) Install the washer on the drive pinion.
HINT:
First fit a washer with the same thickness as the washer which
was removed, then after checking the tooth contact pattern, re-
place the washer with one of a different thickness if necessary.