change time TOYOTA LAND CRUISER 2002 J100 Navigation Manual

i
Foreword
Thank you for your purchase of the Navigation System. Please read this \
manual carefully to ensure proper use. Keep this manual
stored in your vehicle at all times.
The Toyota Navigation System is one of the most technologically advanced vehi\
cle accessories ever developed. The system receiv es satellite
signals from the Global Positioning System (GPS) operated by the U. S. Department of Defense. Using these signals and other vehicle \
sen-
sors, the system can show you where you are and assist you in locating a desi\
red destination.
The navigation system is designed to select efficient routes from your present starting location to your destination. \
The syst em is designed
to direct you to a destination that is unfamiliar to you in an efficient manner. The routes are generated from a large database that includes
all roads contained in AAA state maps along with detailed street coverage f\
or many major metropolitan areas. The calculated rou tes are neither
the shortest routes nor routes without traffic congestion. Your own personal local knowledge or ºshort cutº may at times be fas ter than the
calculated routes.
The navigation system's database includes 53 point of interest categories to allow you to easi\
ly select destinations such as re staurants and
banks. If a destination is not in the database, you can enter the stree\
t address or a major intersection close to it and the system will route
you there. The system will provide both a visual map and audio instruction\
s. The audio instructions will announce the distance and direction
to go when you are approaching a fork or intersection. These voice inst\
ructions will help you keep your eyes on the road and a re timed to
provide enough time to allow you to maneuver, change lanes or slow down.
Please be aware that all current vehicle navigation systems have certain limitatio\
ns that may affect their ability to perform properly.
The accuracy of the vehicle's position depends on the satellite condition, road configuration, vehic\
le condition or other circum-
stances. For more information on the limitations of the system, refer to pages \
35 through 37.

2001 TOYOTA MOTOR CORPORATION
All rights reserved. This material may not be reproduced or copied, in
whole or in part, without the written permission of Toyota Motor Corporation.

2The navigation system operates by
switches on the screen and on the bezel.
When
you touch a switch, a beep sounds.
When using the switches on the touch
screen, please use only light pressure
with your finger to protect the screen
from damage. Do not use objects other
than your finger to touch the screen.
UN005
To type in an address etc., directly touch al-
phabet keys on the screen. If you touch a
wrong letter, delete it using the
switch.
Touching the
switch erases one letter. Touching the
ºListº switch will change the
screen to a display of the database items that
match the name or address that you have
entered on the screen. The number of
matching items is shown to the right side of
the screen. If the matching item is more than
9,999, the system displays º
º on the
screen.
To input numerals, touch the
º0±9º switch
and the display will change the screen to
number input display.
UN006
Touching the ºA±Zº switch changes the
screen back to the previous name input dis-
play.
UN007
When a list is displayed, you can scroll or
page through the list by using the appropri-
ate switch.
To shift to the next or previous
page.
To scroll up or down one item at
a time.
This expresses a displayed
screen position.
Inputting Letters and Numbers

5
5. By Home: You can select your own home
without entering the address each time. In
this case, it is necessary to register your
home beforehand. See page 15 for the de-
tailed steps.
6. By Emergency: You can select one of
the three points of emergency service points
that have been already stored in the sys-
tem's
database. See page 15 for the detailed
steps.
7. By Intersection: You can enter the
names of two intersecting streets. This is
helpful if you do not know the specific street
address of your destination but know the
general vicinity. See page 16 for the detailed
steps.
8. By Freeway Entrance/Exit: You can en-
ter the name of the freeway (interstate) en-
trance or exit. See page 17 for the detailed
steps.
9. By Previous Starting Point: You can en-
ter a point where the system has started to
guide last time. See page 19 for the detailed
steps.
10. By Map Selection: You can select a
destination simply by touching the location
on the displayed map. See page 19 for the
detailed steps.
INFORMATION
When inputting the destination, the response to the switch may be slow.
ºPoint of Interestº are mainly regis-tered in ºDetailed map coverageareasº. The registration is madebased on the NavTech ºStandardPOI Inclusion Listº.
If there is no point registered,switches such as ºMarked Pointº,ºHomeº, ºPrevious Destinationº orºPrevious Starting Pointº are
dimmed and not available.
The route for returning may not bethe same as that for going.
The route guidance to the destina-tion may not be the shortest route or
a route without traffic congestion.
Route gui dance may not be available
if there is no road data for the speci- fied location.
When setting the destination, youshould use the map on a scale of one
half mile or smaller.
To select an ºAddressº, ºPoint of In- terestº, ºFreeway Entrance/Exitº orºIntersectionº in a different region, asearch area's change is necessary.
CAUTION
While you are driving, be sure to follow
traffic regulations and keep the road
condition in mind. If a traffic sign on
the road has been changed, the route
guidance may provide wrong informa-
tion.

8
UN016
Touch the of the desired city name.
The current screen changes to the screen
which is for inputting a house number. In-
put a house number and a street name.
The screen changes and displays the
map location of the selected destination
and the route preference. (See ºEntering
Destinationº on page 19.)
Map: If you touch this switch, the screen
changes and displays the map location of the
selected city and the route preference. (See
ºEntering Destinationº on page 19.) There are 3 ways to select a point of in-
terest location.
(a) Input the name of the point of interest
directly.
(b) Inputting a city name first.
(c) Selecting from the points of interest
categories.
It will not take a long time for you to find
your
destination if you use a combination
of the searching ways of (a), (b) and (c). Touch the
ºPoint of Interestº switch
on the destination screen.
UN017
The ºPoint of Interestº screen appears, and
then you can input the name of the point of
interest.
Touch letters directly on the screen to input
a name. When you input numerals, touch
the
º0±9º switch to display the screen for
numeral input.
If the number of sites becomes 4 or less, or
if you touch the
ºListº switch at the bottom
right of the screen, the screen changes and
displays a list of sites.
Destination Input by POINT
OF INTEREST (a) Input the name of the
point of interest directly

20You are given a number of choices on the
conditions which the system uses to deter-
mine the route to your destination.
UN202
Touch the Onº switch of ºMinimize
Freeway Useº to search for a route other
than freeways as much as possible. (In
some cases, the route cannot avoid running
on a freeway.)
Touch the
Onº switch of ºMinimize Toll
Road Useº to search for a route other than
toll roads as much as possible.
Touch the
Onº switch of ºMinimize
Ferry Useº to search for a route without us-
ing a ferry as much as possible.
The switches you select are highlighted in
green. After choosing conditions, touch the
ºEnterº switch.
UN037
During the route search, ºRoute Search-
ingº appears at the top of the screen and
changes color from the left. When the
search is completed, three types of
routes are displayed on the screen.
UN038
Touch the ºNextº switch to choose one
from the three routes. Route 1:
A route on which you can reach the
destination in the shortest time.
Route 2: A route on which you can reach the
destination in the shortest distance.
Route 3: Other route.
After selecting one, you can start the route
guidance by touching the
ºStartº switch or
starting to move your vehicle.
If you want to set a way point between the
starting point and the destination or change
the search condition, touch the
ºChg.
Routeº
switch. The screen changes and
displays the change route menu. (For de-
tails, see page 22.)
When you keep touching the
ºStartº
switch until you hear a beep, Demo Mode will
start.

21
The route guidance system displays two
different screen modes.
UN039
Single screen:
Only map is shown in a
screen mode.
UN040
Split screen: Map and guidance screen are
shown in a screen mode. (For detail about
Guidance screen, see page 33.)
The two route guidance screens have a
number of indicators and switches with
which you should be familiar.
Map/Guide: To change two screen modes.
[GPS]: Upon reception of signals from the
GPS (Global Positioning System), this mark
appears. (For details, see page 35.)
zoom IN / zoom OUT: Magnifies or reduces
the map scale. (For details, see page 33.) POI:
Touch this switch, and symbols of
points of interest are shown on the screen.
(For details, see page 29.)
Mark: Touch this switch for one-touch regis-
tration of the marked point. (For details, see
page 53.)
INFORMATION
The distance to your destination ap- pears on the left of the screen.
The time to your destination can alsobe displayed. (For the setting steps,see page 2.)
Route Guidance Screen

22Chg. Route: The ºChange Routeº screen
appears and the following settings are avail-
able.
Reroute:
To change the condition for Re-
route.
Detour: To change the condition for Detour.
(For details, see page 28.)
Way point: To set and delete a way point.
(For details, see page 54.)
Route Preference: To change the condi-
tions of the route preference. (For details,
see page 19.)
Cancel Guidance: To stop the route guid-
ance. When you touch this switch, the map
screen appears.
INFORMATION
If the calculated route includes a trip by ferry, the route guidance shows a searoute. After you travel by ferry, the cur-rent vehicle position may be incorrect.Upon reception of GPS signals, it is au-
tomatically corrected.
UN042
The current vehicle position mark ap-
pears in the center of the map screen.
You can return to this map screen show-
ing your current position at any time from
any screen by pushing the
ºMAP/
VOICEº
button on the bezel.
During driving, the current vehicle position
mark is fixed in the center of the screen and
the map moves.
If you move the map with a ºone- touchº
scroll (see page 34 for details), the current
vehicle position mark continues to track your
current location.
Current Position Display

32
INFORMATION
The current vehicle position markappears at the bottom of the screennext to the name of the street you are
driving on. The mark does not move.
If you leave the guidance route, the name of the street you are on is notshown on the list next to the currentvehicle position mark.
If the road type you are on changesbetween a highway, a main street ora residential street (at an inter-
change or fork), it will appear on theturn list.
If a long route has been selected, itmay take a long time to display theturn list.
Push the ºMAP/VOICEº button on
the bezel to return to the map display with a route guidance.
You can change half of the screen to the
Guidance Screen by touching the
ºMap/
Guideº
switch while the map screen is
displayed. You can choose one out of
two types of Guidance Screen.
UN059
1. Push the ºMENUº button on the bezel
to display the menu screen and touch the
ºGuidance Setupº switch.
UN065
2. The screen will change to the Guidance
setup screen and you can select the
ºGuidance Screen Typeº.
To display Arrow Screen
To display Turn List Screen
Guidance Screen

35
UN061
UN062
You can change the orientation of the
map from North- up to Heading- up by
touching the direction symbol at the top
left of the screen.North-up symbol
Regardless of the direction of vehicle travel,
North is always up.Heading-up symbol
The direction of the vehicle travel is always
up. A red arrow indicates North. This navigation system calculates the
current vehicle position using satellite
signals, various vehicle signals, map
data, etc. However, an accurate position
may not be shown depending on the sat-
ellite condition, road configuration, ve-
hicle condition or other circumstances.
The Global Positioning System (GPS) devel-
oped and operated by the U.S. Department
of Defense provides an accurate current ve-
hicle position using 3 to 4 satellites. The
GPS system has a certain level of inaccura-
cy built in for security reasons. While the
navigation system will compensate for this
most of the time, occasional positioning er-
rors up to 300 feet can and should be ex-
pected. Generally, position errors
will be cor-
rected within a few seconds.
Orientation of the Map Limitations of the Navigation
System

37

When the tires are worn.
 After replacing a tire or tires.
 When using tires that are smaller or larger
than the factory specifications.
 When the tire pressure in any of the four
tires is not correct.
INFORMATION
If your vehicle cannot receive GPS sig-
nals, you can correct the current posi-tion manually. For the information onsetting the current position calibration,see page 59.
 When turning at a wrong intersection off
the designated route guidance.
 If you are heading for a destination with-
out passing through a set way point, auto-
matic rerouting may display a route re-
turning to the set way point.
 When turning at an intersection, there is
no route guidance.
 When passing through the intersection,
there is no route guidance.
 During automatic rerouting, the route
guidance may not be available for the next
turn to the right or left.
 It may take a long time to operate auto-
matic rerouting during high speed driving.
In automatic rerouting, a detour route may
be shown.
 During aut omatic rerouting, the route may
not be changed.
 The route in a U-turn may be shown or
announced.
 A location may have multiple names and
the system will announce one or more. 
Some routes may not be searched.
 If the route to your destination includes
gravel, unpaved roads or alleys, the route
guidance may not be shown.
 Your destination point might be shown on
the opposite side of the street.
 When a portion of the route has regula-
tions prohibiting the entry of the vehicle
that vary by time or season or other rea-
son.
 The road and map data stored in your
navigation system may not be complete
or may not be the latest release.
When replacing the tire(s), contact your
dealer.
This navigation system uses the tire turning
data and is designed to work with factory-
specified tires for your T oyota. Installing tires
that are larger or smaller than the originally
equipped diameter may cause inaccurate
display of the vehicle's position. The tire
pressure also affects the diameter of the tires
so please make sure the tire pressure of all
four tires is correct.
(b) Inappropriate route guidance
may occur in the following
cases
: