manual radio set TOYOTA LAND CRUISER 2002 J100 Navigation Manual

8
UNG604
1. Tune in the desired station.
2. Touch one of the station selector
switches (1-6) and hold it until a beep is
heard. This sets the station to the switch
and the frequency appears on the switch
Each switch can store FM1, FM2 and AM. To
change the preset station to a different one,
follow the same procedure.
The preset station memory is cancelled
when the power source is interrupted by bat-
tery disconnection or a blown fuse. Your vehicle has an electronic tuning radio
(ETR). T
une in the desired station using one
of the following methods.
Preset tuning: Touch the switch (1-6) or
push the º

º or ºº bu tto n of th e ºCHº button
for the station you want. The switch (1-6) is
highlighted in green and station frequency
appears on the display.
Manual tuning: Turn the ºTUNEº knob brief-
ly. Each time you turn the knob, the radio will
step up or down to another frequency.
Seek tuning: Push the º

º or ºº button of
the ºSEEKº button and hold it until you hear
a beep. The radio will begin seeking up or
down for a station of the nearest frequency
and will stop on reception. Each time you
push the button, the stations will be searched
out one after another.
UNG612
Scan tuning: Touch the ºSCANº switch
briefly. ºSCANº appears on the display. The
radio will find the next station up or down the
band, stay there for a few seconds, and then
scan again. To select a station, touch the
ºSCANº switch a second time.
(b) Presetting a station (c) Selecting a station