navigation system TOYOTA LAND CRUISER 2003 J100 Navigation Manual

SECTION VI
11 5
2003 Land Cruiser 100 Navigation (OM60A00U)
AUDIO SYSTEM
Audio system 11 6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . . .

11 6
2003 Land Cruiser 100 Navigation (OM60A00U)
Audio System
Quick reference for your audio system
Page
1. Audio operation screen display button 117
. . . . . . . . . . . . . . . . . . . . . . .
2. Function switch display screen 118
. . . . . . . . . . . . . . . . . . . . . .
3. Cassette tape slot 125 . . . . . . . . . . . .
4. Frequency turning knob 122 . . . . . . .
5. [Radio mode] Preset tuning 122 . . .
[Tape mode] Side change of
cassette tape 127 . . . . . . . . . . . . . . . .
[DISC mode] Disc selection 131 . . .
6. Traffic function button 123 . . . . . . . . .
7. Mode selectors 118 . . . . . . . . . . . . . . .
8. Stopping and ejecting a cassette tape 125 . . . . . . . . . . . . . . . .
9. [Radio mode] Seek tuning 123 . . . . .
[Tape/DISC mode] Direct access
to a desired program 127/131 . . . . .
10. Turning the system on and adjusting the volume 117 . . . . . . . . .

11 7
2003 Land Cruiser 100 Navigation (OM60A00U)
This section describes some of the basic fea-
tures of the audio system. Some information
may not pertain to your system.
Your audio system works when the ignition
key is in the ”ACC” or ”ON” position.
NOTICE
To prevent the battery from being
discharged, do not leave the car audio
on longer than necessary when the
engine is not running.
ocu002
Speech command system
Some descriptions in this manual are
marked with the above indicator. This
means that this function can be activated
using the speech command system.
For the operation of the speech command
system and the command list, see page 98
and 151.
POWERVOL: Push this knob to turn the
audio system on and off. Turn this knob to
adjust the volume. The system turns on in
the last mode used.
AUDIO: Push this button to display switches
for audio system.
Using your audio system:
s
ome basics
(a) Turning the system on and
off

11 8
2003 Land Cruiser 100 Navigation (OM60A00U)
Push the ”AM”, ”FM”, ”TAPE” or ”DISC”
button to turn on that mode. The selected
mode turns on directly.
Push these buttons if you want to switch from
one mode to another.
If the tape or disc is not set, the cassette play-
er or compact disc player does not turn on.
You can turn off the cassette player by eject-
ing the cassette tape. If the audio system
was previously off, then the entire audio sys-
tem will be turned off when you eject the cas-
sette tape. If another function was previously
playing, it will come on again.
UNG604
UNG605
The switches for radio, cassette tape and
disc player operation are displayed on
the liquid crystal display. Touch them
lightly and directly on the screen.

11 9
2003 Land Cruiser 100 Navigation (OM60A00U)
When the audio sound becomes difficult to
be heard due to road noise, wind noise, etc.
during driving, touch the ”ASL” switch. The
system adjusts to the optimum volume and
tone quality according to the noise level. How good an audio program sounds to you
is largely determined by the mix of the treble,
mid−
range, and bass levels. In fact, dif ferent
kinds of music and vocal programs usually
sound better with different mixes of treble,
mid−range, and bass.
A good balance of the left and right stereo
channels and of the front and rear sound lev-
els is also important.
Keep in mind that if you are listening to a ste-
reo recording or broadcast, changing the
right/left balance will increase the volume of
one group of sounds while decreasing the
volume of another.
UNG607
Touching the ”SOUND” switch on the
screen displays the sound adjustment
screen.
(b) Automatic sound levelizer(c) Tone and balance

120
2003 Land Cruiser 100 Navigation (OM60A00U)
UNG608
BASS ”+” or ””: Adjusts low−pitched
tones.
MID ”+” or ””: Adjusts mid −pitched tones.
TREB ”+” or ””: Adjusts high−pitched
tones.
”Front” or ”Rear”: Adjusts sound balance
between the front and rear speakers.
”L” or ”R”: Adjusts sound balance between
the left and right speakers.
”OK”: The previous screen returns. The antenna automatically extends when
the radio is on or the radio RDS system is on,
and retracts when the radio mode is off.
I17003
To adjust the height of the antenna manu-
ally, push the switch.
Clean the antenna mast periodically with a
clean dry cloth.
CAUTION
Before extending the antenna,
confirm
that no one is close enough to get
injured.
NOTICE
 To prevent damage to the antenna,
make sure it is retracted before
driving your vehicle through an
automatic car wash.
 Antenna mast have to be extended
higher than 100 mm (3.94 in) length
when the audio is on. Extend the an-
tenna mast when the radio signal is
weak.
(d) Your radio antenna

123
2003 Land Cruiser 100 Navigation (OM60A00U)
Your vehicle has an electronic tuning radio
(ETR). Tune in the desired station using one
of the following methods.
Preset tuning: Touch the switch (1−6) or
push the ”
” or ”” bu tto n of th e ”CH” button
for the station you want. The switch (1 −6) is
highlighted in green and station frequency
appears on the display.
Manual tuning: Turn the ”TUNE” knob brief-
ly. Each time you turn the knob, the radio will
step up or down to another frequency.
Seek t uning: Push the ”” or ”” button of
the ”SEEK” button and hold it until you hear
a beep. The radio will begin seeking up or
down for a station of the nearest frequency
and will stop on reception. Each time you
push the button, the stations will be searched
out one after another.
UNG612
Scan tuning: Touch the ”SCAN” switch
briefly. ”SCAN” appears on the display. The
radio will find the next station up or down the
band, stay there for a few seconds, and then
scan again. To select a station, touch the
”SCAN” switch a second time.
Preset scan tuning: Touch the ”SCAN”
switch and hold it until you hear a beep. ”P.
SCAN” appears on the display. The radio will
tune in the next preset station up or down the
band, stay there for a few seconds, and then
move to the next preset station. To select a
station, touch the ”SCAN” switch a second
time.
TRAF (T raffic) function: A station that reg-
ularly broadcasts traffic information is
automatically sought.
When you push the ”TRAF” button, ”TRAF
SEEK” appears on the display and the radio
will start seeking any traffic program station.
If any traffic program station is not found,
”NOTHING” appears and the previous mode
returns.
If the traffic program station is found, the
name for traffic program station is displayed
and ”TRAF” is lit for a while until traffic an-
nouncement is received.
(c) Selecting a station(d) RDS (Radio Data System)

125
2003 Land Cruiser 100 Navigation (OM60A00U)
UNG618
If a new message is received with the first
text message on the display, ”MSG” appears
on the corner of the screen again. When you
touch the ”LATEST MESSAGE” switch, the
new message appears.
The RDS audio system can store three mes-
sages consisting of 64 characters in
memory. To store a message in memory,
touch the ”STORE” switch until you hear a
beep.
If 3 messages are already stored in memory,
the oldest message will be overwritten by the
new message. To recall a radio text message, touch the
”RECALL”
switch. Each time you touch the
switch, the available messages will be dis-
played beginning with the newest one.
When you touch the ”OK” switch, the pre-
vious screen returns.
unc614
When you insert a cassette tape, the ex-
posed tape should face to the right.
The player will automatically start when you
insert a cassette tape. At this time, ”Tape”
appears on the display.
If a metal or chrome equivalent cassette tape
is put in the cassette player, the player will
automatically recognize it and ”MTL” ap-
pears on the display.
To stop or eject the cassette tape, push the
”
” button.
Cassette tape player
o
peration
(a) Playing a cassette tape

128
2003 Land Cruiser 100 Navigation (OM60A00U)
When the end of the tape is reached, the
player automatically reverses sides and re-
sumes normal play.
Push this button on the lower side to skip
backward. Push the button until ”REW” and
the number you want to skip appear on the
display.
 If you set ”REW 1”, the player will rewind
to the beginning of the current program.
 When counting the number of programs
you want to rewind, remember to count
the current program as well. For example,
if you want to rewind to a song that is two
before the song you are listening to, push
this button until ”REW 3” appears on the
display.
When the beginning of the tape is reached,
the player automatically resumes normal
play.
There must be at least 5 seconds of blank
space between programs for this feature to
work correctly.
”RPT”, ”SKIP” or ”Automatic program
selection” features: These features may
not work well with some spoken word, live or
classical recordings.
DVD player operation
The DVD player can play audio CDs, DVD
video discs and video CDs.
For appropriate discs for this player, see ”Car
audio/video system operating hints” on page
146.
For safety reasons, you can enjoy DVD vid-
eo discs and video CDs only when the ve-
hicle is completely stopped with the ignition
switch in the “ACC” or “ON” position and the
parking brake applied. While you are driving,
you can hear audio alone even in the DVD
video or video CD mode.
The DVD player can play the discs labeled
as shown below.
unc602
1. Pull the lock release lever and open the
console box.
(a) Inserting discs

129
2003 Land Cruiser 100 Navigation (OM60A00U)
unc603
2. Push this button to eject the magazine.
unx606
3. Pull out the tray while pushing the lock
release button.
unx607
4. Put a disc on the tray with its label face
up and push the tray back into the maga-
zine.
If the label faces down, the disc cannot be
played. In this case, “DISC CHECK” and
disc number appears on the display.
If a disc which is not playable is inserted,
”DISC CHECK” will also appear on the
screen. For appropriate discs for this paper,
see ”Car audio/video system operating
hints” on page 146.