engine TOYOTA LAND CRUISER 2007 J200 Navigation Manual

clvi
Using your audio system:
some basics
This section describes some of the basic
features of the Toyota audio system. Some
information may not pertain to your system.
Your audio system works when the ignition
key is in the “ACC” or “ON” position.
NOTICE
To prevent the battery from being
discharged, do not leave the car
audio on longer than necessary when
the engine is not running.
oxu002
By pushing the above button, you can
operate the speech command system.
For the operation of the speech command
system and the command, see page cxxxix
and cxli.
(a) Turning the system on and off
UNX602
POWERVOL: Push this knob to turn the
audio system on and off. Turn this knob to
adjust the volume. The system turns on in
the last mode used.
AUDIO: Push this button to display switches
for audio system.
VI

clxxxix Manufactured under license from Dolby
Laboratories. “Dolby”, “Pro Logic”, and
the doubleD symbol are trademarks of
Dolby Laboratories. Confidential unpub-
lished works.
19921997 Dolby Laboratories. All
rights reserved.
This product incorporates copyright
protection technology that is protected
by method claims of certain U.S. patents
and other intellectual property rights
owned by Macrovision Corporation and
other rights owners. Use of this copyright
protection technology must be autho-
rized by Macrovision Corporation, and is
intended for home and other limited view-
ing uses only unless otherwise autho-
rized by Macrovision Corporation. Re-
verse engineering or disassembly is
prohibited.
“DTS” is a trademark of Digital Theater
Systems, Inc.
Audio/video system
operating hints
NOTICE
To ensure the correct audio/video
system operation:
Be careful not to spill beverages
over the audio system.
Do not put anything other than a cas-
sette tape or magazine into the cas-
sette tape slot or DVD player.
The use of cellular phone inside or
near the vehicle may cause a noise
from the speakers of the audio
system which you are listening to.
However, this does not indicate a
malfunction.
Radio reception
Usually, the problem with radio reception
does not mean there is a problem with your
radio − it is just the normal result of condi-
tions outside the vehicle.
For example, nearby buildings and terrain
can interfere with FM reception. Power lines
or telephone wires can interfere with AM sig-
nals. And of course, radio signals have a
limited range, and the farther you are from a
station, the weaker its signal will be. In addi-
tion, reception conditions change constantly
as your vehicle moves.
Here are some common reception problems
that probably do not indicate a problem with
your radio:
FM
Fading and drifting stations − Generally,
the effective range of FM is about 40 km (25
miles). Once outside this range, you may
notice fading and drifting, which increase
with the distance from the radio transmitter.
They are often accompanied by distortion.
Multipath − FM signals are reflective, mak-
ing it possible for two signals to reach your
antenna at the same time. If this happens,
the signals will cancel each other out, caus-
ing a momentary flutter or loss of reception.
VI