steering TOYOTA LAND CRUISER 2008 J200 Repair Manual

368 4−2. Maintenance
Vehicle interior
Items Check points
Accelerator pedalMoves smoothly (without uneven
pedal effort or catching)?
Automatic transmission “Park”
mechanismCan the vehicle be hold securely
on an incline with the shift lever in
“P”?
Brake pedalMoves smoothly?
Does it have appropriate clear−
ance and correct amount of free
play?
BrakesPulls to one side when applied?
Loss of brake effectiveness?
Spongy feeling brake pedal?
Pedal almost touches floor?
Head restraintsMove smoothly and lock
securely?
Indicators/buzzersFunction properly?
LightsDo all the lights come on?
Headlights aimed correctly?
Parking brakeMoves smoothly?
Can hold the vehicle securely on
an incline?
Seat beltsDoes the seat belt system oper−
ate smoothly?
Are the belts undamaged?
SeatsDo the seat controls operate
properly?
Steering wheel
Moves smoothly?
Has correct free play?
No strange noises?

372 4−3. Do−it−yourself maintenance
ItemsParts and tools
Power steering fluid (
P. 386)Automatic transmission fluid
DEXRON
®II or III
Rag or paper towel
Funnel (used only for adding
power steering fluid)
Radiator and condenser (P. 383)
Tire inflation pressure (P. 401)Tire pressure gauge
Compressed air source
Washer fluid (P. 390)Water
Washer fluid containing antifreeze
(for winter use)
Funnel (used only for adding
washer fluid)

375
4−3. Do−it−yourself maintenance
4
Maintenance and care
Engine compar tment
Power steering fluid reser−
voir ( P. 386)
Engine oil level dipstick
(P. 377)
Engine coolant reservoir
(P. 382)
Cooling fan
Engine oil filler cap
(
P. 378)Brake fluid reservoir
(P. 384)
Fuse box ( P. 413)
Washer fluid tank
(P. 390)
Battery (
P. 387)
Condenser ( P. 383)
Radiator (
P. 383)
51234678
911 1 0ITY43C004

386 4−3. Do−it−yourself maintenance
Power steering fluid
nFluid level
The fluid level should be within the appropriate range.
Full (when hot)
Add fluid (when hot)
Full (when cold)
Add fluid (when cold)
Hot:Vehicle has been driven around 50 mph (80 km/h) for 20 min−
utes, or slightly longer in frigid temperatures. (Fluid tempera−
ture, 140°F − 175°F [60°C − 80°C]).
Cold:Engine has not been run for about five hours. (Room temper−
ature, 50°F − 85°F [10°C − 30°C]).
n
Checking the fluid level
Make sure to check the fluid type and prepare the necessary items.
Clean all dirt off the reservoir.
Remove the cap by turning it counterclockwise.
Wipe the dipstick clean.
Reinstall and remove the reservoir cap again.
Check the fluid level.
1
23
4
ITY43C070
Fluid type Automatic transmission fluid DEXRON® II or III
Items
Rag or paper, Clean funnel (only for adding fluid)
STEP1
STEP 2
STEP 3
STEP 4
STEP 5

387
4−3. Do−it−yourself maintenance
4
Maintenance and care
Battery
nExterior
Make sure that the battery terminals are not corroded and that there
are no loose connections, cracks, or loose clamps.
Terminals
Hold−down clamp
CAUTION
nWhen checking the reservoir
Take care, as the reservoir may be hot.
NOTICE
nWhen adding fluid
Avoid overfilling, or the power steering may be damaged.
nAfter replacing the reservoir cap
Check the steering box case, vane pump and hose connections for leaks or
damage.
1
1
2
ITY43C020

419
4−3. Do−it−yourself maintenance
4
Maintenance and care
41 ECU−B25 ADriving position memory sys−
tem
42 TEL5 A
No circuit
43 RSE7.5 A
Rear seat entertainment
44 TOWING30 A
To w i n g
45 DOOR NO.225 A
Main body ECU
46 STR LOCK20 A
Steering lock system
47 TURN−HAZ15 AMeter, front turn signal lights,
rear turn signal lights, towing
converter
48 EFI MAIN220 A
Fuel pump
49 ETCS10 A
EFI
50 ALT−S5 A
IC−ALT
51 AMP30 A
Audio system
52 RAD NO.110 ANavigation system, radio
receiver assembly
53 ECU−B15 Asmart key system, overhead
module, tilt and telescopic
steering, meter, cool box, gate−
way ECU, steering sensor
54 DOME15 A
Door courtesy lights, clock
55 HEAD LH15 A
Headlight high beam (left)
56 HEAD LL15 A
Headlight low beam (left)
57 INJ10 A
Injector, ignition
58 MET5 A
Meter
59 IGN10 ACircuit open, SRS airbag sys−
tem, gateway ECU, occupant
detection system, smart key
system, ABS, VSC, steering
lock system, GBS
60 HEAD RH15 A
Headlight high beam (right)
FuseAmpereCircuit

422 4−3. Do−it−yourself maintenance
5 ECU−IG NO.2 10 AAir conditioning system,
heater, overhead module,
ABS, VSC, steering sensor,
yaw rate & G sensor, main
body ECU, stoplights, moon
roof, clock, EC mirror
6 WINCH 5 A No circuit
7 A/C IG 10 ACool box, condenser fan,
cooler compressor, MG CL,
rear window defogger, RR
MGC VLV
8 TA I L 15 ATail lights, license plate lights,
front fog lights, front side
marker lights, rear side marker
lights, parking lights
9 WIPER 30 A Windshield wiper
10 WSH 20 A Windshield washer
11 RR WIPER 15 A Rear wiper
12 4WD 20 A 4WD
13 LH−IG 5 AAlternator, sub battery, seat
heater, windshield wiper de−
icer, seat belt pretensioners,
emergency flasher, inverter,
shift lever switch
14 ECU−IG NO.1 5 AABS, VSC, tilt and telescopic
steering, gateway ECU, shift
lock system, cruise control sys−
tem, pre−collision seat belt,
headlight cleaner, multi−dis−
play assembly, driving position
memory system, power door
lock system
15 S/ROOF
25 A Moon roof
FuseAmpereCircuit

423
4−3. Do−it−yourself maintenance
4
Maintenance and care
16 RR DOOR RH 20 A Power windows
17 MIR 15 AMirror ECU, outside rear view
mirror heater
18 RR DOOR LH 20 A Power windows
19 FR DOOR LH 20 A Power windows
20 FR DOOR RH 20 A Power windows
21 RR FOG 7.5 A No circuit
22 A/C 7.5 A Air conditioning system
23 AM1 5 A No circuit
24 TI & TE 15 A Tilt and telescopic steering
25 FR P/SEAT RH 30 A Front seat adjustment
26 PWR OUTLET 15 A Power outlet
27 OBD 7.5 A DLC3
28 PSB 30 A Pre−collision seat belt
29 DOOR NO.1 25 A Main body ECU
30 FR P/SEAT LH 30 A Front seat adjustment
31 INVERTER
15 A Inverter
FuseAmpereCircuit

440
5−1. Essential information
If your vehicle needs to be towed
Before towing
The following may indicate a problem with your transmission. Contact
your Toyota dealer before towing.
lThe engine is running, but the vehicle will not move.
l
The vehicle makes an abnormal sound.
Emergency towing
If a tow truck is not available in an emergency, your vehicle may be
temporarily towed using a cable or chain secured to the following
part. This should only be attempt
ed on hard, surfaced roads for short
distances at low speeds.
A driver must be in the vehicle to steer and operate the brakes. The
vehicle’s wheels, drive train, axles, steering and brakes must be in
good condition.
Towing hook
If towing is necessary, we recommen d having your vehicle towed by
your Toyota dealer or a commerci
al towing service, using a lifttype
truck or a flat bed truck.
Use a safety chain system for all to
wing, and abide by all state/pro
vincial and local laws.
Use a towing dolly or flat bed truck.

5
When trouble arises
441 5−1. Essential information
nEmergency towing procedure
The engine must be in ACCESSORY mode (engine off) or IGNI−
TION ON mode (engine running).
Put the four−wheel drive control switch in “H4”. (The center differen−
tial is unlocked.)
Put the shift lever in “N”.
Release the parking brake.
CAUTION
nWhile towing
lUse extreme caution when towing the vehicle.
Avoid sudden starts or erratic driving maneuvers which place excessive
stress on the emergency towing hook and the cable or chain.
lIf the engine is not running, the power assist for the brakes and steering
will not function, making steering and braking more difficult.
NOTICE
nTo prevent causing serious damage to the transmission
lNever tow this vehicle wheels on the ground.
l
Use only the front emergency towing hooks or towing eyelets (depending
on vehicles) when towing your vehicle.
STEP1
STEP 2
STEP 3
STEP 4