clock TOYOTA LAND CRUISER 2012 User Guide

465
3-7. Other interior features
3
Interior features
L/C200_EE (OM60G38E)
Clock
The clock is displayed when
The “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON
mode.
When the battery is disconnected
The time display will automatically be set to 1:00.
With navigation system
Refer to “Navigation System Owner’s Manual”.
Without navigation system
The clock can be adjusted by pressing the buttons.
Adjust hours.
Adjust minutes.
Round the nearest hour.
*
*
:e.g. 1:00 to 1:291:00
1:30 to 1:592:00
2
1
3

476
3-7. Other interior features
L/C200_EE (OM60G38E)
Seat heaters and ventilators
: If equipped
The seat heaters and ventilators heat the seats and maintain good
airflow by blowing air from the seats.
Front seat heaters/ventilators (if equipped)
Press the knob to release it.
Press the knob back in when
finished adjusting the tempera-
ture or the seat air flow.
Off
Blows air from the seat
The indicator light comes on.
The further you turn the knob
counterclockwise, the stronger
the airflow becomes.
Turns the seat heater on
The indicator light comes on.
The further you turn the knob
clockwise, the warmer the seat
becomes.

477 3-7. Other interior features
3
Interior features
L/C200_EE (OM60G38E)
Front seat ventilators (if equipped)
Press the knob to release it.
Press the knob back in when
finished adjusting the seat air
flow.
On
The indicator light comes on.
Adjusts the seat airflow
The further you turn the knob
clockwise, the stronger the air-
flow becomes.

506 4-3. Do-it-yourself maintenance
L/C200_EE (OM60G38E)Adding engine oil
If the oil level is below or near
the low level mark, add engine
oil of the same type as already in
the engine. (P. 649)
Make sure to check the oil type and prepare the items needed before
adding oil.
Remove the oil filler cap.
Add engine oil slowly, checking the dipstick.
Install the filler cap, turning it clockwise.
Engine oil selectionP. 649
Oil quantity
(Low  Full)1.5 L (1.6 qt., 1.3 Imp.qt.)
Items Clean funnel
STEP1
STEP2
STEP3

517 4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_EE (OM60G38E)
Fuel filter (diesel engine only)
You may drain the fuel filter yourself. However, as the operation is dif-
ficult, we recommend having it drained by your Toyota dealer. Even if
you decide to drain it yourself, contact your Toyota dealer.
The water in the fuel filter needs to be drained if the fuel system
warning light flashes and a buzzer sounds. (P. 574)
Turn the “ENGINE START STOP” switch OFF.
Place a small tray under the drain plug to catch the water and
any fuel that comes out.
Turn the drain plug counterclock-
wise about 2 to 2 1/2 turns.
Operate the priming pump until
fuel begins to run out.
After draining, tighten the drain plug by hand.
STEP1
STEP2
STEP3
STEP4
STEP5

539 4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_EE (OM60G38E)
49ETCS*110 A EFI
A/F*315 A A/F heater
50ALT-S5 A IC-ALT
51AMP 130 A Audio system
52 RAD NO.1 10 ANavigation system, audio system,
parking assist system
53 ECU-B1 5 ADouble lock system, smart entry &
start system, overhead module,
yaw rate & G sensor, tilt and tele-
scopic steering, meter, cool box,
gateway ECU, steering sensor,
VGRS
54 DOME1 5 A Illuminated entry system, clock
55 HEAD LH 15 A Headlight high beam (left)
56 HEAD LL 15 AHeadlight low beam (left), headlight
leveling system
57 INJ 10 A Injector, ignition system
58 MET 5 A Meter
59 IGN 10 ACircuit open, SRS airbag system,
gateway ECU, smart entry & push
start system, ABS, VSC, steering
lock system, GBS
60 DRL 5 A Daytime running light
61 HEAD RH 15 A Headlight high beam (right)
62 HEAD RL 15 A Headlight low beams (right)
63 EFI NO.2 7.5 A Air injection system, air flow meter
64 RR A/C NO.2 7.5 A No circuit
FuseAmpereCircuit

541 4-3. Do-it-yourself maintenance
4
Maintenance and care
L/C200_EE (OM60G38E)Under the instrument panel (type A)
FuseAmpereCircuit
1 CIG 15 A Cigarette lighter
2 BK/UP LP 10 A Back-up lights, trailer
3ACC 7.5 AAudio system, parking assist sys-
tem, multi-display assembly, main
body ECU, mirror ECU, smart entry
& start system, clock
4 PANEL 10 AFour-wheel drive system, ashtray,
cigarette lighter, cool box, cruise
control, center differential lock,
multi-display assembly, seat
heater, air conditioning system,
glove box light, emergency flash-
ers, audio system, headlight
cleaner switch, headlight leveling
dial, power heater, driving position
memory system, outside rear view
mirror switches, overhead module,
roll sensing of curtain shield air-
bags off switch, shift lever switch,
steering switches, VSC OFF
switch, console switch, PANEL
RLY

542 4-3. Do-it-yourself maintenance
L/C200_EE (OM60G38E)
5 ECU-IG NO.2 10 AAir conditioning system, heater,
overhead module, ABS, VSC,
steering sensor, yaw rate & G sen-
sor, main body ECU, stoplights,
moon roof, clock, EC mirror
6 WINCH 5 A No circuit
7 A/C IG 10 ACool box, condenser fan, cooler
compressor, rear window and out-
side rear view mirror defoggers, air
conditioning system
8TAIL 15 ATail lights, license plate lights, front
fog lights, rear fog light, trailer, front
position lights
9 WIPER 30 A Windshield wiper
10 WSH 20 A Windshield washer
11 RR WIPER 15 A Rear window wiper and washer
12 4WD 20 A Four-wheel drive system
13 LH-IG 5 AAlternator, seat heater, windshield
wiper de-icer, front seat belt, emer-
gency flasher, shift lever switch
14 ECU-IG NO.1 5 AABS, VSC, tilt and telescopic steer-
ing, gateway ECU, shift lock sys-
tem, parking assist system, cruise
control system, pre-crash safety,
trailer, headlight cleaner, multi-dis-
play assembly, rain-sensing wind-
shield wipers, driving position
memory system, power door lock
system
15 S/ROOF 25 A Moon roof
FuseAmpereCircuit

548 4-3. Do-it-yourself maintenance
L/C200_EE (OM60G38E)
Replacing light bulbs
Headlight high beams
Turn the bulb base counterclock-
wise.
Unplug the connector while
depressing the lock release.
STEP1
ITY43C041
STEP2

550 4-3. Do-it-yourself maintenance
L/C200_EE (OM60G38E)Front fog lights (if equipped)
Remove the fender liner bolts,
loose the fender liner nut and
remove the fender liner.
Fender liner bolts
Fender liner nut
Unplug the connector while
depressing the lock release.
Turn the light bulb counterclock-
wise.
STEP1
STEP2
STEP3