child lock TOYOTA PRIUS 2001 Service Repair Manual

BODY ± ENHANCEMENT OF PRODUCT APPEAL
182BO14
Phosphorescent
182BO15
A ± A Cross Section B ± B Cross Section CRS Lower AnchorageA
ACRS Anchor Bracket
CRS Anchor Bracket
Anchor Cover
Package
Tray Trim
Seat Back
CRS Lower
Anchorage
Seat CushionB
B 138
ENHANCEMENT OF PRODUCT APPEAL
INTERNAL TRUNK RELEASE HANDLE
An internal trunk release handle is included inside the trunk in case a person inadvertently locks himself with-
in the trunk and needs to free himself. The handle is made of phosphorescent so that it is visible in the trunk
for a while even after the trunk has been closed.
SEAT

CRS (Child Restraint System) lower anchorage for securing child seats, which complies with FMVSS225,
has been provided behind the seat cushion of both outer rear seats.

Three CRS anchor brackets for securing a child seat have been provided above the package tray trim.

IN04Q±11
IN±46
± INTRODUCTIONTERMS
46 Author: Date:
2001 PRIUS (RM778U)
TERMS
ABBREVIATIONS USED IN THIS MANUAL
AbbreviationsMeaning
ABSAnti±Lock Brake System
ACAlternating Current
ACCAccessory
ACISAcoustic Control Induction System
ACSDAutomatic Cold Start Device
A.D.D.Automatic Disconnecting Differential
A/FAir±Fuel Ratio
AHCActive Height Control Suspension
ALRAutomatic Locking Retractor
ALTAlternator
AMPAmplifier
ANTAntenna
APPROX.Approximately
A/TAutomatic Transmission (Transaxle)
AT FAutomatic Transmission Fluid
AUTOAutomatic
AUXAuxiliary
AV GAverage
AV SAdaptive Variable Suspension
BABrake Assist
BACSBoost Altitude Compensation System
BATBattery
BDCBottom Dead Center
B/LBi±Level
B/SBore±Stroke Ratio
BTDCBefore Top Dead Center
BVSVBimetallic Vacuum Switching Valve
Calif.California
CBCircuit Breaker
CCoCatalytic Converter For Oxidation
CDCompact Disc
CFCornering Force
CGCenter Of Gravity
CHChannel
COMB.Combination
CPECoupe
CPSCombustion Pressure Sensor
CPUCentral Processing Unit
CRSChild Restraint System
CTRCenter
C/VCheck Valve
CVControl Valve

H13687
H15431
H15432
H15433
± BODYREAR DOOR
BO±21
2001 PRIUS (RM778U)
14. REMOVE INSIDE PANEL PLATE
Remove the 3 screws and inside panel plate.
15. REMOVE INSIDE PANEL REINFORCEMENT
Remove the 4 screws and inside panel plate.
16. REMOVE DOOR GLASS
(a) Side out the door glass from the window regulator.
NOTICE:
Be careful not to drop the door glass.
(b) Pull the door glass upward to remove it.
17. REMOVE WINDOW REGULATOR
Disconnect the connector, then remove the 4 bolts and window
regulator.
Torque: 5.4 N´m (55 kgf´cm, 48 in.´lbf)
HINT:
Remove the regulator through the service hole.
HINT:
At the time of reassembly, please refer to the following item.
Apply MP grease to the window regulator.
18. REMOVE DOOR LOCK
(a) Remove the child protection cover.
(b) Disconnect the connector.
(c) Using a screwdriver, remove the door lock link guide and
clamp.
HINT:
Tape the screwdriver tip before use.
(d) Remove the 3 screws.
Torque: 4.9 N´m (50 kgf´cm, 43 in.´lbf)
HINT:
At the time of reassembly, please refer to the following item.
Apply adhesive to the 3 screws.
Part No. 08833±00070, THREE BOND 1324 or equiva-
lent
(e) Remove the bolts.
(f) Remove the door lock through the service hole.