tires TOYOTA PRIUS 2009 2.G Navigation Manual

ADVANCED FUNCTIONS
109
4. Touch either or to adjust the
direction of the current vehicle position
mark.
5. Touch “Enter”.
The map screen will be displayed. TIRE CHANGE CALIBRATION
The tire change
calibration function will be
used when replacing the tires. This func-
tion will adjust the miscalculation caused
by the circumference difference between
the old and new tires. If this procedure is
not performed when the tires are replaced,
the current vehicle position mark may be
incorrectly displayed.
To perform a distance calibration pro-
cedure, touch “Tire Change” on the
“Calibration” screen.
The message appears and the quick dis-
tance calibration is automatically started.
A few seconds later, a map screen will be
displayed.
08/06/25 Prius_Navi_U
OM47615U

OTHER FUNCTIONS
11 3
INFORMATION ITEMS
“ENGINE OIL”: Replace engine oil
“OIL FILTER”: Replace engine oil filter
“ROTATION”: Rotate tires
“TIRES”: Replace tires
“BATTERY”: Replace 12 volt battery
“BRAKE PAD”: Replace brake linings
“WIPERS”: Replace wiper blades
“LLC”: Replace engine coolant
“BRAKE OIL”: Replace brake fluid
“ATF”: Replace ATF (Automatic Trans-
mission Fluid)
“SERVICE”: Scheduled maintenance
“AIR FILTER”: Replace air filter
“PERSONAL”: New information items
can be created separately from provided
ones.
4. Input the conditions.
Notice of “Date”: The next maintenance
date can be input.
Notice of “Distance”: The driving dis-
tance until the next maintenance check
can be input.
“Delete”: To cancel the date and distance
conditions.
“Reset”: To reset the date and distance
conditions .
5. Touch “OK”.
The screen then returns to the “Mainte-
nance” screen.
INFORMATION
 For scheduled maintenance infor-
mation, please refer to the “Own-
er’s Manual Supplement/Sched-
uled Maintenance”.
 Depending on driving or road con-
ditions, the actual date and dis-
tance may differ from the stored
date and distance in the system.
08/06/25 Prius_Navi_U
OM47615U

APPENDIX
133
(a) Accurate current vehicle position
may not be shown in the following
cases:
When driving on a small angled Y−
shaped road.
When driving on a winding road.
When driving on a slippery road such
as in sand, gravel, snow, etc.
When driving on a long straight road.
When motorway and surface streets
run in parallel.
After moving by ferry or vehicle carrier.
When a long route is searched during
high speed driving.
When driving without setting the cur-
rent position calibration correctly.
After repeating a change of direction by
going forward and backward, or turning
on a turntable in the parking lot.
When leaving a covered parking lot or
parking garage.
When a roof carrier is installed.
When driving with tire chains installed.
When the tires are worn.
After replacing a tire or tires.
When using tires that are smaller or
larger than the factory specifications.
When the tire pressure in any of the
four tires is not correct.
INFORMATION
If your vehicle cannot receive GPS
signals, you can correct the current
position manually. For information
on setting the current position cal-
ibration, see page 108.
(b) Inappropriate route guidance may
occur in the following cases:
When turning at an intersection off the
designated route guidance.
If you set more than one destination but
skip any of them, auto reroute will dis-
play a route returning to the destination
on the previous route.
When turning at an intersection for
which there is no route guidance.
When passing through an intersection
for which there is no route guidance.
During auto reroute, the route guid-
ance may not be available for the next
turn to the right or left.
It may take a long time to operate auto
reroute during high speed driving. In
auto reroute, a detour route may be
shown.
After a uto reroute, the route may not be
changed.
An unnecessary U −turn may be shown
or announced.
A location may have multiple names
and the system will announce one or
more.
Some routes may not be searched.
If the route to your destination includes
gravel, unpaved roads or alleys, the
route guidance may not be shown.
Your destination point might be shown
on the opposite side of the street.
When a portion of the route has regula-
tions prohibiting the entry of the vehicle
that vary by time or season or other
reasons.
The road and map data stored in your
navigation system may not be com-
plete or may not be the latest version.
08/06/25 Prius_Navi_U
OM47615U

APPENDIX
134
After replacing a tire, implement the op-
eration described in the “TIRE
CHANGE CALIBRATION”. (See page
109.)
This navigation system uses tire turning
data and is designed to work with factory −
specified tires for your vehicle. Installing
tires that are larger or smaller than the orig-
inally equipped diameter may cause inac-
curate display of the vehicle’s position.
The tire pressure also affects the diameter
of the tires so please make sure the tire
pressure of all four tires is correct. This system uses the maps of DENSO.
©
2007 DENSO CORPORATION
© 2006 NAVTEQ. All rights reserved.
© 2006 Tele Atlas North America, Inc.
All rights reserved. This material is pro-
prietary and the subject of copyright
protection and other intellectual prop-
erty rights owned by or licensed to Tele
Atlas North America, Inc. The use of
this material is subject to the terms of
a license agreement. You will be held
liable for any unauthorized copying or
disclosure of this material.
Data by infoUSA Copyright © 2006, All
Rights Reserved.
© 2006 VISA Corporation
National Research Bureau © 2006
The Bullseye Design is a registered
trademark of Target Brands, Inc.
08/06/25 Prius_Navi_U
OM47615U
Map database information
and updates

20
NOTICE
The installation of window tinting may obstruct the GPS signals. Most window
tinting contains some metallic content that will interfere with GPS signal recep\
-
tion of the antenna in the instrument panel. We advise against the use of win-
dow tinting on vehicles equipped with navigation systems.
(a) Accurate current vehicle position may not be shown in the following case\
s:
When driving on a small angled Y −shaped road.
When driving on a winding road.
When driving on a slippery road such as in sand, gravel, snow, etc.
When driving on a long straight road.
When motorway and surface streets run in parallel.
After moving by ferry or vehicle carrier.
When a long route is searched during high speed driving.
When driving without setting the current position calibration correctly.
After repeating a change of direction by going forward and backward, or \
turning on
a turntable in the parking lot.
When leaving a covered parking lot or parking garage.
When a roof carrier is installed.
When driving with tire chains installed.
When the tires are worn.
After replacing a tire or tires.
When using tires that are smaller or larger than the factory specificati\
ons.
When the tire pressure in any of the four tires is not correct.
INFORMATION
If your vehicle cannot receive GPS signals, you can correct the current po\
sition
manually. For information on setting the current position calibration, see page
108.
(b) Inappropriate route guidance may occur in the following cases:
When turning at an intersection off the designated route guidance.
If you set more than one destination but skip any of them, auto reroute \
will display
a route returning to the destination on the previous route.
When turning at an intersection for which there is no route guidance.
When passing through an intersection for which there is no route guidanc\
e.
08/06/25 Prius_Navi_U
OM47615U

21

During auto reroute, the route guidance may not be available for the next turn \
to the
right or left.
It may take a long time to operate auto reroute during high speed driving.\
In auto re-
route, a detour route may be shown.
After auto reroute, the route may not be changed.
An unnecessary U−
turn may be shown or announced.
A location may have multiple names and the system will announce one or m\
ore.
Some routes may not be searched.
If the route to your destination includes gravel, unpaved roads or alley\
s, the route
guidance may not be shown.
Your destination point might be shown on the opposite side of the street.\
When a portion of the route has regulations prohibiting the entry of the\
vehicle that
vary by time or season or other reasons.
The road and map data stored in your navigation system may not be complete or may
not be the latest version.
After replacing a tire, implement the operation described in the “TIR\
E CHANGE
CALIBRATION”. (See page 109.)
This navigation system uses tire turning data and is designed to work with fa\
ctory −speci-
fied tires for your vehicle. Installing tires that are larger or smaller than the \
originally
equipped diameter may cause inaccurate display of the vehicle’s position. The tire pres-
sure also affects the diameter of the tires so please make sure the tire pressure of\
all four
tires is correct.
This system uses the maps of DENSO.
08/06/25 Prius_Navi_U
OM47615U
Map database informa-
tion and updates