light TOYOTA PRIUS 2009 2.G Quick Reference Guide

19
OVERVIEW
BASIC HYBRID VEHICLE OPER AT ION
FEAT U RES/O PERAT IONS
SAFETY AND EMERGENCY FEAT URES
Windows
Window operation
Automatic operation (driver side only) Push the switch completely down
or pull it completely up and release to fully open or close. To stop window
midway, lightly push the switch in the opposite direction.
Window lock switch Deactivates all passenger windows. Driver’s window
remains operable.
NO TE: If 12V battery is disconnected, the driver’s window will need to be
reinitialized. Refer to the Owner’s Manual for more details.
Window lock switch
Up
Down
Driver side
Down
Up
Tilt steering wheel
Hold wheel, push lever down, set angle and return lever.
Note: Do n ot attempt to adjust while the vehicle is in motion.
Angle
Lock release lever
M2.qxd 7/28/08 3:50 PM Page 19

26
SAFETY AND
EMERGENCY FEATUR ES
If belt is fully extended, then retracted even slightly, it cannot be
re-extended beyond that point, unless fully retracted again. This feature
is used to help hold child restraint systems securely.
To find more information about seat belts, and how to install a child
restraint system, refer to the Owner’s Manual.
Keep as low on
hips as possible
Take up slack
Too high
Seat belts
Moving the lever to “ LOCK” will allow the door to be opened only from
the outside.
Doors- Child safety locks
Door locks
Seat belts- Shoulder belt anchor
Unlock
Rear door
Push up, or squeeze lock
release to lower
Lock
M2.qxd 7/28/08 3:50 PM Page 26

27
OVERVIEW
BASIC HYBRID VEHICLE OPER AT ION
FEAT U RES/O PERAT IONS
SAFETY AND EMERGENCY FEAT URES
Emergency flashers
Note: The air vent on the ri ght side of the rear sea tback is desi gned
to assist in coolin g the Hybrid vehicle battery. DO NOT BLOC K
OR COVER THIS VEN T, as it may cause overhea ting, resultin g in
reduced vehicle performance .
Rear air vent
Push
System reset initialization
1. Push and hold “ S ET” button
until the indicator blinks
three times.
2. Wait a few minutes to allow initialization to complete.
Tire Pressure Monitoring (warning)
System
After ad justing tire pressures, or after tires have been rotated or
replaced, turn the ignition switch to “ ON” and press and hold the
“S ET” button until indicator blinks three times. Let the vehicle sit for a
few minutes to allow initialization to complete.
R efer to the load label on the door jamb or the Owner’s Manual for tire
inflation specifications.
If the tire pressure indicator flashes for more than 60 seconds and then
remains on, take the vehicle to your local Toyota dealer.
Note : The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not\
been initialized recently, setting the tire pressures to factory
specifications should turn off the light.
M2.qxd 7/28/08 3:50 PM Page 27