TOYOTA PRIUS 2009 2.G Quick Reference Guide

19
OVERVIEW
BASIC HYBRID VEHICLE OPER AT ION
FEAT U RES/O PERAT IONS
SAFETY AND EMERGENCY FEAT URES
Windows
Window operation
Automatic operation (driver side only) Push the switch completely down
or pull it completely up and release to fully open or close. To stop window
midway, lightly push the switch in the opposite direction.
Window lock switch Deactivates all passenger windows. Driver’s window
remains operable.
NO TE: If 12V battery is disconnected, the driver’s window will need to be
reinitialized. Refer to the Owner’s Manual for more details.
Window lock switch
Up
Down
Driver side
Down
Up
Tilt steering wheel
Hold wheel, push lever down, set angle and return lever.
Note: Do n ot attempt to adjust while the vehicle is in motion.
Angle
Lock release lever
M2.qxd 7/28/08 3:50 PM Page 19

20
FEATURES/OPERAT IONS
Passenger compartment temperature
Outside temperature
Temperature selector
Airflow vent
Fan speed
Automatic climate control ON
Fresh or recirculated cabin air
R ear window and outside rearview mirror defogger
Windshield airflow
Air Conditioning ON/OFF
Climate control OFF
Display the operation screen
Air Conditioning /Heating
* For details, refer to the “ Navigation System Owner’s Manual .”
Type 2 functions
Ty p e 1 functions
With navigation system*
M2.qxd 7/28/08 3:50 PM Page 20

21
OVERVIEW
BASIC HYBRID VEHICLE OPER AT ION
FEAT U RES/O PERAT IONS
SAFETY AND EMERGENCY FEAT URES
Setting a speed
System ON/OFF
R esume
2/Increase speed
Cancel1
Set /Decrease speed
Cruise control (if equipped)
Auto A /C ON/OFF
Temperature selector
Air intake selector
Windshield vent
R ear window and outside rearview mirror defogger
1 The set speed may also be cancelled by depressing the brake pedal.2 If vehicle speed falls below 25 mph, the set speed will not be resumed.
Turning system ON/OFF
Steering wheel switches
M2.qxd 7/28/08 3:50 PM Page 21

22
FEATURES/OPERAT IONS
RADIO
To preset a station Tune in the desired station and touch a station
selector icon (1-6) until you hear a beep.
To scan for stations Push “SCAN.” Push again to hold selection.
Audio
Audio operation screen
Push
Audio operation screen
Ty p e 1
Eject CDPush to turn ON/OFF
Audio
Type 2 additional functions
Audio file search
With
navigation
system*
Load CD(s)
Push to turn ON/OFF
Mode
Station/CD track scanSeek station /CD track select
Seek station /CD track
or audio file selectCD/ AUX mode select
* For details, refer to the “Navigation System Owner’s Manual .”
M2.qxd 7/28/08 3:50 PM Page 22

23
OVERVIEW
BASIC HYBRID VEHICLE OPER AT ION
FEAT U RES/O PERAT IONS
SAFETY AND EMERGENCY FEAT URES
CD PLAYER
To scan tracks on a disc Touch “S CAN” icon on the display. Push again to
hold selection.
CD changer (Type 2 only)
-To load one disc Push “LOAD” and insert one disc.
-To load multiple discs Push and hold “LOAD” until you hear a beep.
Insert one disc. Shutter will close and then re -open for next disc.
To select a file ( MP3/WMA only) Tu r n “ T UNE•FILE.”
“MODE”
Push to turn audio ON and select an audio mode.
Push and hold to turn the audio system OFF.
“ ” switch
In radio mode Push to select a preset station; push and hold to seek
the next strong station.
In CD mode Push to skip up or down to next /previous track.
>>
Steering wheel switches
By inserting a mini plug into the AUX audio jack, you can listen to music
from a portable audio device through the vehicle’s speaker system while
in AUX mode.
AUX audio jack (if equipped)
Center console
Volume control
M2.qxd 7/28/08 3:50 PM Page 23

24
FEATURES/OPERAT IONS
Luggage storage box
Unlock
Unlock
Bluetooth®technology allows dialing or receipt of calls without taking
hands from the steering wheel or using a cable to connect the telephone
and the system.
R efer to “ Hands-free system (for cellular phone ),” Section 3-4 in the
Owner’s Manual for more details.
Telephone controls ( Bluetooth®)
(if equipped)
MicrophoneDisplay
Steering wheel telephone switches
V olume
Start call
End call
Voice command button
M2.qxd 7/28/08 3:50 PM Page 24

25
OVERVIEW
BASIC HYBRID VEHICLE OPER AT ION
FEAT U RES/O PERAT IONS
SAFETY AND EMERGENCY FEAT URES
Clock
H-Hour set
M-Minute set
Cup and bottle holders
Cup holder- Front Cup holder-Rear
Bottle holder
Front door
Power outlets
Instrument panel ( 12V)Center console box ( 12V)
The Hybrid System must be in “A CC” or “IG-ON.”
Parking brake
Set: Depress
R elease: Depress again
M2.qxd 7/28/08 3:50 PM Page 25

26
SAFETY AND
EMERGENCY FEATUR ES
If belt is fully extended, then retracted even slightly, it cannot be
re-extended beyond that point, unless fully retracted again. This feature
is used to help hold child restraint systems securely.
To find more information about seat belts, and how to install a child
restraint system, refer to the Owner’s Manual.
Keep as low on
hips as possible
Take up slack
Too high
Seat belts
Moving the lever to “ LOCK” will allow the door to be opened only from
the outside.
Doors- Child safety locks
Door locks
Seat belts- Shoulder belt anchor
Unlock
Rear door
Push up, or squeeze lock
release to lower
Lock
M2.qxd 7/28/08 3:50 PM Page 26

27
OVERVIEW
BASIC HYBRID VEHICLE OPER AT ION
FEAT U RES/O PERAT IONS
SAFETY AND EMERGENCY FEAT URES
Emergency flashers
Note: The air vent on the ri ght side of the rear sea tback is desi gned
to assist in coolin g the Hybrid vehicle battery. DO NOT BLOC K
OR COVER THIS VEN T, as it may cause overhea ting, resultin g in
reduced vehicle performance .
Rear air vent
Push
System reset initialization
1. Push and hold “ S ET” button
until the indicator blinks
three times.
2. Wait a few minutes to allow initialization to complete.
Tire Pressure Monitoring (warning)
System
After ad justing tire pressures, or after tires have been rotated or
replaced, turn the ignition switch to “ ON” and press and hold the
“S ET” button until indicator blinks three times. Let the vehicle sit for a
few minutes to allow initialization to complete.
R efer to the load label on the door jamb or the Owner’s Manual for tire
inflation specifications.
If the tire pressure indicator flashes for more than 60 seconds and then
remains on, take the vehicle to your local Toyota dealer.
Note : The warning light may come on due to temperature changes or
changes in tire pressure from natural air leakage. If the system has not\
been initialized recently, setting the tire pressures to factory
specifications should turn off the light.
M2.qxd 7/28/08 3:50 PM Page 27

28
SAFETY AND EMERGENCY FEATUR ES
Jump starting
Jump start terminal
Connecting jumper cables
The jump start terminal is in the fuse box. To access the terminal, open
the fuse block cover and the jump start terminal cover.
Recommended
connecting point
Exclusive jump start
terminal cover
(1) Connect positive (red) jumper cable to the jump start terminal.
(2) Connect positive (red) jumper cable to the positive (+) terminal on the
booster battery.
(3) Connect negative (black) jumper cable to the negative (-) terminal on
the booster battery.
(4) Connect negative (black) jumper cable to the recommended
connecting point of the vehicle with the discharged battery.
(5) Depress brake pedal, and press “P OWER” button to start the vehicle.
R efer to the “ Owner’s Manua l” for more details.
(1)
(3)
(2)
(4)
(4)
M2.qxd 7/28/08 3:50 PM Page 28