key TOYOTA PRIUS C 2017 NHP10 / 1.G Owners Manual
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 2017, Model line: PRIUS C, Model: TOYOTA PRIUS C 2017 NHP10 / 1.GPages: 596, PDF Size: 10.05 MB
Page 495 of 596

4958-2. Steps to take in an emergency
8
When trouble arises
PRIUS c_U (OM52J11U)
Carrying out the corresponding action turns the message off.
After taking the specified steps to correct the suspected problem,
check that the warning message and light go off.
Other displayed message
Displayed messageDetails/Actions
Maintenance of the hybrid battery (traction battery)
cooling component is required The filter may be clogged, the air intake vent
may be blocked or there may be a gap in the
duct.
→ Have maintenance performed on the hybrid
battery (traction batter y) cooling component
at your Toyota dealer.
Have the malfunction repaired immediately. (vehicles with a
smart key system)
Interior
buzzerExterior buzzerWarning messageDetails/Actions
Once ⎯ The electronic key is not
detected when an attempt is
made to start the hybrid sys-
tem.
→
Start the hybrid system
with the electronic key
present.
(Flashes)
Page 496 of 596

4968-2. Steps to take in an emergency
PRIUS c_U (OM52J11U)
Once3 times
The electronic key was carried
outside the vehicle and the
driver’s door was opened and
closed while the shift lever was
in P without turning off the
“POWER” switch.
→Turn the “POWER” switch
off or bring the electronic
key back into the vehicle.
The electronic key was carried
outside the vehicle and a door
other than the driver's door was
opened and closed while the
“POWER” switch was in a
mode other than off.
→Bring the electronic key
back into the vehicle.
Once
Contin-
uous
(For 5 sec-
onds)
An attempt was made to lock
the doors using the entry func-
tion after the electronic key was
carried outside the vehicle with-
out turning off the “POWER”
switch.
→ Turn the “POWER” switch
off and lock the doors
again.
Interior
buzzerExterior buzzerWarning messageDetails/Actions
(Flashes)
(Displayed alternately)
(Flashes)
Page 497 of 596

4978-2. Steps to take in an emergency
8
When trouble arises
PRIUS c_U (OM52J11U)
9 times⎯
An attempt was made to start
the hybrid system without the
electronic key being present, or
the electronic key was not func-
tioning normally.
An attempt was made to drive
when the regular key was not
inside the vehicle.
→Confirm that the elec-
tronic key is inside the
vehicle.
Contin-
uous⎯
The driver’s door was opened
while a shift lever position other
than P was selected without
turning off the “POWER”
switch.
→ Shift the shift lever to P.
Contin-
uousContin-uous
The electronic key was carried
outside the vehicle and the
driver’s door was opened and
closed while a shift lever posi-
tion other than P was selected
without turning off the
“POWER” switch.
→ Shift the shift lever to P.
→ Bring the electronic key
back into the vehicle.
Interior
buzzerExterior buzzerWarning messageDetails/Actions
(Flashes)
(Flashes)
(Displayed alternately)
(Flashes)
Page 498 of 596

4988-2. Steps to take in an emergency
PRIUS c_U (OM52J11U)
⎯
Contin-uous
(5 sec-
onds)
An attempt was made to lock
the doors using the smart key
system while the electronic key
was still inside the vehicle.
→ Retrieve the electronic key
from the vehicle and lock
the doors again.
Once
Contin-
uous
(5 sec- onds)
An attempt was made to lock
either front door by opening a
door and putting the inside door
lock button into the lock posi-
tion, and then closing the door
while pulling on the outside
door handle with the electronic
key still inside the vehicle.
→ Retrieve the electronic key
from the vehicle and lock
the doors again.
Once⎯
• The electronic key could not
be detected when the
“POWER” switch was
pressed after the doors were
unlocked with the mechanical
key.
• The electronic key could not
be detected two consecutive
times when the “POWER”
switch was pressed.
→ Touch the electronic key to
the “POWER” switch while
depressing the brake
pedal.
Contin-
uous⎯
An attempt was made to start
the hybrid system with the shift
lever in a position other than P.
→ Shift the shift lever to P
and start the hybrid sys-
tem.
Interior
buzzerExterior buzzerWarning messageDetails/Actions
(Flashes)
(Flashes)
(Flashes)
(Flashes)
Page 499 of 596

4998-2. Steps to take in an emergency
8
When trouble arises
PRIUS c_U (OM52J11U)
⎯⎯
Power was turned off due to the
automatic power off function.
→Next time when starting
the hybrid system,
increase the engine speed
slightly and maintain that
level for approximately 5
minutes to recharge the
12-volt-battery.
Once⎯
The electronic key has a low
battery.
→Replace the electronic key
battery. ( →P. 448)
Once⎯
The driver's door was opened
and closed with the “POWER”
switch turned off and then the
“POWER” switch was put in
ACCESSORY mode twice with-
out the hybrid system being
started.
→Press the “POWER”
switch while depressing
the brake pedal.
During a hybrid system starting
procedure in the event that the
electronic key was not function-
ing properly
(→P. 516), the “POWER” switch
was touched with the electronic
key.
→ Press the “POWER”
switch within 10 seconds
of the buzzer sounding.
Interior
buzzerExterior buzzerWarning messageDetails/Actions
(Flashes)
Page 514 of 596

5148-2. Steps to take in an emergency
PRIUS c_U (OM52J11U)
One of the following may be the cause of the problem:
●Vehicles with a smart key system: The electronic key may not be
functioning properly. ( →P. 516)
● There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle. ( →P. 217)
● Vehicles with immobilizer syst em: There may be a malfunction in
the immobilizer system. ( →P. 8 4 )
● There may be a malfunction in the steering lock system.
● Vehicles with a smart key system : The hybrid system may be mal-
functioning due to an electrical problem such as an open circuit or a
blown fuse. However, depending on the type of malfunction, an
interim measure is available to start the hybrid system. (→P. 515)
One of the following may be the cause of the problem:
● The 12-volt battery may be discharged. ( →P. 518)
● The 12-volt battery terminal connections may be loose or corroded.
(→ P. 428)
If the hybrid system will not start
Reasons for the hybrid system not starting vary depending on
the situation. Check the follo wing and perform the appropriate
procedure:
The hybrid system will not start even though the correct starting
procedure is being followed. ( →P. 184, 188)
The interior lights and headlights are dim, or the horn does not
sound or sounds at a low volume.
Page 515 of 596

5158-2. Steps to take in an emergency
8
When trouble arises
PRIUS c_U (OM52J11U)
One of the following may be the cause of the problem:
●The 12-volt battery may be discharged. ( →P. 518)
● One or both of the 12-volt batter y terminals may be disconnected.
( → P. 428)
Contact your Toyota dealer if the problem cannot be repaired, or if repair
procedures are unknown.
When the hybrid system does not start, the following steps can be
used as an interim measure to start the hybrid system if the “POWER”
switch is functioning normally.
Do not use this starting procedure except in case of emergency.
Set the parking brake.
Shift the shift lever to P.
Turn the “POWER” switch to ACCESSORY mode.
Press and hold the “POWER” switch for about 15 seconds.
Even if the hybrid system can be started using the above steps, the
system may be malfunctioning. Have the vehicle inspected by your
Toyota dealer.
The interior lights and headlight s do not turn on, or the horn
does not sound.
Emergency start function (vehicles with a smart key system)
1
2
3
4
Page 516 of 596

5168-2. Steps to take in an emergency
PRIUS c_U (OM52J11U)
Use the mechanical key (→P.
121) in order to perform the fol-
lowing operations (driver’s door
only):
Unlocks the doors
Locks all the doors
Turning the key rearward unlocks
the driver’s door. Turning the key
once again within 5 seconds
unlocks the other doors.
Ensure that the shift lever is in P and depress the brake pedal.
Touch the Toyota emblem side
of the electronic key to the
“POWER” switch.
When the electronic key is
detected, a buzzer sounds and the
“POWER” switch will turn to ON
mode.
When the smart key system is
deactivated in customization set-
ting, the power switch will turn to
ACCESSORY mode.
If the electronic key do es not operate prop-
erly (vehicles with a smart key system)
If communication between the electronic key and vehicle is
interrupted (→P. 142) or the electronic key cannot be used
because the battery is depleted, the smart key system and wire-
less remote control cannot be used. In such cases, the doors
can be opened and the hybrid system can be started by follow-
ing the procedure below.
Locking and unlocking the doors
1
2
Starting the hybrid system
1
2
Page 517 of 596

5178-2. Steps to take in an emergency
8
When trouble arises
PRIUS c_U (OM52J11U)
Firmly depress the brake pedal and check that is displayed
on the multi-information display.
Press the “POWER” switch.
In the event that the “P OWER” switch still cannot be operated, contact
your Toyota dealer.
■ Stopping the hybrid system
Shift the shift lever to P and press the “POWER” switch as you normally do
when stopping the hybrid system.
■ Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the
electronic key battery be replaced immediately when the battery is depleted.
(→P. 448)
■ Changing “POWER” switch modes
Release the brake pedal and press the “POWER” switch in above.
The hybrid system does not start and modes will be changed each time the
switch is pressed. ( →P. 189)
■ If the doors cannot be locked or unlocked by the smart key system
Lock and unlock the doors by the mechanical key or wireless remote contr\
ol.
■ When the electronic key does not work properly
●Make sure that the smart key system has not been deactivated in the cus-
tomization setting. If it is off, turn the function on.
(Customizable features →P. 556)
● Check if battery-saving mode is set. If it is set, cancel the function.
(→P. 141)
3
4
3
Page 519 of 596

5198-2. Steps to take in an emergency
8
When trouble arises
PRIUS c_U (OM52J11U)
Connect the jumper cables according to the following procedure:Connect a positive jumper cabl e clamp to the exclusive jump
starting terminal on your vehicle.
Connect the clamp on the other e nd of the positive cable to the
positive (+) battery terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery termi-
nal on the second vehicle.
Connect the clamp at the other end of the negative cable to a
solid, stationary, unpainted metallic point away from the exclusive
jump starting terminal and any moving parts, as shown in the
illustration.
Start the engine of the second v ehicle. Increase the engine speed
slightly and maintain that le vel for approximately 5 minutes to
recharge the 12-volt battery of your vehicle.
Vehicles with a smart key system only: Open and close any of the
doors of your vehicle with the “POWER” switch off.3
1
2
3
4
4
5