sensor TOYOTA PRIUS PLUG-IN HYBRID 2022 Workshop Manual

4535-5. Using the driving support systems
Prius Plug-in Hybrid_OM_OM47E75E_(EE)
5
Driving
*: The images may differ from those shown in the illustrations depending on
the detection status. (P. 451)
Front center sensors
Front corner sensors
Front side sensorsRear side sensors
Rear corner sensors
Rear center sensors1
2
3
4
5
6

4545-5. Using the driving support systems
Prius Plug-in Hybrid_OM_OM47E75E_(EE)
When an obstacle is detected, the buzzer sounds.
OAs the obstacle is approached, the buzzer sounds more rapidly.
When the obstacle is extremely close, the buzzer switches from
sounding intermittently (short beeps) to continuously (a long beep).
• Distance to obstacle detected by front corner sensor is approxi-
mately 35 cm (1.2 ft.) or less
• Distance to obstacle detected by front side sensor or rear side
sensor is approximately 30 cm (1.0 ft.) or less
• Distance to obstacle detected by front sensor is approximately
35 cm (1.2 ft.) or less
• Distance to obstacle detected by rear corner sensor is approxi-
mately 35 cm (1.2 ft.) or less
• Distance to obstacle detected by back sensor is approximately
35 cm (1.2 ft.) or less
OWhen an obstacle is detected by multiple sensors simultaneously,
the buzzer sounds according to the distance to the closest obsta-
cle.
OWhen obstacles are simultaneously detected to the front and rear
of the vehicle, separate buzzers sound patterns according to the
distance to each obstacle.
The volume and timing of the buzzer can be changed. (P. 724)
Buzzer

4555-5. Using the driving support systems
Prius Plug-in Hybrid_OM_OM47E75E_(EE)
5
Driving
Approximately 100 cm (3.3 ft.)
Approximately 150 cm (4.9 ft.)
Approximately 60 cm (2.0 ft.)
Approximately 100 cm (3.3 ft.)
• The detection range is shown in
the illustration to the right. How-
ever, the sensor will not detect
the obstacle if it is too close.
• For details regarding obstacle
detection in the side areas.
( P. 456)
• The distance at which an obsta-
cle can be detected and whether
it can be detected depends on
the shape and condition of the
obstacle.
The obstacle detection range can be changed. ( P. 7 2 4 )
QOperation conditions
The power switch is turned on.
O Front corner sensors:
• Shift position is not in P
• Vehicle speed is approximately 10 km/h (6 mph) or less
O Front side sensors/rear side sensors:
• Shift position is not in P
• Vehicle speed is approximately 10 km/h (6 mph) or less
• Steering wheel is turned approximately 90  or more
O Front center sensors:
• Shift position is not in P or R
• Vehicle speed is approximately 10 km/h (6 mph) or less
O Rear corner sensors/rear center sensors:
Shift position is in R
Q Toyota parking assist-sensor pop-up display
 P. 477
Detection range of the sensors
1
2
3
4

4565-5. Using the driving support systems
Prius Plug-in Hybrid_OM_OM47E75E_(EE)
Q Sensor detection information
O The sensor’s detection areas are limited to the areas around the vehicle’s
bumper.
O Depending on the shape of the obstacle and other factors, the detection dis-
tance may shorten, or detection may be impossible.
O Obstacles may not be detected if they are too close to the sensor.
O There will be a short delay between obstacle detection and display. Even
when traveling at a low speed, if you come too close to an obst acle before
the display and buzzer activate, the display and buzzer may not activate at
all.
O Thin posts or objects lower than the sensor may not be detected when
approached, even if they have been detected once.
O It might be difficult to hear beeps due to the volume of audio system or air
flow noise of the air conditioning system.
Q Obstacle warning function
When an obstacle in the side areas is within the vehicle course while the
vehicle is moving forward or backward, this function inform the driver by the
display and the buzzer. ( P. 452, 454)
Q Obstacle detection in side areas
O Obstacles in the side areas are detected while driving by scanning the side
areas with the side sensors. Recognized obstacles are retained in memory
for up to approximately 2 minutes.
O Obstacles may not be detected in the side areas until the scan completes.
After the power switch is turned on, scanning completes after d riving the
vehicle for a short period of time.
O When an obstacle such as another vehicle, pedestrian or animal is detected
by the side sensors, the obstacle may continue to be detected e ven after it
has left the side sensor detection area.
Obstacle
Calculated vehicle course
1
2

4575-5. Using the driving support systems
Prius Plug-in Hybrid_OM_OM47E75E_(EE)
5
Driving
QIf “Clean Parking Assist Sensor” is displayed on the multi-information
display
A sensor may be dirty or covered with snow or ice. In such case s, if it is
removed from the sensor, the system should return to normal.
Also, due to the sensor being frozen at low temperatures, a mal function dis-
play may appear or an obstacle may not be detected. If the sens or thaws out,
the system should return to normal.
Q If “Parking Assist Malfunction” is displayed on the multi-information dis-
play
Depending on the malfunction of the sensor, the device may not be working
normally. Have the vehicle inspected by any authorized Toyota r etailer or
Toyota authorized repairer, or any reliable repairer.
Q Customization
Settings (e.g. buzzer volume) can be changed.
(Customizable features: P. 724)
Q Objects which the system may not properly detect
The shape of the object may prevent the sensor from detecting i t. Pay partic-
ular attention to the following objects:
O Wires, fences, ropes, etc.
O Cotton, snow and other materials that absorb sound waves
O Sharply-angled objects
O Low objects
O Tall objects with upper sections projecting outwards in the direction of your
vehicle
Q Situations in which the system may not operate properly
Certain vehicle conditions and the surrounding environment may affect the
ability of a sensor to correctly detect objects. Particular ins tances where this
may occur are listed below.
O There is dirt, snow, water drops or ice on a sensor. (Cleaning the sensors
will resolve this problem.)
O A sensor is frozen. (Thawing the area will resolve this problem.) In espe-
cially cold weather, if a sensor is frozen the sensor display m ay be displayed
abnormally, or objects, such as a wall, may not be detected.
O On an extremely bumpy road, on an incline, on gravel, or on grass.
O When a sensor or the area around a
sensor is extremely hot or cold.

4585-5. Using the driving support systems
Prius Plug-in Hybrid_OM_OM47E75E_(EE)OWhen vehicle horns, vehicle detectors, motorcycle engines, air brakes of
large vehicles, the clearance sonar of other vehicles or other devices which
produce ultrasonic waves are near the vehicle
OA sensor is coated with a sheet of spray or heavy rain.
OIf objects draw too close to the sensor.
OWhen a pedestrian is wearing clothing that does not reflect ultrasonic waves
(ex. skirts with gathers or frills).
OWhen objects that are not perpendicular to the ground, not perpendicular to
the vehicle traveling direction, uneven, or waving are in the detection range.
OStrong wind is blowing
OWhen driving in inclement weather such as fog, snow or a sandstorm
OWhen an object that cannot be detected is between the vehicle and a
detected object
OIf an object such as a vehicle, motorcycle, bicycle or pedestrian cuts in front
of the vehicle or runs out from the side of the vehicle
OIf the orientation of a sensor has been changed due to a collision or other
impact
OWhen equipment that may obstruct a sensor is installed, such as a towing
eyelet, bumper protector (an additional trim strip, etc.), bicycle carrier, or
snow plow
OIf the front of the vehicle is raised or lowered due to the carried load
OIf the vehicle cannot be driven in a stable manner, such as when the vehicle
has been in an accident or is malfunctioning
OWhen tire chains, a compact spare tire or an emergency tire puncture repair
kit are used.

4595-5. Using the driving support systems
Prius Plug-in Hybrid_OM_OM47E75E_(EE)
5
Driving
QSituations in which the system may operate even if there is no possibil-
ity of a collision
In some situations, such as the following, the system may opera te even
though there is no possibility of a collision.
O When driving toward a banner, flag, low-hanging branch or boom barrier
(such as those used at railroad crossings, toll gates and parki ng lots)
O When there is a rut or hole in the surface of the road
O When driving on a metal cover (grating), such as those used for drainage
ditches
O When driving up or down a steep slope
O If a sensor is hit by a large amount of water, such as when driving on a
flooded road
O There is dirt, snow, water drops or ice on a sensor. (Cleaning the sensors
will resolve this problem.)
O A sensor is coated with a sheet of spray or heavy rain
O When driving in inclement weather such as fog, snow or a sandstorm
O When vehicle horns, vehicle detectors, motorcycle engines, air brakes of
large vehicles, the clearance sonar of other vehicles or other devices which
produce ultrasonic waves are near the vehicle
O If the front of the vehicle is raised or lowered due to the carried load
O If the orientation of a sensor has been changed due to a collision or other
impact
O Driving close to columns (H-shaped steel beams, etc.) in multi-story parking
garages, construction sites, etc.
O If the vehicle cannot be driven in a stable manner, such as when the vehicle
has been in an accident or is malfunctioning
O When driving on a narrow road
O When strong winds are blowing

4605-5. Using the driving support systems
Prius Plug-in Hybrid_OM_OM47E75E_(EE)
O When tire chains, a compact spare tire or an emergency tire puncture repair
kit are used.
O On an extremely bumpy road, on an
incline, on gravel, or on grass
WARNING
Q Cautions regarding the use of the system
There is a limit to the degree of recognition accuracy and cont rol perfor-
mance that this system can provide, do not overly rely on this system. The
driver is always responsible for paying attention to the vehicl e’s surround-
ings and driving safely.
Q To ensure the system can operate properly
Observe the following precautions to avoid an unexpected accide nt.
O Do not damage the sensors, and always keep them clean.
O Do not attach a sticker or install an electronic component, such as a backlit
license plate (especially fluorescent type), fog lights, fender pole or wire-
less antenna near a radar sensor.
O Do not subject the surrounding area of the sensor to a strong impact. If
subjected to an impact, have the vehicle inspected by any autho rized
Toyota retailer or Toyota authorized repairer, or any reliable repairer. If the
front or rear bumper needs to be removed/installed or replaced, contact
any authorized Toyota retailer or Toyota authorized repairer, o r any reliable
repairer.
O Do not modify, disassemble or paint the sensors.
O Do not attach a license plate cover.
O Keep your tires properly inflated.
Q When to disable the function
In the following situations, disable the function as it may ope rate even
though there is no possibility of a collision.
O Failing to observe the warnings above.
O A non-genuine Toyota suspension (lowered suspension, etc.) is installed.

4615-5. Using the driving support systems
Prius Plug-in Hybrid_OM_OM47E75E_(EE)
5
Driving
WARNING
QSide sensors
In the following situations, the Toyota parking assist-sensor m ay not operate
normally and may result in an unexpected accident. Drive carefu lly.
O Obstacles may not be detected in the side areas until the vehicle is driven
for a short time and a scan of the side areas is completed. ( P. 456)
O Even after the scan of the side areas is completed, obstacles such as
other vehicles, people or animals that approach from the sides cannot be
detected.
O Even after the scan of the side areas is completed, obstacles may not be
detected depending on the surrounding situation of the vehicle.
At that time, the side sensor operation displays ( P. 451) temporary turn
off.
Q Notes when washing the vehicle
O Do not apply intensive bursts of water or steam to the sensor area.
Doing so may result in the sensor malfunctioning.
O When using steam to wash the vehicle, do not direct steam too close to
the sensors. The sensors may not function properly if subjected to steam.
NOTICE
QWhen using Toyota parking assist-sensor
In the following situations, the system may not function correc tly due to a
sensor malfunction etc. Have the vehicle checked by any authori zed Toyota
retailer or Toyota authorized repairer, or any reliable repaire r.
O Toyota parking assist-sensor operation display flashes, and a beep
sounds when no obstacles are detected.
O If the area around a sensor collides with something, or is subjected to
strong impact.
O If the bumper collides with something.
O If the display shows up and remains on without a beep.
O If a display error occurs, first check the sensor.
If the error occurs even when there is no ice, snow or mud on t he sensor, it
is likely that the sensor is malfunctioning.

4625-5. Using the driving support systems
Prius Plug-in Hybrid_OM_OM47E75E_(EE)
Parking Support Brake function
The system operates in the following situations when an obstacle is
detected in the traveling direction of the vehicle.
XThe vehicle is driven at low speeds and the brake pedal is not
depressed, or is depressed too late
XThe accelerator pedal is depressed too far
: If equipped
When a collision may occur with an obstacle while parking or
traveling at low speeds, when the vehicle suddenly moves for-
ward due to mistaken accelerator pedal operation, or when the
vehicle moves due to the wrong shift position being selected,
the sensors detect obstacles to the front or rear in the travel ing
direction of the vehicle, and the system operates to lessen
impact with obstacles such as walls, and reduce resulting dam-
age.
Examples of system operation