TOYOTA PRIUS PLUS 2013 Owners Manual

451 4-3. Do-it-yourself maintenance
4
Maintenance and care
PRIUS +_OM_OM47841E_(EE)
CAUTION
Replacing light bulbs
Be sure to stop the hybrid system and turn off the lights. Do not attempt to
replace the bulb immediately after turning off the lights.
The bulbs become very hot and may cause burns.
Do not touch the glass portion of the light bulb with bare hands. When it is
unavoidable to hold the glass portion, use and hold with a clean dry cloth
to avoid getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
Do not attempt to repair or disassemble light bulbs, connectors, electric
circuits or component parts.
Doing so may result in death or serious injury due to electric shock.
To prevent damage or fire
Make sure bulbs are fully seated and locked.

452 4-3. Do-it-yourself maintenance
PRIUS +_OM_OM47841E_(EE)

5When trouble arises
453
PRIUS +_OM_OM47841E_(EE)
5-1. Essential information
Emergency flashers .......... 454
If your vehicle needs to
be towed ......................... 455
If you think something is
wrong .............................. 462
5-2. Steps to take in an
emergency
If a warning light turns on
or a warning buzzer
sounds ............................ 463
If you have a flat tire
(vehicles with spare
tire) ................................. 476
If you have a flat tire
(vehicles without a
spare tire) ....................... 488
If the hybrid system
will not start..................... 510
If you lose your keys ......... 512
If the electronic key does
not operate properly ....... 513
If the 12-volt battery is
discharged ...................... 516
If your vehicle
overheats ........................ 522
If the vehicle becomes
stuck ............................... 528
If your vehicle has to
be stopped in an
emergency ...................... 530

454
PRIUS +_OM_OM47841E_(EE)
5-1. Essential information
Emergency flashers
NOTICE
To prevent 12-volt battery discharge
Do not leave the emergency flashers on longer than necessary when the
hybrid system is not operating.
Use the emergency flashers if the vehicle malfunctions or is
involved in an accident.
Press the switch to flash all
the turn signal lights. To turn
them off, press the switch
once again.

5
455
5-1. Essential information
When trouble arises
PRIUS +_OM_OM47841E_(EE)
If your vehicle needs to be towed
Before towing
The following may indicate a problem with your hybrid transmission.
Contact any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional before towing.
The hybrid system is operating but the vehicle will not move.
The vehicle makes an abnormal sound.
If there is a malfunction in the P position control system, the smart
entry & start system or the immobilizer system, or if the 12-volt bat-
tery is discharged, the vehicle cannot be towed with the front wheels
on the ground, as the front wheels may be locked. In this case, trans-
port the vehicle with both front wheels or all four wheels lifted.
If towing is necessary, we recommend having your vehicle towed by
any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional or a commercial towing service, using a
lift-type truck or flat bed truck.
Use a safety chain system for all towing, and abide by all state/pro-
vincial and local laws.

456 5-1. Essential information
PRIUS +_OM_OM47841E_(EE)
Emergency towing
If a tow truck is not available in
an emergency, your vehicle may
be temporarily towed using a
cable or chain secured to the
emergency towing eyelet(s).
This should only be attempted
on hard surfaced roads for short
distances at under 30 km/h
(18 mph).
A driver must be in the vehicle to
steer and operate the brakes.
The vehicle’s wheels, drive train,
axles, steering and brakes must
be in good condition.

5
457 5-1. Essential information
When trouble arises
PRIUS +_OM_OM47841E_(EE)
Installing towing eyelets
Remove the eyelet cover using a
flathead screwdriver.
To prevent damage, cover the tip
of the screwdriver with a rag.
Insert the towing eyelet into the
hole and tighten partially by
hand.
Tighten down the towing eyelet
securely using a wheel nut
wrench.
STEP 1
STEP 2
STEP 3

458 5-1. Essential information
PRIUS +_OM_OM47841E_(EE)
Towing with a sling-type truck
Do not tow with a sling-type truck
to prevent body damage.
Towing with a wheel-lift type truck
From the front
Release the parking brake.
From the rear
Use a towing dolly under the
front wheels.

5
459 5-1. Essential information
When trouble arises
PRIUS +_OM_OM47841E_(EE)
Using a flat bed truck
If you use chains or cables to tie
down your vehicle, the angles
shaded in black must be 45.
Do not overly tighten the tie
downs or the vehicle may be
damaged.
Before emergency towing
Turn the “POWER” switch to ON mode.
Do not turn the “POWER” switch to ACCESSORY mode.
Shift the shift position to N.
Release the parking brake.
Emergency towing eyelet location
P. 476, 488
STEP 1
STEP 2
STEP 3

460 5-1. Essential information
PRIUS +_OM_OM47841E_(EE)
CAUTION
Caution while towing
Use extreme caution when towing the vehicle.
Avoid sudden starts or erratic driving maneuvers which place excessive
stress on the emergency towing eyelets and the cables or chains. Always
be cautious of the surroundings and other vehicles while towing.
Do not turn the “POWER” switch off.
This may lead to an accident as the front wheels will be locked by the
parking lock.
If the hybrid system is off, the power assist for the brakes and steering will
not function, making steering and braking more difficult.
Installing towing eyelets to the vehicle
Make sure that towing eyelets are installed securely.
If not securely installed, towing eyelets may come loose during towing. This
may lead to accidents that cause serious injury or even death.