Guard TOYOTA RAIZE 2023 Owners Manual

421-1. For safe use
RAIZE_OM_General_BZ358E
WARNING
⬛Modification and disposal of SRS airbag system components
Do not dispose of your vehicle or pe rform any of the following modifications
without consulting your Toyota dealer.
The SRS airbags may malfunction or deploy (inflate) accidentally, causing death
or serious injury.
⚫Installation, removal, disassembly and repair of the SRS airbags
⚫Vehicles without SRS side and curtain shield airbags: Repairs, modifications,
removal or replacement of the steerin g wheel, instrument panel, dashboard
⚫Vehicles with SRS side and curtain sh ield airbags: Repairs, modifications,
removal or replacement of the steering wheel, instrument panel, dashboard,
seats or seat upholstery, front, side and rear pillars or roof side rails
⚫Repairs or modifications of the front fender, front bumper or side of the
occupant compartment
⚫Installation of a grille guard (bull bars, kangaroo bar, etc.), snow plows or
winches
⚫Modifications to the vehi cle’s suspension system
⚫Installation of electronic devices such as mobile two-way radios (RF trans-
mitter) and CD players
⚫Modification to your vehicle for a person with a physical disability
⬛If the SRS airbags deploy (inflate)
⚫A loud noise and white gas will be emitted.
⚫Vehicles without SRS curtain shield airbag : In addition to the front seat, parts
of the airbag module (steering whee l hub, airbag cover and inflator) may
become hot for several minutes. Th e airbag itself may also be hot.
⚫Vehicles with SRS side and curtain shie ld airbags: Parts of the airbag module
(steering wheel hub, airbag cover and infl ator), as well as parts of the front
seat, front pillar, center pillar, rear pillar, and roof side rails, may also become
hot for several minutes. The airbag itself may also be hot.
⚫The windshield may be damaged.
RAIZE_OM_General_BZ358E.book 42 ページ ２０２２年５月１７日　火曜日　午後１時５９分

431-1. For safe use
RAIZE_OM_General_BZ358E
✽: If equipped
For safety and security
1
⚫Vehicles with eCall: If any of the following situat ions occur, the system is
designed to send an emergency call* to the eCall control center, notifying
them of the vehicle’s location (witho ut needing to push the “SOS” button)
and an agent will attempt to speak with the occupants to ascertain the level
of emergency and assistance required. If the occupants are unable to com-
municate, the agent automa tically treats the call as an emergency and helps
to dispatch the necessary emergency services. ( ➞P. 6 8 )
⦁ An SRS airbag is deployed.
⦁ A seat belt pretensioner is activated.
⦁ The vehicle is involved in a severe rear-end collision.
⦁ The vehicle is involved in a rollover accident.
*In some cases, the call cannot be made. ( ➞P. 7 0 )
⬛Types of collisions that may depl oy SRS airbags (SRS front airbags)
⚫The SRS front airbags will deploy in the event of an impact that exceeds the
set threshold level (the level of force corresponding to a frontal collision at
the speed of approx. 20 to 30 km/h (12 to 18 mph) against a fixed wall that
will not move or deform).
However, this threshold velocity of th e airbag deployment will be considera-
bly higher in the following situations:
⦁ When the vehicle collides with a concrete wall or guardrail at an angle of
about 30° or more to the front
⦁ If the vehicle strikes an object, such as a parked vehicle or sign pole, which
can move or deform on impact
⦁ If the vehicle is involved in an unde rride collision, such as a collision in
which the front of the vehicle “underrides”, or goes under, is pinned under
a truck
⚫Depending on the type of co llision, it is possible that only the seat belt pre-
tensioners will activate.
⬛Types of collisions that may deploy SRS airbags (SRS side and curtain
shield airbags)
✽
⚫The SRS side and curtain shield airbags wi ll deploy in the event of an impact
that exceeds the set threshold level (t he level of force corresponding to a
perpendicular collision of an approx imately 1.5-ton vehicle traveling at
approximately 50 km/h (31 mph) into the cabin of the vehicle).
⚫The right and left SRS side and curtain shield airbags will also deploy in a
frontal collision if the force of th e collision is particularly strong.
RAIZE_OM_General_BZ358E.book 43 ページ ２０２２年５月１７日　火曜日　午後１時５９分

2164-5. Using the driving support systems
RAIZE_OM_General_BZ358E
dArea approx. between 3 m and 60 m (9.8 and 196.9 ft.) behind the rear
bumper
The greater the speed difference between your vehicle and the other vehicle, the
sooner the outside rear view mirror indicators will turn on and start flashing when
the other vehicle is located further away.
⬛Activation conditions of the BSM function
The BSM function will be activated when all of the following conditions are sat-
isfied:
⚫In the TFT color multi-info rmation display settings (➞P. 109), “BSM” is set to
“ON”
⚫When the shift lever is set in other than R
⚫When the BSM OFF indicator is off
⚫When the vehicle speed is approx. 16 km/h (10 mph) or greater
⬛Conditions where the BSM fu nction detects a vehicle
The BSM function detects a vehicle that has entered the detection area in the
following situations:
⚫When another vehicle traveling in th e next lane passes your vehicle
⚫When your vehicle passes another vehicl e traveling in the next lane with a
small speed difference
⚫When another vehicle enters the de tection range while changing lanes
⬛Conditions where the BSM function does not detect a vehicle
The BSM function may not detect vehicles that fit the following description or
non-vehicle objects:
⚫Small motorcycles, bicycles , pedestrians, and so on
⚫Oncoming vehicles
⚫Still objects such as guardrails, walls, road signs, parked vehicles, and so on
⚫A following vehicle traveling in the same lane
⚫Other vehicle traveling in the lane that is 2 lanes away from yours
⚫Vehicles that your vehicle has passed with a large speed difference
⚫Vehicles in the next lane’s detection area, which is the rear side of your vehi-
cle, but not approaching your vehic le (The system determines approaching
vehicles using radar detection data.)
⚫Vehicles in the shape that do not easily reflect radar signals (such as a low
height trailer without cargo, sports cars)
RAIZE_OM_General_BZ358E.book 216 ページ ２０２２年５月１７日　火曜日　午後１時５９分

2174-5. Using the driving support systems
RAIZE_OM_General_BZ358E
Driving
4
⬛Situations where the BSM function may not work properly
⚫The BSM function may not detect vehicles correctly in the following circumstances.
⦁The sensor positions or orientations are off due to a strong impact applied
to the sensors or the surrounding areas
⦁ The sensors or the rear bumper near the sensors are covered with mud,
snow, ice, or stickers
⦁ Driving on a wet road or driving in a puddle under bad weather conditions,
such as heavy rain, snow, or fog
⦁ Several vehicles are continuously approaching in a tight space
⦁ When there is not enough distance between your vehicle and the follow-
ing vehicle
⦁ When the speed difference between yo ur vehicle and the other vehicle in
the detection range is too large
⦁ When the speed difference between your vehicle and the other vehicle is
fluctuating
⦁ When the speed of your vehicle and the other vehicle in the detection
range is almost the same
⦁ When another vehicle continues to stay in the detection range after your
vehicle starts moving from the stopped state
⦁ When driving up and down on a series of steep slopes or driving on
dented areas of a road
⦁ When driving through a sharp curve or continuous curves, or driving in an
area with ups and downs
⦁ When the other vehicle in the next la ne is too far away from your vehicle,
such as while driving in a wide lane or driving on the edge of the lane
⦁When the vehicle has accessories such as a bicycle carrier installed in the rear side
⦁When there is a large difference in th e vehicle height of your vehicle and
the other vehicle in the detection range
⦁ Right after turning on the BSM function or the RCTA function
⦁ Right after setting the shift lever to other than R
⦁ When an extremely heavy load is st ored in the luggage compartment
⦁ When a vehicle changed lanes from 2 lanes away to the next lane
⚫The BSM function may have more unnecessary detections, especially in the
following circumstances.
⦁The sensor positions or orientations are off due to a strong impact applied
to the sensors or the surrounding areas
⦁ When guardrails or walls have ente red the detection area while the dis-
tance from the vehicle is short
⦁ When a vehicle other than that trave ling in the next lane has entered the
detection range, such as while driving in a narrow lane or driving on the
edge of the lane
RAIZE_OM_General_BZ358E.book 217 ページ ２０２２年５月１７日　火曜日　午後１時５９分

2194-5. Using the driving support systems
RAIZE_OM_General_BZ358E
Driving
4
For the vehicle traveling fast, the warning buzzer will sound at a position
further away from the vehicle.
⬛Activation conditions of the RCTA function
The RCTA function will be activated when all of the following conditions are sat-
isfied:
⚫In the TFT color multi-info rmation display settings (➞P. 109), “RCTA” is set to
“ON”
⚫When the shift lever is set to R
⚫When the RCTA OFF indicator is off
⚫When your vehicle’s speed is approx. 8 km/h (5 mph) or less
⚫When the approaching vehicle’s speed is approx. between 8 and 28 km/h (5
and 18 mph)
⬛Situations where the RCTA function may not work properly
The RCTA function may not detect vehicles that fit the following description or
non-vehicle objects:
⚫A vehicle approaching from directly behind
⚫A vehicle backing up from the parking spot next to your vehicle
⚫Vehicles that cannot be detected by
the sensors due to obstacles
⚫Still objects such as guardrails, walls, road signs, parked vehicles, and so on
⚫Small motorcycles, bicycles, pedestrians, and so on
⚫Vehicles driving away from your vehicle
⚫A vehicle approaching from the parki ng spot next to your vehicle
⚫A vehicle approaching at high speed
Approaching vehicle’s speedaWarning distance (approximate)
Approx. 28 km/h (18 mph) (fast)Approx. 20 m (65.6 ft.)
Approx. 8 km/h (5 mph) (slow)Approx. 5.5m (18.0 ft.)
KBRO460507
RAIZE_OM_General_BZ358E.book 219 ページ ２０２２年５月１７日　火曜日　午後１時５９分

2204-5. Using the driving support systems
RAIZE_OM_General_BZ358E
⬛Situations where the RCTA function may not work properly
⚫The RCTA function may not detect vehicles correctly in the following circumstances.
⦁The sensor positions or orientations are off due to a strong impact applied
to the sensors or the surrounding areas
⦁ The sensors or the rear bumper near the sensors are covered with mud,
snow, ice, or stickers
⦁ Driving on a wet road or driving in a puddle under bad weather conditions,
such as heavy rain, snow, or fog
⦁ When several vehicles are passing continuously behind your vehicle or
when a vehicle is approaching from th e opposite direction to the vehicle
detected first
⦁ When the vehicle is parked on a hill or an uneven road
⦁ When the vehicle has accessories such as a bicycle carrier installed in the
rear side
⦁ When the vehicle is moving backward on a steep hill with varying slopes
⦁ When the vehicle is parked diagonally
⦁ Right after turning on the RCTA function
⦁ Right after starting the engine wi th the RCTA function turned on
⦁ When being affected by radio wave interference from the radar sensors
installed on the vehicle parked next to your vehicle
⦁ When getting out from a sloped parking spot
⦁ When a large vehicle is parked next to your vehicle
⦁ When the vehicle is backing up at fast speed
⚫The RCTA function may have more unnecessary detections, especially in the
following circumstances.
⦁The sensor positions or orientations are off due to a strong impact applied
to the sensors or the surrounding areas
⦁ When another vehicle passes through the side of your vehicle
⦁ When the vehicle is traveling on a
road facing a parking lot
⦁ When metal objects (such as guardrails, walls, signs, parked vehicles) that
can easily reflect radio waves are located behind the vehicle
⦁ When the vehicle has accessories such as a bicycle carrier installed in the
rear side
⦁ When buildings or roadside walls are present in the direction to which the
vehicle is backing up
KBRO460508
RAIZE_OM_General_BZ358E.book 220 ページ ２０２２年５月１７日　火曜日　午後１時５９分