tailgate TOYOTA RAV4 1996 Service Repair Manual
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 1996, Model line: RAV4, Model: TOYOTA RAV4 1996Pages: 1632, PDF Size: 41.64 MB
Page 622 of 1632

1999-2000 ACCESSORIES & EQUIPMENT
Power Door Locks - Trucks
DESCRIPTION & OPERATION
Power door locks are all controlled through a multipurpose Electronic Control Unit (ECU) or integration relay.
The Land Cruiser is controlled through the instrument cluster ECU. The 4Runner is controlled through the body
ECU, and the Sienna, Tundra, RAV4 and Tacoma are all controlled through the integration relay. Each system
also consists of a door lock motor at each door, tailgate, liftgate and sliding door, a master door lock switch at
driver's door, which controls all other doors, tailgate, liftgate and sliding doors and a switch at each door,
tailgate, liftgate and sliding doors.
To operate door locks from the outside, insert door key into door lock cylinder and turn it to the right
(clockwise) once will unlock the driver's door and turning it a second time will unlock all other doors, tailgate,
liftgate and sliding doors. Passenger door will unlock all other doors when it is unlocked. When either front
door lock is turned to left (counter clockwise) all other doors will lock. The driver's door has a master lock
switch which will lock all doors on the vehicle. Each door and sliding doors have a switch inside that controls
each door lock.
COMPONENT LOCATIONS
COMPONENT LOCATIONS NOTE: This article also applies to Lexus LX470. Refer to Land Cruiser, unless
otherwise indicated.
NOTE: For information on keyless entry systems, see appropriate KEYLESS ENTRY
SYSTEMS article.
ComponentLocation
Body ECU (4Runner)Lower Left Side Of Dashboard
Instrument ECU (Land Cruiser)Under Center Of Dashboard
Integration Relay (RAV4)On Rear Of Instrument Panel Fuse Box, Lower Left
Side Of Dashboard
Integration Relay (Sienna)On Instrument Panel Fuse Box, Lower Left Side Of
Dashboard
Integration Relay (Tacoma)On Instrument Panel Fuse Box, Lower Left Side Of
Dashboard
Integration Relay (Tundra)On Instrument Panel Fuse Box, Lower Left Side Of
Dashboard
Unlock Warning Switch (Land Cruiser)Under Dashboard, Left Side Of Center Console
Unlock Warning Switch (RAV4)Under Dashboard, Left Side Of Center Console
Unlock Warning Switch (Sienna)Under Dashboard, Left Side Of Center Console
Unlock Warning Switch (Tacoma)Under Dashboard, Left Side Of Center Console
1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Power Door Locks - Trucks
1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Power Door Locks - Trucks
Microsoft
Sunday, November 22, 2009 10:53:11 AMPage 1 © 2005 Mitchell Repair Information Company, LLC.
Microsoft
Sunday, November 22, 2009 10:53:15 AMPage 1 © 2005 Mitchell Repair Information Company, LLC.
Page 635 of 1632

Fig. 16: Identifying Door Lock Actuator Harness Connector (Land Cruiser, Sienna, 4Runner & Tundra)
REAR DOOR UNLOCK DETECTION SWITCH
Inspect rear door unlock detection switch continuity by measuring between specified door lock actuator
terminals. See REAR DOOR UNLOCK DETECTION SWITCH
table. If continuity is not as specified,
replace rear door unlock detection switch. See Fig. 16
.
REAR DOOR UNLOCK DETECTION SWITCH
TAILGATE, LIFTGATE UNLOCK DETECTION SWITCH
Inspect rear tailgate, liftgate unlock detection switch continuity by measuring between specified tailgate or
liftgate lock actuator terminals. See TAILGATE, LIFTGATE UNLOCK DETECTION SWITCH
CONTINUITY table. If continuity is not as specified, replace tailgate or liftgate lock actuator. See Fig. 17 .
TAILGATE, LIFTGATE UNLOCK DETECTION SWITCH CONTINUITY
4Runner (Driver's Door)
Door Set To UNLOCK1 & 4Yes
Application & Switch PositionTerminal No.Continuity
Land Cruiser
Door Set To UNLOCK1 & 4Yes
4Runner
Door Set To UNLOCK1 & 4Yes
1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Power Door Locks - Trucks
Microsoft
Sunday, November 22, 2009 10:53:11 AMPage 14 © 2005 Mitchell Repair Information Company, LLC.
Page 1453 of 1632

1999-2000 ACCESSORIES & EQUIPMENT
Power Windows - Trucks
DESCRIPTION & OPERATION
Depending on model, system components vary. System components may consist of a power main relay, body
control ECU, integration relay or instrument ECU. See WIRING DIAGRAMS
. All models have power
window switches and power window motors for each door. With ignition switch in ON position, battery voltage
is supplied through power main relay or body control ECU to power window switches. Power window switch
supplies power and ground for power window motors. 4Runner also has a power window switch and lock
switch for tailgate door.
Driver's power window switch offers one-touch operation of driver's window. Driver's power window switch
also includes a lock-out feature to prevent passengers from operating any other power window switches.
ADJUSTMENTS
ADJUSTING METHOD FOR JAM PROTECTION
To adjust limit switch to OFF position, connect motor to harness connector and operate power window motor in
UP direction for 4-5 seconds. This sets limit switch to full UP position (OFF).
TROUBLE SHOOTING
WINDOW REVERSES WHEN OPERATED IN AUTO UP MODE (DRIVER'S WINDOW ONLY)
If window reverses when window is being raised in AUTO UP mode, check door glass run, window regulator,
window motor or window guide for sign of damage or misalignment. Resistance in window glass movement
causes window to reverse direction. Check power window motor limit switch for proper adjustment. See
ADJUSTING METHOD FOR JAM PROTECTION
under ADJUSTMENTS. If all mechanical checks are
okay, replace driver's power window master switch with a known-good unit and retest.
AUTO REVERSE INOPERATIVE WITH OBSTRUCTION IN WINDOW NOTE: Use this procedure when power window motor has been replaced or when
power window motor has been run while removed from vehicle.
NOTE: Trouble shooting available for Land Cruiser and RAV4 models only. For
connector views for trouble shooting diagnostic steps, see CONNECTOR
VIEWS .
NOTE: This test diagnoses inoperative AUTO REVERSE operation (jam function) when
foreign object restricts window up operation. AUTO REVERSE mode will not
operate when window is within .157" (4 mm) of fully open position.
1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Power Windows - Trucks
1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Power Windows - Trucks
Microsoft
Sunday, November 22, 2009 10:59:35 AMPage 1 © 2005 Mitchell Repair Information Company, LLC.
Microsoft
Sunday, November 22, 2009 10:59:39 AMPage 1 © 2005 Mitchell Repair Information Company, LLC.
Page 1463 of 1632

4Runner
1. Remove master switch and disconnect 14-pin connector. Connect jumper wire between 12-volt battery
positive terminal and master switch terminals No. 3 and 10. Connect another jumper between battery
negative terminal and master switch terminal No. 4.
2. Measure voltage by backprobing between specified terminals with driver's power window switch in
specified position. See POWER WINDOW MASTER SWITCH VOLTAGE TEST (4RUNNER)
table. Voltage should be 10-14 volts. If voltage is not as specified, replace power window switch. If
voltage is as specified, switch is okay.
POWER WINDOW MASTER SWITCH VOLTAGE TEST (4RUNNER)
POWER WINDOW SWITCH CONTINUITY TEST (BACK DOOR/TAILGATE)
4Runner
Using an ohmmeter, check continuity between specified terminals with back door/tailgate power window switch
in specified position. See POWER WINDOW SWITCH CONTINUITY TEST (4RUNNER
- BACK
DOOR/TAILGATE) table. See Fig. 13 . If continuity does not exist at specified terminals, replace appropriate
power window switch.
POWER WINDOW SWITCH CONTINUITY TEST (4RUNNER - BACK DOOR/TAILGATE)
DOWN13 & 14
(1)For terminal location, see Fig. 7 .
Application & Switch Position(1) Terminals No.
Driver's Switch (Locked & Unlocked)
UP1 & 2
DOWN1 & 2
Passenger's Switch (Locked & Unlocked)
UP7 & 8
DOWN7 & 8
Left Rear Switch (Locked & Unlocked)
UP9 & 11
DOWN9 & 11
Right Rear Switch (Locked & Unlocked)
UP13 & 14
DOWN13 & 14
(1)For terminal location, see Fig. 7 .
Application & Position(1) Terminals No.
UP2 & 6
OFFNone
1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Power Windows - Trucks
Microsoft
Sunday, November 22, 2009 10:59:35 AMPage 11 © 2005 Mitchell Repair Information Company, LLC.
Page 1467 of 1632

Motor should operate in opposite direction. If motor does not test as specified, replace motor.
POWER WINDOW LOCK SWITCH
Tailgate Door (4Runner)
Switch Continuity Test
Disconnect power window lock switch Black 10-pin connector, located on left side of instrument panel.
Using an ohmmeter, check continuity between terminals No. 7 (White/Black wire) and No. 10
(Blue/White wire) with lock switch in UNLOCK position. See Fig. 13
. Continuity should be present.
With lock switch in LOCK position, continuity should not be present. If continuity is not as specified,
replace switch.
Switch Illumination Circuit Test
Check continuity between power window lock switch terminals No. 2 (Green wire) and No. 3
(Green/White wire). Continuity should be present with power window lock switch in LOCK or UNLOCK
position. If continuity is not as specified, replace power window lock switch.
POWER WINDOW LIMIT SWITCH
Tailgate Door (4Runner)
Disconnect power window limit switch 2-pin connector, located on left side of tailgate door, behind trim panel.
Using an ohmmeter, check continuity between terminals No. 1 (Red/Blue wire) and No. 2 (White/Black wire)
with switch in ON position. Continuity should exist. With switch in OFF position, continuity should not exist. I
f
continuity is not as specified, replace switch.
CONNECTOR VIEWS
Use the following connector views for diagnostic pin point tests in TROUBLE SHOOTING , COMPONENT
TESTS and CIRCUIT TESTS . See Fig. 4-Fig. 13.
1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Power Windows - Trucks
Microsoft
Sunday, November 22, 2009 10:59:35 AMPage 15 © 2005 Mitchell Repair Information Company, LLC.
Page 1473 of 1632

Fig. 12: Identifying Passenger & Rear Power Window Switch Connector Terminals (Land Cruiser,
RAV4, Sienna, Tacoma, Tundra & 4Runner)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Fig. 13: Identifying Back Door/Tailgate Power Window Switch Connector Terminals (4Runner)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
CIRCUIT TESTS
INTEGRATION RELAY CIRCUIT TEST
1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Power Windows - Trucks
Microsoft
Sunday, November 22, 2009 10:59:35 AMPage 21 © 2005 Mitchell Repair Information Company, LLC.
Page 1493 of 1632

Fig. 21: Tailgate Power Window System Wiring Diagram (4Runner)
1999 Toyota RAV4
1999-2000 ACCESSORIES & EQUIPMENT Power Windows - Trucks
Microsoft
Sunday, November 22, 2009 10:59:36 AMPage 41 © 2005 Mitchell Repair Information Company, LLC.