TC00D-02
P20891
No.1 Air Hose
Air Cleaner
and MAF Meter
Assembly
Tube Bracket
Non-reusable Air Cleaner Duct
Theft Deterrent Horn
Tube Clamp
A/T Oil Cooler TubeMAF Meter Connector
Engine Wire Protector
Cruise Control
Actuator Cable
Heat Insulator
for No.2 Front
Exhaust Pipe
Pipe Support BracketGasket
Tube ClampFront Lower Arm
Bracket Stay
Engine Under CoverUpper Front
Crossmember
ExtensionNo.2 Front
Exhaust Pipe
Gasket
x 16
- TURBOCHARGING (2JZ-GTE)TURBOCHARGER
TC-7
1207 Author: Date:
1997 SUPRA (RM502U)
COMPONENTS
TC00E-02
P11430
ClampWire
P11348Arm Bracket Stay
Crossmember
Extension
P12054
TC-10
- TURBOCHARGING (2JZ-GTE)TURBOCHARGER
1210 Author: Date:
1997 SUPRA (RM502U)
REMOVAL
1. DRAIN ENGINE COOLANT
2. REMOVE ENGINE UNDER COVER
3. DISCONNECT CRUISE CONTROL ACTUATOR
CABLE FROM THROTTLE BODY
4. REMOVE NO.1 AIR HOSE
5. REMOVE AIR CLEANER DUCT
6. REMOVE AIR CLEANER AND MAF METER
ASSEMBLY
(a) Remove the 3 bolts.
(b) Loosen the hose clamp, disconnect the air hose from the
intake air connector.
(c) Disconnect the MAF meter wire from the clamp on the air
cleaner case.
(d) Disconnect the MAF meter connector, and remove the air
cleaner and MAF meter assembly.
7. DISCONNECT THEFT DETERRENT HORN FROM
BODY
8. REMOVE FRONT LOWER ARM BRACKET STAY
Remove the 2 bolts, nut, plate washer and arm bracket stay.
Torque:
Bolts 44 N´m (450 kgf´cm, 33 ft´lbf)
Nut 59 N´m (600 kgf´cm, 43 ft´lbf)
9. REMOVE UPPER FRONT CROSSMEMBER
EXTENSION
Remove the 2 bolts, 2 nuts and crossmember extension.
Torque:
Bolts 29 N´m (300 kgf´cm, 22 ft´lbf)
Nuts 33 N´m (340 kgf´cm, 25 ft´lbf)
10. REMOVE NO.2 FRONT EXHAUST PIPE
(a) Remove the 2 bolts and nuts holding the front exhaust
pipe to the No.2 front exhaust pipe.
Torque: 58 N´m (590 kgf´cm, 43 ft´lbf)
(b) Remove the 2 bolts and pipe support bracket.
Torque: 43 N´m (440 kgf´cm, 32 ft´lbf)
(c) Disconnect the front exhaust pipe from the No.2 exhaust
pipe. Remove the gasket.
HINT:
At the time of installation, please refer to the following items.
Use a new gasket.
