trans removal TOYOTA T100 1996 Factory Service Manual

Downloaded from www.Manualslib.com manuals search engine PP3LO−01
PP−86
− PREPARATIONPROPELLER SHAFT
135 Author: Date:
1996 TOYOTA T100 (RM449U)
PROPELLER SHAFT
SST (Special Service Tools)
09325−40010Transmission Oil PlugTransmission to prevent oil leakage
09330−00021Companion Flange Holding ToolCompanion flange holding
09332−25010Universal Joint Bearing Remover
& ReplacerSpider bearing removal and installa-
tion

Downloaded from www.Manualslib.com manuals search engine EM07I−03
− ENGINE MECHANICAL (3RZ−FE)ENGINE UNIT
EM−65
1996 TOYOTA T100 (RM449U)
REMOVAL
1. REMOVE BATTERY
2. REMOVE ENGINE UNDER COVER
Remove the 4 bolts and engine under cover.
3. DRAIN ENGINE COOLANT
4. DRAIN ENGINE OIL
5. DRAIN TRANSMISSION OIL
6. REMOVE HOOD
7. REMOVE RADIATOR RESERVOIR TANK
8. REMOVE RADIATOR (See page CO−15)
9. REMOVE AIR CLEANER CAP, MAF METER AND RES-
ONATOR
(a) Disconnect the MAF meter connector, IAT sensor con-
nector and wire clamp.
(b) Loosen the air cleaner hose clamp.
(c) Loosen the 4 clips, and remove the air cleaner cap, MAF
meter and resonator.
10. REMOVE AIR CLEANER CASE
(a) Remove the air cleaner element.
(b) Remove the 3 bolts and air cleaner case.
11. M/T:
DISCONNECT ACCELERATOR CABLE FROM
THROTTLE BODY
12. A/T:
DISCONNECT ACCELERATOR AND THROTTLE
CABLES FROM THROTTLE BODY
13. REMOVE INTAKE AIR CONNECTOR
(a) Disconnect the 2 air hoses and vs hose.
(b) Remove the 2 bolts, hose clamp and intake air connector.

Downloaded from www.Manualslib.com manuals search engine EM06W−02
− ENGINE MECHANICAL (5VZ−FE)ENGINE UNIT (2WD)
EM−65
1996 TOYOTA T100 (RM449U)
REMOVAL
1. DRAIN ENGINE COOLANT
2. DRAIN ENGINE OIL
3. DRAIN TRANSMISSION OIL
4. REMOVE HOOD
5. REMOVE RADIATOR ASSEMBLY
(See page CO−16)
6. REMOVE DRIVE BELT FOR PS PUMP
7. w/ A/C:
REMOVE DRIVE BELT FOR A/C COMPRESSOR
8. REMOVE DRIVE BELT FOR GENERATOR
9. REMOVE FAN WITH FLUID COUPLING AND FAN PUL-
LEYS
(See page CO−5)
10. DISCONNECT PS PUMP FROM ENGINE
HINT:
Put aside the pump, and suspend it.
11. w/ A/C:
REMOVE A/C COMPRESSOR FROM ENGINE
HINT:
Put aside the compressor, and suspend it.
12. REMOVE AIR CLEANER CAP, MAF METER AND RES-
ONATOR
13. REMOVE AIR CLEANER CASE AND FILTER
14. DISCONNECT THESE CABLES:
(a) w/ Cruise control:
Cruise control actuator cable
(b) Accelerator cable
(c) A/T:
Throttle cable
15. DISCONNECT HEATER HOSES
16. DISCONNECT HOSES
Disconnect these hoses:
(1) Brake booster vacuum hose
(2) EVAP hose

Downloaded from www.Manualslib.com manuals search engine CL02J−01
Q06639
Matchmarks
Q06637
CL−16
− CLUTCHCLUTCH UNIT
1996 TOYOTA T100 (RM449U)
REMOVAL
1. REMOVE TRANSMISSION FROM ENGINE
W59: See page MT−3
R150 (2WD): MT−3
R150F (4WD): MT−6
2. REMOVE CLUTCH COVER AND DISC
(a) Place matchmarks on the flywheel and clutch cover.
(b) Loosen each set bolt one turn at a time until spring tension
is released.
(c) Remove the set bolts, and pull off the clutch cover with the
clutch disc.
NOTICE:
Do not drop the clutch disc.
3. REMOVE BOOT, RELEASE BEARING AND FORK
FROM TRANSMISSION
Remove the boot and release bearing together with the fork and
then separate them.

Downloaded from www.Manualslib.com manuals search engine MT0501
Down
ClothCounterclockwise
MT0ER−01
D10948
MT−4
− MANUAL TRANSMISSION (R150, R150F)MANUAL TRANSMISSION UNIT (2WD)
1996 TOYOTA T100 (RM449U)
REMOVAL
1. REMOVE TRANSMISSION WITH ENGINE (See page
EM−65)
2. REMOVE REAR END PLATE
Remove the 4 bolts, nuts and rear end plate.
Torque:37 N·m (380 kgf·cm, 27 ft·lbf)
3. REMOVE STARTER
Remove the 2 bolts and starter.
Torque:39 N·m (400 kgf·cm, 29 ft·lbf)
4. REMOVE TRANSMISSION FROM ENGINE
(a) Remove the 6 transmission mounting bolts from the en-
gine.
Torque:72 N·m (730 kgf·cm, 53 ft·lbf)
(b) Pull out the transmission toward the rear.
5. REMOVE ENGINE REAR MOUNTING
(a) Remove the 4 bolts and engine rear mounting.
Torque:25 N·m (250 kgf·cm, 18 ft·lbf)
(b) Lower the front side of the transmission and remove it
from the front side of the vehicle.

Downloaded from www.Manualslib.com manuals search engine MT04M−03
− MANUAL TRANSMISSION (R150, R150F)MANUAL TRANSMISSION UNIT (2WD)
MT−5
1996 TOYOTA T100 (RM449U)
INSTALLATION
Installation is in the reverse order of removal (See page MT−4).
HINT:
After installation, do the road test.

Downloaded from www.Manualslib.com manuals search engine MT0501
Down
ClothCounterclockwise
MT04O−02
Q06817
Installation
Front
Select Return Spring
Tip of Shift Lever
− MANUAL TRANSMISSION (R150, R150F)MANUAL TRANSMISSION UNIT (4WD)
MT−7
1996 TOYOTA T100 (RM449U)
REMOVAL
1. REMOVE TRANSMISSION SHIFT LEVER
(a) Remove the 4 screws and front console box.
(b) Remove the 4 screws and shift lever boot retainer.
(c) Cover the shift lever cap with a cloth.
(d) Then, pressing down on the shift lever cap, rotate it coun-
terclockwise to remove.
(e) Pull out the shift lever.
HINT:
At the time of installation, please refer to the following item.
Apply MP grease to the tip of the shift lever.
2. REMOVE TRANSFER SHIFT LEVER
Using snap ring pliers, remove the snap ring and pull out the
shift lever.
HINT:
At the time of installation, please refer to the following item.
Apply MP grease to the tip of shift lever.
3. RAISE VEHICLE AND DRAIN TRANSMISSION OIL
Oil grade: API GL−4 or GL−5
Viscosity: SAE 75W−90
Capacity: 2.2 liters (2.3 US qts, 1.9 Imp. qts)
Torque: 37 N·m (380 kgf·cm, 27 ft·lbf)
4. REMOVE FRONT AND REAR PROPELLER SHAFTS
(See page PR−10)
5. DISCONNECT SPEEDOMETER CABLE
6. DISCONNECT BACK−UP LIGHT SWITCH AND 4WD
INDICATOR SWITCH CONNECTORS
7. DISCONNECT CLUTCH RELEASE CYLINDER AND
LINE
Remove the 4 bolts, release cylinder and line.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)

Downloaded from www.Manualslib.com manuals search engine MT04P−04
MT−10
− MANUAL TRANSMISSION (R150, R150F)MANUAL TRANSMISSION UNIT (4WD)
1996 TOYOTA T100 (RM449U)
INSTALLATION
Installation is in the reverse order of removal (See page MT−7).
HINT:
After installation, do the road test.

Downloaded from www.Manualslib.com manuals search engine MT0ES−01
D10954
D10955
MT−4
− MANUAL TRANSMISSION (W59)MANUAL TRANSMISSION UNIT
1996 TOYOTA T100 (RM449U)
REMOVAL
1. REMOVE TRANSMISSION WITH ENGINE (See page
EM−65)
2. REMOVE REAR END PLATE
Remove the 4 bolts, 2 nuts and rear end plate.
Torque: 37 N·m (380 kgf·cm, 27 ft·lbf)
3. REMOVE STARTER
Remove the 2 bolts and starter.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
4. REMOVE TRANSMISSION FROM ENGINE
(a) Remove the 3 transmission mounting bolts from the en-
gine.
Torque: 72 N·m (730 kgf·cm, 53 ft·lbf)
(b) Pull out the transmission toward the rear.
HINT:
At the time of installation, please refer to the following item.
Align the input shaft spline with the clutch disc and install the
transmission to the engine.
5. REMOVE ENGINE REAR MOUNTING
Remove the 4 bolts and engine rear mounting.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)

Downloaded from www.Manualslib.com manuals search engine MT03L−02
− MANUAL TRANSMISSION (W59)MANUAL TRANSMISSION UNIT
MT−5
1996 TOYOTA T100 (RM449U)
INSTALLATION
Installation is in the reverse order of removal (See page MT−4).
HINT:
After installation, do the road test.