3782007 TACOMA from Sep. ’06 Prod. (OM35877U)
The tire pressure warning system
must be initialized when the
specified tire inflation pressure is
changed due to tire replacement.
See “Tire pressure warning
system” on page 199 in Section
1 7.
NOTICE
When the tires must be re-
paired or replaced, have them
repaired or replaced by the
nearest Toyota dealer or au-
thorized tire dealer. Failure to
do so may cause the tire
pressure sensors to be dam-
aged when the tires are re-
moved or installed.
Remove the air pressure sen-
sors before replacing the
tires to prevent the sensors
from being damaged.
LS72010
With a spare tire of the same
wheel type as the installed tires
LS72012
With a spare tire of different
wheel type from the installed
tires
Rotating tires
3822007 TACOMA from Sep. ’06 Prod. (OM35877U)
The tire pressure warning system must
be initialized when the specified tire
inflation pressure is changed due to
wheel replacement. See “Tire pressure
warning system” on page 199 in
Section 1 7.
NOTICE
The use of non genuine wheels will
cause the air pressure sensors to
transmit the electronic code in differ-
ent manner, resulting in the system
failure.
When installing aluminum wheels,
check that the wheel nuts are tight
after driving your vehicle the first 1600
km (1000 miles). Retorque the wheel
nuts to 113 N·m (11.5 kgf·m, 85 ft·lbf).
If you have rotated, repaired, or
changed your tires, check that the
wheel nuts are still tight after driving
1600 km (1000 miles). Retorque the
wheel nuts to 113 N·m (11.5 kgf·m, 85
ft·lbf).
When using tire chains, be careful not
to damage the aluminum wheels.
Use only Toyota wheel nuts and
wrench designed for your aluminum
wheels.
When balancing your wheels, use only
Toyota balance weights or equivalent
and a plastic or rubber hammer.
As with any wheel, periodically check
your aluminum wheels for damage. If
damaged, replace immediately.
Aluminum wheel precautions
