TOYOTA tC 2007 Warranties & Maintenance Guides (in English)

17
Maintenance Log: 2007 tC ‹‹
1Reset the oil replacement reminder (“MAINT REQD”) light after replacing engine oil.2Perform these service items only if you drive primarily under the conditions indicated.3Initial replacement at 100,000 miles/120 months. Replace every 50,000 miles/60 months
thereafter. See page 21 for additional information.
4See page 21 for details.
105,000 Miles or 126 Months
Replace engine oil and oil filter1
Rotate tires
Visuallyinspect brake linings/drums and brake pads/discs
Inspect the following:__ Ball joints and dust covers
__ Brake lines and hoses
__ Drivebelts
__ Drive shaft boots __ Engine coolant
4
Additional Maintenance Items for Special Operating Conditions2
Driving on dirt roads or dusty roads:
Inspect engine air filter
Tighten nuts and bolts on chassis
Dealer Service Verification:
Date:
Mileage:
__Exhaustpipes and mountings
__ Radiator core and condenser
__ Steering gear box
__ Steering linkage and boots

18
›› Maintenance Log: 2007 tC
110,000 Miles or 132 Months
Replace engine oil and oil filter1
Rotate tires
Visually inspect brake linings/drums
and brake pads/discs
Additional Maintenance Items for
Special Operating Conditions2
Driving on dirt roads or dusty roads:
Inspect ball joints and dust covers
Inspect drive shaft boots
Inspect engine air filter
Inspect steering linkage and boots
Tighten nuts and bolts on chassis
115,000 Miles or 138 Months
Replace engine oil and oil filter1
Rotate tires
Visually inspect brake linings/drums
and brake pads/discs
Additional Maintenance Items for
Special Operating Conditions2
Driving on dirt roads or dusty roads:
Inspect ball joints and dust covers
Inspect drive shaft boots
Inspect engine air filter
Inspect steering linkage and boots
Tighten nuts and bolts on chassis
Dealer ServiceVerification:
Date: Mileage: Dealer ServiceVerification:
Date: Mileage:

19
Maintenance Log: 2007 tC ‹‹
1Reset the oil replacement reminder (“MAINT REQD”) light after replacing engine oil.2Perform these service items only if you drive primarily under the conditions indicated.3Required under the terms of the Emission Control Warranty.4Inspect thickness measurement and disc runout.5See page 21 for details.
120,000 Miles or 144 Months
Replace engine oil and oil filter1
Rotate tires
Replace engine air filter
Replace spark plugs3
Inspect the following:__ Ball joints and dust covers
__Brake lines and hoses
__ Brake linings/drums and
brake pads/discs
4
__ Differential oil
__ Drive belts
__ Drive shaft boots__Engine coolant
5
__Engine valve clearance
Additional Maintenance Items for Special Operating Conditions2
Driving on dirt roads or dusty roads:
Tighten nuts and bolts on chassis
Dealer Service Verification:
Date:
Mileage:
__ Exhaust pipes and mountings
__ Fuel lines and connections, fuel
tank band and fuel tank vapor
vent system hoses
__ Fuel tank cap gasket
__ Radiator core and condenser
__ Steering gear box
__ Steering linkage and boots
__ Transmission fluid or oil

20
›› Explanation of Maintenance Items
The following descriptions are provided to give you a better under
standing of the maintenance items that should be performed on your
vehicle. The scheduled maintenance log indicates at which mileage/
time intervals each item should be performed. Please note that many
maintenance items should be performed only by a qualified technician.
For further information on maintenance items you can perform
yourself, see the “Vehicle Maintenance and Care” and “DoIt
Yourself Maintenance” sections of the
Owner’s Manual.
Ball Joints and Dust Covers
Check the suspension and steering linkage ball joints for looseness
and damage. Check all dust covers for deterioration and damage.
Replace any deteriorated or damaged parts. A qualified technician
should perform these operations.
Brake Lines and Hoses
Visually inspect for proper installation. Check for chafing, cracks, dete
rioration and signs of leakage. Replace any deteriorated or damaged
parts. A qualified technician should perform these operations.
BrakeLinings/Drums and Brake Pads/Discs
Check the brake linings (shoes) and drums for scoring, burning, fluid
leakage, broken parts and excessive wear. Check the pads for excessive
wear and the discs for runout, excessive wear and fluid leakage.
Replace any deteriorated or damaged parts. A qualified technician
should perform these operations.
Differential Oil
When performing inspections, check each component for signs of
leakage. If you discover any leakage, have it repaired by a qualified
technician immediately.
Drive Belts
Inspect for cracks, excessive wear and oiliness. Check the belt tension
and adjust if necessary. Replace the belts if they are damaged.

Drive Shaft Boots
Check the drive shaft boots and clamps for cracks, deterioration
and damage. Replace any deteriorated or damaged parts and, if
necessary, repack the grease. A qualified technician should perform
these operations.
Engine Air Filter
Replace at specified intervals. When performing inspections, check
for damage, excessive wear and oiliness, and replace if necessary.
Engine Coolant
Drain and flush the cooling system and refill with an ethyleneglycol
type coolant. Inspect the radiator, condenser and/or intercooler for
leaves, dirt and insects and clean if necessary. Inspect hoses and con
nections for corrosion and leaks. Tighten connections and replace parts
as necessary.A qualified technician should perform these operations.
(For further details, refer to “Radiator, Condenser and Hoses” in the
“Vehicle Maintenance and Care” section of the
Owner’s Manual.)
Note:Your Scion is equipped with Genuine Toyota Super LongLife
Coolant. The replacement intervals for engine coolant recommended
in this booklet are based on replacement with Genuine Toyota Super
LongLife Coolant or similar highquality nonsilicate, nonamine,
nonborate ethyleneglycol coolant with longlife hybrid organic acid
technology (i.e., a combination of low phosphates and organic acids). If
another type of ethyleneglycol coolant is used, replacement intervals
may be different.
Engine Oil and Oil Filter
Replacethe oil filter and drain and refill the engine oil at specified
intervals. For recommended oil grade and viscosity, refer to the
Owner’s Manual.
Engine Valve Clearance
Check for tappet noise and engine vibration and adjust if necessary.
A qualified technician should perform this operation.
Exhaust Pipes and Mountings
Visually inspect the exhaust pipes, muffler and hangers for cracks,
deterioration and damage. Start the engine and listen carefully for
any exhaustgas leakage. Tighten connections or replace parts as
necessary.
21
Explanation of Maintenance Items ‹‹

22
›› Explanation of Maintenance Items
Fuel Lines and Connections, Fuel Tank Band and
Fuel Tank Vapor Vent System Hoses
Visually inspect for corrosion, damage, cracks and loose or leaking
connections. Tighten connections or replace parts as necessary.
Fuel Tank Cap Gasket
Visually inspect for cracks, deterioration and damage and replace
if necessary.
Nuts and Bolts on Chassis and Body
Retighten the seatmounting bolts and front/rear suspension member
retaining bolts to specified torque.
Radiator Core and Condenser
Inspect for damage, debris, dirt, insects and signs of leakage. Have any
problem repaired by a qualified technician.
Spark Plugs
Replace at specified intervals. Install new plugs of the same type
as originallyequipped. A qualified technician should perform this
operation.
Steering Gear Box
Inspect for signs of leakage. If you discover any leakage, have it
repaired immediately by a qualified technician.
Steering Linkage and Boots
With the vehicle stopped, check for excessive freeplay in the steering
wheel. Inspect the linkage for bending and damage and the dust boots
for deterioration, cracks and damage. Replace any damaged parts. A
qualified technician should perform these operations.
Tire Rotation
Tires should be rotated according to the instructions in the Owner’s
Manual
.When rotating tires, check for damage and uneven wear.
Replace if necessary.
Transmission Fluid or Oil
When performing inspections, check each component for signs of
leakage. If you discover any leakage, have it repaired by a qualified
technician immediately.

23
Vehicle Identification ‹‹
Model
Inservice date
Selling dealership
Keynumber
Body style
Mileage at delivery
Selling dealership phone numberVehicle Identification Number

24
›› Notes

25
Notes ‹‹

26
›› Notes