recommended oil TOYOTA tC 2016 Owners Manual (in English)

284
4-2. Maintenance
tC_OM_OM21056U_(U)
General maintenance
Engine compartment
ItemsCheck points
Battery Check the connections.
(P. 308)
Brake fluid Is the brake fluid at the correct
level? (
P. 305)
Engine coolant Is the engine coolant at the cor-
rect level? (
P. 303)
Engine oil Is the engine oil at the correct
level? (
P. 299)
Exhaust system There should not be any fumes or
strange sounds.
Radiator/condenser The radiator and condenser
should be free from foreign
objects. (
P. 305)
Washer fluid Is there sufficient washer fluid?
(P. 312)
Listed below are the general maintenance items that should be per-
formed at the intervals specified in the “Owner’s Warranty Informa-
tion Booklet” or “Owner’s Manual Supplement/Scheduled
Maintenance Guide”. It is recommended that any problem you notice
should be brought to the attention of your Scion dealer or qualified
service shop for advice.

330 4-3. Do-it-yourself maintenance
tC_OM_OM21056U_(U)
■When replacing wheels (U.S.A. only)
The wheels of your vehicle are equipped with tire pressure warning
valves and transmitters that allow the tire pressure warning system to
provide advance warning in the event of a loss in tire inflation pressure.
Whenever wheels are replaced, tire pressure warning valves and trans-
mitters must be installed. (P. 315)
CAUTION
■When replacing wheels
●Do not use wheels that are a different size from those recommended in
the Owner’s Manual, as this may resu lt in a loss of handling control.
●Never use an inner tube in a leaking wheel which is designed for a
tubeless tire. Doing so may result in an accident, causing death or seri-
ous injury.
■When installing the wheel nuts
●Never use oil or grease on the wheel bolts or wheel nuts.
Oil and grease may cause the wheel nuts to be excessively tightened,
leading to bolt or disc wheel damage. In addition, the oil or grease can
cause the wheel nuts to loosen and the wheel may fall off, causing an
accident and resulting in death or serious injury. Remove any oil or
grease from the wheel bolts or wheel nuts.
●Be sure to install the wheel nuts with
the tapered ends facing inward.
Installing the nuts with the tapered
ends facing outward can cause the
wheel to break and eventually cause
the wheel to come off while driving,
which could lead to an accident
resulting in death or serious injury.Tapered
portion

433
6-1. Specifications
6
Vehicle specifications
tC_OM_OM21056U_(U)
Lubrication system
*: The engine oil capacity is a reference quantity to be used when changing
the engine oil. Warm up and turn off the engine, wait more than 5 minutes,
and check the oil level on the dipstick.
■Engine oil selection
“Toyota Genuine Motor Oil” is used in your Scion vehicle. Use Scion
approved “Toyota Genuine Motor Oil” or equivalent to satisfy the fol-
lowing grade and viscosity.
Oil grade: ILSAC GF-5 multigrade engine oil
Recommended viscosity: SAE 0W-20
SAE 0W-20 is the best choice for
good fuel economy and good
starting in cold weather.
If SAE 0W-20 is not available,
SAE 5W-20 oil may be used.
However, it must be replaced
with SAE 0W-20 at the next oil
change.
Oil capacity
(Drain and refill — reference
*)
With filter
Without filter4.6 qt. (4.4 L, 3.9 Imp.qt.)
4.2 qt. (4.0 L, 3.5 Imp.qt.)
Outside temperature

452 6-1. Specifications
tC_OM_OM21056U_(U)
Glossary of tire terminology
Tire related termMeaning
Cold tire inflation pres-
sure Tire pressure when the vehicle has been
parked for three hours or more, or has not
been driven more than 1 mile or 1.5 km under
that condition
Maximum inflation
pressure The maximum cold inflated
pressure to which a
tire may be inflated, s hown on the sidewall of
the tire
Recommended infla-
tion pressure Cold tire inflation pressure recommended by a
manufacturer
Accessory weight The combined weight (in excess of those stan-
dard items which may be replaced) of auto-
matic transmission, power steering, power
brakes, power windows, power seats, radio
and heater, to the extent that these items are
available as factory-installed equipment
(whether installed or not)
Curb weight The weight of a motor vehicle with standard
equipment, including the maximum capacity of
fuel, oil and coolant, and if so equipped, air
conditioning and additional weight optional
engine

492
tC_OM_OM21056U_(U)GAS STATION INFORMATION
Auxiliary catch lever
P. 294Fuel filler doorP. 9 7
Hood release lever
P. 294
Fuel filler door opener P. 9 7Tire inflation pressure
P. 439
Fuel tank capacity
(Reference) 14.5 gal. (55 L,
12.1 Imp.gal.)
Fuel type Unleaded gasoline, Octane Rating of 87 (Research
Octane Number 91) or higher
P. 4 3 2
Cold tire inflation
pressure P. 439
Engine oil capacity
(Drain and refill —
reference)qt. (L, Imp.qt.)
With filter 4.6 (4.4, 3.9)
Without filter 4.2 (4.0, 3.5)
Engine oil type Toyota Genuine Motor Oil or equivalent
Oil grade: ILSAC GF-5 multigrade engine oil.
Recommended viscosity: SAE 0W-20 P. 433