Temperature TOYOTA TERCEL 1996 Service Manual PDF
[x] Cancel search | Manufacturer: TOYOTA, Model Year: 1996, Model line: TERCEL, Model: TOYOTA TERCEL 1996Pages: 1202, PDF Size: 17.43 MB
Page 1145 of 1202
AC1HH-04
AC-16
- AIR CONDITIONINGTROUBLESHOOTING
1168 Author: Date:
1996 TERCEL (RM440U)
TROUBLESHOOTING
PROBLEM SYMPTOMS TABLE
Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely
cause of the problem. Check each part in order. If necessary, replace these parts.
SymptomSuspect AreaSee page
No blower operation
2. Heater main relay
3. Blower motor
4. Blower resistor
5. Blower speed control switchAC-62
AC-55
AC-56
AC-71
No air temperature control1. Inspect engine coolant volume
2. A/C control lever-
AC-72
No compressor operation
1. Refrigerant volume
2. A/C Fuse
3. Magnetic clutch relay
4. Magnetic clutch
5. Compressor
6. Pressure switch
7. Heater main relay
8. A/C switch
9. Blower speed control switch
10.A/C amplifier
11. Thermistor
12.Wiring and wiring connectionsAC-3
-
AC-63
AC-40
AC-36
AC-59
AC-59
AC-62
AC-71
AC-66
AC-57
-
Compressor operates intermittently
1. Refrigerant volume
2. Refrigerant cooling system
3. Pressure switch
4. A/C amplifier
5. Thermistor
6. Wiring and wiring connectionsAC-3
-
AC-59
AC-66
AC-57
-
No condenser fan operation
1. Condenser fan fuse
2. Engine main relay
3. Cooling fan relay No.1
4. Cooling fan relay No.2
5. Cooling fan relay No.3
6. Magnetic clutch relay
7. Condenser fan motor
8. Pressure switch
9. Water temperature switch
10.A/C amplifier-
CO-33
AC-64
AC-64
AC-64
AC-63
AC-65
AC-59
-
AC-66
No cool air comes out
1. Refrigerant volume
2. Drive belt
3. Magnetic clutch
4. Compressor
5. Refrigeration controlAC-3
AC-18
AC-40
AC-36
-
Cool air comes out intermittently
1. Refrigerant Volume
2. Drive belt
3. A/C amplifier
4. Expansion valve
5. Evaporator
6. Thermistor
7. Wiring and wiring connectionAC-3
AC-18
AC-66
AC-54
AC-52
AC-57
-
Cool air comes out only at high engine rpm
1. Refrigerant volume
2. Drive belt
3. Inspect refrigerant linesAC-3
AC-18
-
Page 1187 of 1202
AC2XO-02
AC0175
Thermometer
Ice
ThermistorMore than
10 cm (3.94 in.)Ohmmeter
AC0548
5,500
5,000
4,500
4,000
3,500
Temperature
Resistance (W)
-1
300
321
342
363
384
40°F 5°C
AC-58
- AIR CONDITIONINGTHERMISTOR
1996 TERCEL (RM440U)
INSPECTION
1. REMOVE THERMISTOR (See page AC-27)
2. INSPECT THERMISTOR RESISTANCE
(a) Place the thermistor in cold water. While changing tem-
perature of the water, measure resistance at the connec-
tor and at the same time, measure temperature of water
with a thermometer.
(b) Compare the 2 readings on the chart.
If resistance value is not as specified, replace the thermistor.
3. REINSTALL THERMISTOR (See page AC-27)
Page 1195 of 1202
AC1D0-04
Z14427
Wire harness side
1
23
4
5
10 9 8 6
71112
Z14428
1 2 3 4 5
1098
6 7 11 12 From back side AC-66
- AIR CONDITIONINGAIR CONDITIONING AMPLIFIER
1218 Author: Date:
1996 TERCEL (RM440U)
AIR CONDITIONING AMPLIFIER
ON-VEHICLE INSPECTION
1. w/ Power Steering:
INSPECT A/C AMPLIFIER CIRCUIT
(a) Disconnect the connector from amplifier and inspect the
connector on wire harness side, as shown in the chart.
Test conditions:
Turn ignition switch to ON
Blower speed control switch at ºHIº position
A/C switch ON
Temperature control lever at MAX COOL
Tester connectionConditionSpecified condition
5 - GroundConstantContinuity
1 - GroundConstantContinuity
6 - GroundConstantContinuity
1 - ECM terminal AC1ConstantContinuity
6 - ECM terminal ACTConstantContinuity
8 - 12ConstantApprox. 1.5 kW at 25°C (77°F)
7 - GroundA/C switch ONBattery positive voltage
7 - GroundA/C switch OFFNo voltage
9 - GroundA/C switch ONBattery positive voltage
9 - GroundA/C switch OFFNo voltage
11 - GroundConstantBattery positive voltage
If circuit is as specified, try replacing the amplifier with a new
one. If the circuit is not as specified, inspect the circuits con-
nected to other parts.
(b) Connect the connector to A/C amplifier and inspect the
wire harness connector from the back side, as shown in
the chart below.
Tester conditions:
Running engine at idle speed
Blower speed control switch at HI position
Temperature control lever at MAX COOL
position
A/C switch ON
Set manifold gauge set
Page 1196 of 1202
Z11344
1234
5
10 9 8 6
7 Wire harness side
N10516
1 2 3 4
5 10 9 8
6 7
From back side
- AIR CONDITIONINGAIR CONDITIONING AMPLIFIER
AC-67
1219 Author: Date:
1996 TERCEL (RM440U)Tester connection
ConditionSpecified condition
2 - GroundRefrigerant pressure 196 - 3,140 kPaBattery positive voltage
2 - GroundRefrigerant pressure less than
196 kPa or more than 3,140No voltage
If circuit is as specified, try replacing the amplifier with a new
one. If the circuit is not as specified, inspect the circuits con-
nected to other parts.
2. w/o Power steering:
INSPECT A/C AMPLIFIER
(a) Disconnect the connector from amplifier and inspect the
connector on wire harness side, as shown in the chart.
Test conditions:
Turn ignition switch to ON
Blower speed control switch at HI position
A/C switch ON
Temperature control lever at MAX COOL
Test connectionConditionSpeed condition
4 - GroundConstantContinuity
6 - ECM terminal ACTConstantContinuity
8 - ECM terminal AC1ConstantContinuity
6 - 10ConstantApprox. 1.5 kW at 25°C (77°F)
5 - GroundA/C switch ONBattery positive voltage
5 - GroundA/C switch OFFNo voltage
9 - GroundIgnition switch ONBattery positive voltage
9 - GroundIgnition switch ONNo voltage
7 - GroundA/C switch ONBattery positive voltage
7 - GroundA/C switch OFFNo voltage
If circuit is as specified, try replacing the amplifier with a new
one. If the circuit is not as specified, inspect the circuits con-
nected to other parts.
(b) Connect the connector to amplifier and inspect the wire
harness connector from back side, as shown in the chart
below.
Test conditions:
Running engine at idle speed
Blower speed control switch at HI position
Temperature control lever at MAX COOL
position
A/C switch ON
Set manifold gauge set