oil filter TOYOTA VENZA 2010 Owners Manual (in English)

492 4-3. Do-it-yourself maintenance
VENZA_U (OM73007U)
Vehicles with smart key system:
While pressing the trip meter reset button, set the “ENGINE START
STOP” switch to IGNITION ON mode (but do not start the engine
because otherwise the reset mode will be canceled). Continue to
press and hold the trip meter reset button until the trip meter dis-
plays “000000”.
Vehicles without smart key system:
While pressing the trip meter reset button, set the engine switch to
“ON” position (but do not start the engine because otherwise the
reset mode will be canceled). Continue to press and hold the trip
meter reset button until the trip meter displays “000000”.
CAUTION
■Used engine oil
● Used engine oil contains potentially harmful contaminants which may
cause skin disorders such as inflammation or skin cancer, so care should
be taken to avoid prolonged and repeated contact. To remove used engine
oil from your skin, wash thoroughly with soap and water.
● Dispose of used oil and filters only in a safe and acceptable manner. Do
not dispose of used oil and filters in household trash, in sewers or onto the
ground.
Call your Toyota dealer, service station or auto parts store for information
concerning recycling or disposal.
● Do not leave used engine oil within the reach of children.
STEP3

606 6-1. Specifications
VENZA_U (OM73007U)
Lubrication system
2GR-FE engine
■Engine oil selection
“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Use Toy-
ota approved “Toyota Genuine Motor Oil” or equivalent to satisfy the
following grade and viscosity.
Oil grade: ILSAC multigrade engine oil
Recommended viscosity: SAE 5W-30
SAE 5W-30 is the best choice for
good fuel economy and good
starting in cold weather.
If SAE 5W-30 is not available,
SAE 10W-30 oil may be used.
However, it should be replaced
with SAE 5W-30 at the next oil
change.
The 5W portion of the oil viscosity rating indicates the characteristic of the
oil which allows cold startability. Oils with a lower value before the W allow
for easier starting of the engine in cold weather.
The 30 in 5W-30 indicates the oil viscosity when the oil is at its operating
temperature. An oil with a higher viscosity may be better suited if the vehi-
cle is operated at high speeds, or under extreme load conditions.
Oil capacity
(Drain and refill —
reference)
With filter
Without filter6.4 qt. (6.1 L, 5.4 lmp.qt.)
6.0 qt. (5.7 L, 5.0 lmp.qt.)
Outside temperature

607
6-1. Specifications
6
Vehicle specifications
VENZA_U (OM73007U)
How to read oil container label:
The ILSAC (International Lubric
ant Standardization and Approval
Committee) Certification Mark is added to some oil containers to help
you select the oil you should use.
1AR-FE engine ■Engine oil selection
“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Use Toy-
ota approved “Toyota Genuine Motor Oil” or equivalent to satisfy the
following grade and viscosity.
Oil grade: ILSAC multigrade engine oil
Recommended viscosity: SAE 5W-20 or 0W-20
Oil capacity
Drain and refill
(Reference)
With filter
Without filter4.7 qt. (4.4 L, 3.9 lmp.qt.)
4.2 qt. (4.0 L, 3.5 lmp.qt.)

664
VENZA_U (OM73007U)
GAS STATION INFORMATION
Auxiliary catch leverP. 482Fuel filler doorP. 9 2
Hood lock release lever
P. 482
Fuel filler door opener
P. 9 2
Tire inflation pressure
P. 6 1 3
Fuel tank capacity
(Reference)17.7 gal. (67 L, 14.7 lmp.gal.)
Fuel typeUnleaded gasoline only P. 93, 605
Cold tire inflation
pressureP. 6 1 3
Engine oil capacity
(Drain and refill —
reference)qt. (L, Imp.qt.)
2GR-FE engine 1AR-FE engine
With filter 6.4 (6.1, 5.4) 4.7 (4.4, 3.9)
Without filter 6.0 (5.7, 5.0) 4.2 (4.0, 3.5)
Engine oil type
“Toyota Genuine Motor Oil” or equivalent
Oil grade: ILSAC multigrade engine oil
Recommended oil viscosity P. 606
2GR-FE engine: SAE 5W-30
1AR-FE engine: SAE 5W-20 or 0W-20