bulb TOYOTA VENZA 2016 Owners Manual

1
2
3
4
5
6
7
5
VENZA_OM_OM73030U_(U) 3-3. Using the interior lights
Interior lights list .................. 430
• Personal/interior light main
switch ................................ 431
• Personal/interior lights
and luggage compartment
light ................................... 432
3-4. Using the storage features
List of storage features ....... 434
• Glove box.......................... 435
• Console boxes .................. 436
• Overhead console............. 438
• Cup holders ...................... 439
• Bottle holders .................... 441
• Auxiliary boxes.................. 442
3-5. Other interior features
Sun visors ........................... 445
Vanity mirror........................ 446
Power outlets ...................... 447
Seat heaters........................ 449
Armrest ............................... 451
Assist grips (folding type) .... 452
Floor mats ........................... 453
Luggage compartment
features ............................. 455
Garage door opener............ 457
Compass ............................. 464 4-1. Maintenance and care
Cleaning and protecting the
vehicle exterior ................. 470
Cleaning and protecting the
vehicle interior .................. 473
4-2. Maintenance
Maintenance
requirements .................... 476
General maintenance ......... 479
Emission inspection and
maintenance (I/M)
programs .......................... 482
4-3. Do-it-yourself maintenance
Do-it-yourself service
precautions....................... 483
Hood ................................... 487
Positioning a floor jack ....... 489
Engine compartment .......... 491
Tires ................................... 506
Tire inflation pressure ......... 513
Wheels ............................... 517
Air conditioning filter ........... 520
Key battery ......................... 523
Checking and
replacing fuses ................. 527
Light bulbs .......................... 5374
Maintenance and care

1852-1. Driving procedures
2
When driving
VENZA_OM_OM73030U_(U) Tur n signal lever
■ Turn signals can be operated when
Vehicles with smart key system
The “ENGINE START STOP” switch is in IGNITION ON mode.
Vehicles without smart key system
The engine switch is in the “ON” position.
■ If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out. Right turn
Left turn
Move and hold the lever
partway to signal a lane
change. The right hand signal will flash
until you release the lever.
Move and hold the lever
partway to signal a lane
change. The left hand signal will flash
until you release the lever.

Maintenance and care
4
469
VENZA_OM_OM73030U_(U) 4-1. Maintenance and care
Cleaning and protecting
the vehicle exterior ......... 470
Cleaning and protecting
the vehicle interior .......... 473
4-2. Maintenance
Maintenance
requirements .................. 476
General maintenance....... 479
Emission inspection
and maintenance (I/M)
programs........................ 482
4-3. Do-it-yourself maintenance
Do-it-yourself service
precautions .................... 483
Hood ................................ 487
Positioning a floor jack ..... 489
Engine compartment ........ 491
Tires ................................. 506
Tire inflation pressure ...... 513
Wheels ............................. 517
Air conditioning filter......... 520
Key battery ....................... 523
Checking and
replacing fuses ............... 527
Light bulbs........................ 537

5364-3. Do-it-yourself maintenance
VENZA_OM_OM73030U_(U) ■ After a fuse is replaced
● If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. (  P. 537)
● If the replaced fuse blows again, have the vehicle inspected by your
Toyota dealer.
■ If there is an overload in the circuits
The fuses are designed to blow, protecting the wiring harness from damage.
CAUTION■ To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage to the vehicle, and possibly a fire or
injury.
● Never use a fuse of a higher amperage rating than indicated, or use any
other object in place of a fuse.
● Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
● Do not modify fuses or the fuse box.
NOTICE■ Before replacing fuses
Have the cause of electrical overload determined and repaired by your
Toyota dealer.

5374-3. Do-it-yourself maintenance
4
Maintenance and care
VENZA_OM_OM73030U_(U) Light bulbs You may replace the following bulbs yourself. The difficulty level of
replacement varies depending on the bulb. If necessary bulb
replacement seems difficult to perfor m, contact your Toyota dealer.
For more information about replacing other light bulbs, contact your
Toyota dealer.
■ Prepare a replacement light bulb.
Check the wattage of the light bulb being replaced. (  P. 624)
■ Turn the power back door main switch off. (vehicles with
power back door)
 P. 5 9
■ Front bulb locations
Vehicles with halogen headlights Headlight low beam
Headlight high beam
Front turn signal/parking light Front fog light Front side marker lightDaytime running right

5384-3. Do-it-yourself maintenance
VENZA_OM_OM73030U_(U) Vehicles with discharge headlights
■ Rear bulb locations Front fog lightFront turn
signal light
Front side marker light
Stop/tail and rear side
marker lights
Back-up light Tail light
License plate lightRear turn signal light

5394-3. Do-it-yourself maintenance
4
Maintenance and care
VENZA_OM_OM73030U_(U) Replacing light bulbs
■ Headlight low beams (vehicle s with halogen headlights)
Turn the bulb base counterclock-
wise.
Unplug the connector while
pushing the lock release.STEP 1
STEP 2

5404-3. Do-it-yourself maintenance
VENZA_OM_OM73030U_(U) Replace the light bulb, and install
the bulb base. Align the 3 tabs on the light bulb
with the mounting, and insert.
Turn and secure the bulb base. Shake the bulb base gently to
check that it is not loose, turn the
headlights on once and visually
confirm that no light is leaking
through the mounting.STEP 3
STEP 4

5414-3. Do-it-yourself maintenance
4
Maintenance and care
VENZA_OM_OM73030U_(U) ■ Headlight high beams and d aytime running lights (vehicles
with halogen headlights)
Unplug the connector while
pushing the lock release.
Turn the bulb base counterclock-
wise.
Replace the light bulb, and install
the light bulb. Align the 3 tabs on the light bulb
with the mounting, and insert.STEP 1
STEP 2
STEP 3

5424-3. Do-it-yourself maintenance
VENZA_OM_OM73030U_(U) Turn and secure the bulb base.
Install the connector. Shake the bulb base gently to check that it is not loose, turn the
headlights on once and visually confirm that no light is leaking
through the mounting. STEP 4
STEP 5