oil type TOYOTA xB 2008 Warranties & Maintenance Guides (in English)

Drive Shaft Boots
Check the drive shaft boots and clamps for cracks, deterioration and damage. Replace
any deteriorated or damaged parts and, if necessary, repack the grease. A qualified
technician should perform these operations.
Engine Air Filter
Replace at specified intervals. When performing inspections, check for damage,
excessive wear and oiliness, and replace if necessary.
Engine Coolant
Drain and flush the cooling system and refill with an ethylene-glycol type coolant.
Inspect the radiator, condenser and/or intercooler for leaves, dirt and insects, and
clean if necessary. Inspect hoses and connections for corrosion and leaks. Tighten
connections and replace parts as necessary. A qualified technician should perform
these operations. (For further details, refer to “Radiator, Condenser and Hoses” in the
“Vehicle Maintenance and Care” section of the
Owner’s Manual.)
Note:
Your Scion is equipped with Genuine Toyota Super Long-Life Coolant. The
replacement intervals for engine coolant recommended in this booklet are based on
replacement with Genuine Toyota Super Long-Life Coolant or similar high-quality
non-silicate, non-amine, non-borate ethylene-glycol coolant with long-life hybrid
organic acid technology (i.e., a combination of low phosphates and organic acids).
If another type of ethylene-glycol coolant is used, replacement intervals may be
different.
Engine Oil and Oil Filter
Replace the oil filter and drain and refill the engine oil at specified intervals. For
recommended oil grade and viscosity, refer to the
Owner’s Manual.
Engine Valve Clearance
Check for tappet noise and engine vibration and adjust if necessary. A qualified
technician should perform this operation.
Exhaust Pipes and Mountings
Visually inspect the exhaust pipes, muffler and hangers for cracks, deterioration and
damage. Start the engine and listen carefully for any exhaust gas leakage. Tighten
connections or replace parts as necessary.
xB
SCHEDULED
MAINTENANCE
GUIDE 2008
EXPLANATION OF MAINTENANCE ITEMS
21

Fuel Lines and Connections, Fuel Tank Band and
Fuel Tank Vapor Vent System Hoses
Visually inspect for corrosion, damage, cracks and loose or leaking connections.
Tighten connections or replace parts as necessary.
Fuel Tank Cap Gasket
Visually inspect for cracks, deterioration and damage and replace if necessary.
Nuts and Bolts on Chassis and Body
Re-tighten the seat-mounting bolts and front/rear suspension member retaining bolts
to specified torque.
Radiator Core and Condenser
Inspect for damage, debris, dirt, insects and signs of leakage. Have any problem
repaired by a qualified technician.
Spark Plugs
Replace at specified intervals. Install new plugs of the same type as originally
equipped. A qualified technician should perform this operation.
Steering Gear Box
Inspect for signs of leakage. If you discover any leakage, have it repaired immediately
by a qualified technician.
Steering Linkage and Boots
With the vehicle stopped, check for excessive freeplay in the steering wheel. Inspect
the linkage for bending and damage and the dust boots for deterioration, cracks and
damage. Replace any damaged parts. A qualified technician should perform these
operations.
Tire Rotation
Tires should be rotated according to the instructions in theOwner’s Manual. When
rotating tires, check for damage and uneven wear. Replace if necessary.
Transmission Fluid or Oil
When performing inspections, check each component for signs of leakage. If you
discover any leakage, have it repaired by a qualified technician immediately.
xB
SCHEDULED
MAINTENANCE
GUIDE 2008
EXPLANATION OF MAINTENANCE ITEMS
22