tires TOYOTA xB 2010 Accessories, Audio & Navigation (in English)

ADVANCED FUNCTIONS
118
V573_E

4. Touch either the or to
adjust the direction of the current ve-
hicle position mark.
5. Touch “Enter”.
The map screen will be displayed. TIRE CHANGE CALIBRATION
The tire change calibration function will
be used when replacing the tires. This
function will adjust the miscalculation
caused by the circumference difference
between the old and new tires. If this
procedure is not performed when the
tires are replaced, the current vehicle
position mark may be incorrectly dis-
played.

To perform a distance calibration
procedure, touch “Tire Change” on
the “Calibration” screen.
The message appears and the quick
distance calibration is automatically
started. A few seconds later, a map
screen will be displayed.

OTHER FUNCTIONS
121
V573_E

INFORMATION ITEMS
“ENGINE OIL”: Replace engine oil
“OIL FILTER”: Replace engine oil filter
“ROTATION”: Rotate tires
“TIRES”: Replace tires
“BATTERY”: Replace battery
“BRAKE PAD”: Replace brake linings
“WIPERS”: Replace wiper blades
“LLC”: Replace engine coolant
“BRAKE OIL”: Replace brake fluid
“ATF”: Replace ATF (Automatic Trans-
mission Fluid)
“SERVICE”: Scheduled maintenance
“AIR FILTER”: Replace air filter
“PERSONAL”: New information items
can be created separately from provided
ones

4. Input the conditions.
Notice of “Date”: The next maintenance
date can be input.
Notice of “Distance”: The driving dis-
tance until the next maintenance check
can be input.
“Delete”: To cancel the date and dis-
tance conditions.
“Reset”: To reset the date and distance
conditions.
5. Touch “OK”.
The screen then returns to the “Mainte-
nance” screen.

INFORMATION
z For scheduled maintenance in-
formation, please refer to the
“Scheduled Maintenance Guide”
or “Owner’s Manual Supple-
ment”.
z Depending on driving or road
conditions, the actual date and
distance may differ from the
stored date and distance in the
system.

APPENDIX
271
V573_E

(a) Accurate current vehicle position
may not be shown in the following
cases:
z When driving on a small angled
Y-shaped road.
z When driving on a winding road.
z When driving on a slippery road
such as in sand, gravel, snow, etc.
z When driving on a long straight road.
z When freeway and surface streets
run in parallel.
z After moving by ferry or vehicle car-
rier.
z When a long route is searched dur-
ing high speed driving.
z When driving without setting the
current position calibration correctly.
z After repeating a change of direction
by going forward and backward, or
turning on a turntable in the parking
lot.
z When leaving a covered parking lot
or parking garage.
z When a roof carrier is installed.
z When driving with tire chains in-
stalled.
z When the tires are worn.
z After replacing a tire or tires.
z When using tires that are smaller or
larger than the factory specifications.
z When the tire pressure in any of the
four tires is not correct.

INFORMATION
If your vehicle cannot receive GPS
signals, you can correct the current
position manually. For information
on setting the current position cali-
bration, see page 117.

(b) Inappropriate route guidance may
occur in the following cases:
z When turning at an intersection off
the designated route guidance.
z If you set more than one destination
but skip any of them, auto reroute
will display a route returning to the
destination on the previous route.
z When turning at an intersection for
which there is no route guidance.
z When passing through an intersec-
tion for which there is no route
guidance.
z During auto reroute, the route guid-
ance may not be available for the
next turn to the right or left.
z It may take a long time to operate
auto reroute during high speed driv-
ing. In auto reroute, a detour route
may be shown.
z After auto reroute, the route may not
be changed.
z An unnecessary U-turn may be
shown or announced.
z A location may have multiple names
and the system will announce one or
more.
z Some routes may not be searched.
z If the route to your destination in-
cludes gravel, unpaved roads or al-
leys, the route guidance may not be
shown.
z Your destination point might be
shown on the opposite side of the
street.
z When a portion of the route has
regulations prohibiting the entry of
the vehicle that vary by time or sea-
son or other reasons.
z The road and map data stored in
your navigation system may not be
complete or may not be the latest
version.

APPENDIX
272
V573_E
After replacing a tire, implement the
operation described in the “TIRE
CHANGE CALIBRATION”. (See page
118.)
This navigation system uses tire turning
data and is designed to work with fac-
tory-specified tires for your vehicle.
Installing tires that are larger or smaller
than the originally equipped diameter
may cause inaccurate display of the ve-
hicle’s position. The tire pressure also
affects the diameter of the tires so
please make sure the tire pressure of all
four tires are correct. In order to provide you with as accurate
map information as possible, we are
always gathering information such as on
road repairs and carrying out on-site
investigations. However, the names of
roads, streets, facilities, and their loca-
tions frequently change. In some
places, construction on roads may be in
progress. For that reason, information
on some areas in this system might be
different from the actual location.
The map database is normally updated
once a year. Contact your dealer for
information about the availability and
pricing of an update.

INFORMATION
Do not attempt to store audio or
other data files in the map SD mem-
ory card.

Map database information
and u
pdates —