stop start TOYOTA xB 2010 (in English) User Guide

199
4. Start your engine in the normal way.After starting, run it at about 2000 rpm
for several minutes with the accelerator
pedal lightly depressed.
5. Carefully disconnect the cables in the exact reverse order: the negative cable
and then the positive cable.
If the cause of your battery discharging is
not apparent (for example, lights left on),
you should have it checked at your Scion
dealer.
If the first start attempt is not success-
ful...
Check that the clamp on the jumper
cables are tight. Recharge the discharged
battery with the jumper cables connected
for several minutes and restart your en-
gine in the normal way.
If the another attempt is not successful,
the battery may be depleted. Have it
checked at your Scion dealer. If your engine stalls while driving...
1. Reduce your speed gradually, keeping a straight line. Move cautiously off the
road to a safe place.
2. Turn on your emergency flashers.
3. Try starting the engine again.
If the engine will not start, see “If your
vehicle will not start” on page 196.
CAUTION
If the engine is not running, the pow-
er assist for the brakes and steering
will not work so steering and braking
will be much harder than usual.
If your vehicle overheats
If your engine coolant temperature
gauge indicates overheating, if you ex-
perience a loss of power, or if you hear
a loud knocking or pinging noise, the
engine has probably overheated. You
should follow this procedure...
1. Pull safely off the road, stop the ve- hicle and turn on your emergency
flashers. Put the transmission in “P”
(automatic) or neutral (manual) and ap-
ply the parking brake. Turn off the air
conditioning if it is being used.
2. If coolant or steam is boiling out of the radiator or reservoir, stop the engine.
Wait until the steam subsides before
opening the hood. If there is no coolant
boiling over or steam, leave the engine
running and make sure the electric
cooling fan is operating. If it is not,
turn the engine switch off.
CAUTION
To help avoid personal injury, keep
the hood closed until there is no
steam. Escaping steam or coolant is
a sign of very high pressure.
If your engine stalls while
driving

201
CAUTION
When jacking, be sure to observe
the following to reduce the possi-
bility of death or serious injury:
Follow jacking instructions.
 Do not put any part of your
body under the vehicle sup-
ported by the jack. Otherwise,
death or serious injury may oc-
cur.
 Do not start or run the engine
while your vehicle is supported
by the jack.
 Stop the vehicle on a level firm
ground, firmly set the parking
brake and put the transmission
in “P” (automatic) or reverse
(manual). Block the wheel diag-
onally opposite to the one be-
ing changed if necessary.
Make sure to set the jack prop-
erly in the jack point. Raising
the vehicle with jack improper-
ly positioned will damage the
vehicle or may allow the ve-
hicle to fall off the jack and
cause death or serious injury.
 Never get under the vehicle
when the vehicle is supported
by the jack alone.
 Use the jack only for lifting
your vehicle during wheel
changing.
 Do not raise the vehicle with
someone in the vehicle.
 When raising the vehicle, do
not place any objects on top
of or underneath the jack.
 Raise the vehicle only high
enough to remove and change
the tire.NOTICE
Do not continue driving with a
deflated tire. Driving even a short
distance can damage a tire and
wheel beyond repair.

237
When jacking up your vehicle with the
floor jack, position the jack correctly as
shown in the illustration.CAUTION
When jacking, be sure to observe the
following to reduce the possibility of
personal injury:
Follow jacking instructions.
Do not put any part of your body
under the vehicle supported by a
floor jack. Personal injury may oc-
cur.
Do not start or run the engine while
your vehicle is supported by the
floor jack.
Stop the vehicle on a level firm
ground, firmly set the parking brake
and put the transmission in “P”
(automatic) or reverse (manual).
Block the wheels on the opposite
side of the floor jack up point if
necessary.
Make sure to set the floor jack
properly in the jack point. Raising
the vehicle with floor jack improper-
ly positioned will damage the ve-
hicle or may allow the vehicle to
fall off the floor jack and cause
personal injury.
Never get under the vehicle when
the vehicle is supported by the
floor jack alone; use vehicle sup-
port stands.
Do not raise the vehicle with some-
one in the vehicle.
When raising the vehicle, do not
place any objects on top of or un-
derneath the floor jack.
NOTICE
Make sure to place the floor jack cor-
rectly, or your vehicle may be dam-
aged.

267
26. HLP MAIN 50 A: “H−LP LH LO”, “H −
LP RH LO”, “H −LP LH HI” and “H −LP
RH HI” fuses
27. P/I 50 A: “EFI MAIN”, “HORN” and
“IG2” fuses
28. EPS 60 A: Electric power steering sys-
tem
29. ALT 120 A: “RDI FAN”, “CDS FAN”,
“ABS NO.1”, “ABS NO.3”, “HTR”,
“AM1”, “DOOR”, “STOP”, “FR DOOR”,
“RR DOOR”, “RL DOOR”, “OBD”,
“ACC −B”, “DEF”, ”TAIL” and “PANEL”
fuses
30. POWER 30 A: Power windows
31. DEF 30 A: Rear window defogger
32. PWR SEAT 30 A: No circuit
33. TAIL 10 A: Parking lights, tail lights,
side maker lights, gauges and meter,
licence plate light and multiport fuel
injection system/ sequential multiport
fuel injection system
34. PANEL 7.5 A: Instrument cluster lights,
instrument panel lights, gauges and
meters
35. FR DOOR 20 A: Power windows
36. RL DOOR 20 A: Power windows
37. RR DOOR 20 A: Power windows
38. SUNROOF 20 A: No circuit
39. CIG 15 A: Cigarette lighter 40. ACC 7.5 A:
Power rear view mirrors,
shift lock control system and audio
system
41. MIR HTR 10 A: Multiport fuel injection
system/ s equential multiport fuel injec-
tion system
42. IGN 7.5 A: Multiport fuel injection sys-
tem/ sequential multiport fuel injection
system, SRS airbag system and steer-
ing lock system
43. METER 7.5 A: Gauges and meters
44. HTRIG 10 A: Air conditioning system
45. WIPER 25 A: Front windshield wiper
46. RR WIPER 15 A: Rear windshield wip-
er
47. WASHER 15 A: Washer
48. ECUIG NO.1 10 A: Multiport fuel in-
jection system/ sequential multiport fuel
injection system, electric power steer-
ing, electric cooling fan, anti −lock brake
system, vehicle stability control system,
shift lock control system and audio
system
49. ECU IG NO.2 10 A: Back−up light,
emergency flasher, starting system, air
conditioning system and rear window
defogger
50. OBD 7.5 A: On−board diagnosis sys-
tem 51. STOP 10 A:
Stop lights, high mounted
stoplight, multiport fuel injection sys-
tem/ sequential multiport fuel injection
system and anti −lock brake assist sys-
tem
52. DOOR 25 A: Power door lock system
53. ACCB 25 A: “CIG” and “ACC” fuses
54. FR FOG 15 A: Front fog lights
55. AM1 7.5 A: Starting system and shift
lo

ck control system