parking brake VAUXHALL COMBO 2015 User Guide
[x] Cancel search | Manufacturer: VAUXHALL, Model Year: 2015, Model line: COMBO, Model: VAUXHALL COMBO 2015Pages: 183, PDF Size: 4.28 MB
Page 150 of 183

148Vehicle careTyre repair kit
Minor damage to the tyre tread can be repaired with the tyre repair kit.
Do not remove foreign bodies from
the tyres.
Tyre damage exceeding 4 mm or that
is at tyre's sidewall cannot be repaired with the tyre repair kit.9 Warning
Do not drive faster than 50 mph.
Do not use for a lengthy period.
Steering and handling may be
affected.
If you have a flat tyre:
Apply the parking brake and engage
first or reverse gear.
The tyre repair kit may be located
under the front seat, in the glovebox,
or on the right side of the load
compartment behind a cover.
1. Take the tyre repair kit from the vehicle.
2. Remove the compressor.
3. Set the compressor upright near the tyre.
4. Unscrew valve cap from defective
tyre.5. Screw the flexible filler hose onto the tyre valve.
6. The switch on the compressor must be set to J.
7. Connect the compressor plug to the power outlet or cigarette
lighter socket.
To avoid discharging the battery,
we recommend running the
engine.
Page 152 of 183

150Vehicle care
Notice
The driving characteristics of the repaired tyre are severely affected,therefore have this tyre replaced.
If unusual noise is heard or the
compressor becomes hot, turn
compressor off and allow to cool.
Note the expiry date of the kit. After
this date its sealing capability is no
longer guaranteed. Pay attention to
storage information on sealant
bottle.
Replace the used sealant bottle. Dispose of the bottle as prescribed
by applicable laws.
The compressor and sealant can be used from approx. -20 °C.
Replacing the sealant canister
To replace the sealant canister:
1. Disconnect the compressor air hose.
2. Turn the canister anticlockwise to lift it out.
3. Insert the new canister and turn it clockwise.
4. Connect the compressor air hose to the canister and fit the flexible
filler tube into its allocated space.
Wheel changing Some vehicles are equipped with a
tyre repair kit instead of a spare wheel 3 148.
Make the following preparations and
observe the following information:
■ Park the vehicle on a level, firm and
non-skid surface. The front wheels
must be in the straight-ahead
position.
■ Apply the parking brake and engage first or reverse gear.
■ Remove the spare wheel 3 152.
■ Never change more than one wheel
at once.
■ Use the jack only to change wheels
in case of puncture, not for
seasonal winter or summer tyre
change.
■ The jack is maintenance-free.
■ If the ground on which the vehicle is standing is soft, a solid board
(max. 1 cm thick) should be placed
under the jack.
■ No people or animals may be in the
vehicle when it is jacked-up.
■ Never crawl under a jacked-up vehicle.
Page 157 of 183

Vehicle care155Jump starting
Do not start with quick charger.
A vehicle with a discharged battery
can be started using jump leads and the battery of another vehicle.9 Warning
Be extremely careful when starting
with jump leads. Any deviation
from the following instructions can
lead to injuries or damage caused
by battery explosion or damage to the electrical systems of both
vehicles.
9 Warning
Avoid contact of the battery with
eyes, skin, fabrics and painted
surfaces. The fluid contains
sulphuric acid which can cause
injuries and damage in the event
of direct contact.
■ Never expose the battery to naked flames or sparks.
■ A discharged battery can alreadyfreeze at a temperature of 0 °C.
Defrost the frozen battery before
connecting jump leads.
■ Wear eye protection and protective
clothing when handling a battery.
■ Use a booster battery with the same voltage (12 Volts). Its
capacity (Ah) must not be much less than that of the discharged
battery.
■ Use jump leads with insulated terminals and a cross section of at
least 16 mm 2
(25 mm 2
for diesel
engines).
■ Do not disconnect the discharged battery from the vehicle.
■ Switch off all unnecessary electrical
consumers.
■ Do not lean over the battery during jump starting.
■ Do not allow the terminals of one lead to touch those of the other
lead.■ The vehicles must not come into contact with each other during the
jump starting process.
■ Apply the parking brake, transmission in neutral.
Lead connection order:
1. Connect the red lead to the positive terminal of the booster
battery.
2. Connect the other end of the red lead to the positive terminal of the
discharged battery.
Page 180 of 183

178
HHalogen headlights ....................134
Hand brake ................................. 114
Hazard warning flashers ..............91
Headlight flash ............................. 89
Headlight range adjustment ........90
Headlights..................................... 89
Headlights when driving abroad ..90
Head restraint adjustment .............8
Head restraints ............................ 32
Heated mirrors ............................. 28
Heated rear window ..................... 31
Heating ........................................ 35
Heating and ventilation system ...96
High beam ............................. 80, 89
Hill start assist ...................... 76, 115
Horn ....................................... 13, 63
I
Identification plate .....................164
Ignition switch positions .............103
Immobiliser ............................ 26, 79
Indicators ...................................... 67
Information displays...................... 80
Initial drive information.................... 6 Instrument cluster ........................67
Instrument panel fuse box .........142
Instrument panel illumination .....139Instrument panel illumination
control ...................................... 92
Instrument panel overview ........... 10
Instrument panel storage ..............53
Interior care ............................... 159
Interior lighting ........................ 80, 92
Interior lights ........................ 93, 138
Interior mirrors .............................. 28
Introduction .................................... 3
ISOFIX child restraint systems ....52
J
Jump starting ............................. 155
K Kerb weight................................... 60Keys ............................................. 19
Keys, locks ................................... 19
L
Language ..................................... 80
Lashing eyes ......................... 59, 60
Light switch .................................. 89
Load compartment ................25, 55
Load compartment cover .............56
Load compartment lighting ...........94
Loading ......................................... 55
Loading information .....................60
Low engine oil level .....................79
Low fuel ....................................... 79M
Malfunction indicator light ............75
Manual adjustment ......................27
Manual anti-dazzle ......................28
Manual mode ............................. 112
Manual transmission .................. 109
Manual transmission automated 110
Manual windows ..........................29
Mirror adjustment ........................... 8
Misted light covers .......................92
Multifunction display .....................80
N New vehicle running-in ..............103
Number plate light .....................137
O Object detection systems ...........118
Odometer ..................................... 68
Oil, engine .......................... 162, 165
Operating windows from outside ..29
Outside temperature ....................64
Overhead console .......................54
Overrun cut-off ........................... 105
P Parking ................................ 18, 107
Parking assist ............................ 118
Parking brake ............................ 114
Particulate filter ........................... 108