display VOLKSWAGEN BEETLE CONVERTIBLE 2013 3.G Owner's Manual

Display
Different cruise control versions are available. The stored speed is shown in the instrument cluster
display on some equipment versions.
When the ignition is switched on, several warning and indicator lights come on briefly for a function
check. They go out after a few seconds.
WARNING
Failure to heed warning lights and instrument cluster text messages can cause the vehicle to
break down in traffic and result in a collision and serious personal injury.
x Never ignore warning lights or text WARNINGS.
x Always stop the vehicle as soon as it is safe to do so.
NOTICE
Failure to heed warning lights or text WARNINGS can result in vehicle damage.
Cruise control operation

Fig. 110 On the left side of the steering column: Cruise control buttons and switches.

Fig. 118 A: Bracket for hood support in the engine compartment. B: Hood propped open.
Please first read and note the introductory information and heed the WARNINGS
Opening the engine hood
x Before you open the hood, make sure that the windshield wiper arms are resting on the windshield
⇒ .
x Open the driver door and pull the inside hood release lever in the direction of the arrow ⇒ fig. 117
A. The engine hood is released from its latch by a spring ⇒ .
x Push the outside hood release lever B (arrow) and lift the hood all the way up.
x Pull the hood support out of its bracket in the direction of the arrow ⇒ fig. 118 A and insert it into
the opening in the hood B (arrow).
Closing the engine hood
x Lift the hood slightly ⇒ .
x Take out the hood support and clamp it in place in its bracket A.
x Lower the engine hood by hand until it is about 8 in. (20 cm) above its latch and then let it drop into
place to latch it. Do not push down on it afterwards!
If the hood does not close completely, open it again and close it properly.
When the hood is properly closed, you can see that it fits flush with the other body parts. The indicator
light in the instrument cluster display will go out
WARNING
If the hood is not closed properly, it could fly up and block your view while you are driving.
This can lead to a crash and serious personal injuries.
x After closing the engine hood, check that the hood release lever is properly latched into
the hood latch. The engine hood must be flush with the surrounding auto body parts.
x If you ever notice that the hood latch is not properly secured when the vehicle is moving,
stop at once and close it.
x Never let anyone get in the way of the hood when closing it.
NOTICE
x Make sure the windshield wiper arms are resting on the windshield before you open the
hood. Otherwise, the windshield wipers and the hood may be damaged.

Fig. 140 Convertible top emergency closing (2).
Please first read and note the introductory information and heed the WARNINGS on
page 290.
The convertible top can be closed by hand if there is a malfunction ⇒ . Before using the
emergency closing function, make sure the preliminary requirements for the normal convertible top
closing process are met 64.
Only use the convertible top emergency closing procedure if the top will not close even though all
of the technical requirements are met, or if all of the requirements cannot be met.
The X indicator light in the instrument cluster will flash if there is a convertible top malfunction. A
message providing information or instructions may also appear in the instrument cluster display. Only
perform these steps in the specified order.
1. Release the convertible top
Release the open convertible top as follows:
x Remove the cover (boot) from the convertible top if it is installed .
x Remove the hexagonal socket wrench for releasing the convertible top, the emergency handle for
latching the convertible top, and the screwdriver from the vehicle tool kit
x Unscrew the bolts ⇒ fig. 139 A (1) (arrow) on both sides of the convertible top counterclockwise
using the rounded end of the hexagonal socket wrench. Remove the bolts completely.
2. Close the convertible top
Lift the convertible top out of the tray and close it by hand as follows:
x Close the convertible top until it meets the windshield B (2) (arrow). Have a second person help
(one person on either side), if necessary ⇒ .
3. Latch the convertible top
Latch the convertible top using the emergency handle as follows:
x Carefully remove the front cover under the convertible top using the flat blade of the screwdriver
⇒ fig. 140 C (3). The emergency locking mechanism is located behind it.
x Push the end of the screw in the top of the emergency handle down so the end of the screw is
flush with the top of the handle.
x Insert the emergency handle in the emergency release opening and turn until it locks into place D
(4) (small arrow).
x Keep the handle pressed in place and turn the screw in the center of the emergency clockwise to
tighten using the Phillips head end of the screwdriver D (4).
x Turn the handle counterclockwise to open the convertible top hooks. You may have to push up on
the front of the convertible top slightly so the hooks can open all the way.