window VOLKSWAGEN BEETLE CONVERTIBLE 2013 3.G Owners Manual

Rear view

Fig. 3 Vehicle rear overview.
Key to fig. 3:
(1) Rear window
– Rear window defroster
(2) High-mounted brake light
(3) Volkswagen Emblem for opening the luggage compartment lid
(4) Taillights
(5) Threaded hole for the rear towing eye (behind cover)
(6) Rear license plate bracket
(7) License plate lights
(8) Luggage compartment lid

Driver door overview

Fig. 4 Overview of controls in the driver door.
Key to fig. 4:
(1) Indicator light for power locking system and anti-theft alarm system (if equipped)
(2) Buttons for operating the power windows , -
(3) Door handle
(4) Power locking button for locking and unlocking the vehicle 0

Convenience features
To use the convenience closing feature to close all power windows, hold your finger on the lock sensor
surface on the outside of the door handle for a few seconds until the windows close.
Remove your finger from the lock sensor surface ⇒ fig. 25 (B) to stop the function. If you touch the
unlock sensor surface (A) on the inside of the door handle immediately after releasing the lock sensor
surface (B) (arrow), all of the windows will open (safety function).
Pinch protection is active during convenience closing of the windows.
NOTICE
The door handle sensor surfaces can be activated by a strong stream of water or steam if a
valid vehicle key is within range of the vehicle.
x All windows may open if you turn the spray of water or steam away from and then back onto
the door handle sensor surface in quick succession. If at least one power window is opened
and the sensor is continuously activated, convenience closing is started.
The door may not open if the outside and inside door handles are used at the same time.
If the vehicle battery or the battery in the remote control vehicle key is weak or dead, it might not
be possible to unlock and lock the vehicle using Keyless Access. The vehicle can still be manually
locked or unlocked with the key bit 266.
The driver message Key not in range appears in the instrument cluster display if there is no
remote control vehicle key inside the vehicle or if the system does not recognize the remote control
vehicle key. The key may not be recognized, for example, if it is covered by something that interferes
with the signal (such as a briefcase), or if the remote control vehicle key battery is weak. Electronic
devices such as cell phones can also interfere with the signal.
Dirt on the door handles that contains a lot of salt (especially in winter) can affect the way the
door handle sensors work. Cleaning the door handles can help with this problem.
If the automatic transmission is not in Park (P) position, the electronic steering column lock will
not lock and the vehicle will not lock via sensors in the front door handles or the remote control vehicle
key.
Anti-theft alarm system
Please first read and note the introductory information and heed the WARNINGS
Your vehicle is either equipped with an anti-theft alarm system or pre-equipped for anti-theft alarm
system installation. If the vehicle is pre-equipped for installation of the anti-theft alarm system, the
alarm system can be retrofitted by an authorized Volkswagen dealer or an authorized Volkswagen
Service Facility.
The anti-theft alarm system makes it more difficult for someone to break into or steal the vehicle.
The anti-theft alarm system is automatically activated when the vehicle is locked by pressing the lock
button on the remote control vehicle key.

Power windows

Switches in the driver door
Key to fig. 29:
(1) For the rear side windows.
(2) For the window in the driver door and to open or close all other windows at the same time.
(3) For the window in the passenger door.
Opening or closing windows

Function Action
Opening: Press the switch.
Closing: Pull the switch.
Opening the driver door
window:
Press the -switch.
Closing the driver door
window:
Pull the - switch.
Opening all windows: Press and hold the - switch until all windows
open.
Closing all windows: Pull and hold the - switch until all windows close.
Stopping automatic
movement:
Press/pull the respective switch again.

You can still use the power windows for several minutes after the ignition is switched off as long as the
driver or passenger door has not been opened. When the vehicle key has been removed from the
ignition and the driver door has been opened, the power windows cannot be opened or closed.
Power windows – features

One-touch opening and closing
The one-touch feature automatically opens/closes a power window all the way. The window switch
does not have to be held down/up.
For one-touch opening: Press the switch for the window down briefly as far as it goes.
For one-touch closing: Pull the switch for the window up briefly as far as it goes.
Stopping automatic movement: Pull/press the switch again.
Reactivating the one-touch feature
If the vehicle battery is disconnected or dead and the windows are not completely closed, the one-
touch feature will not work and must be reactivated:
x Switch on the ignition.
x Close all windows and doors.
x Pull the -switch up and hold it for at least 2 seconds in this position.
x Release the - switch, pull up and hold again. The one-touch feature is now reactivated.
The one-touch feature can be reactivated for one or more windows at the same time.
Convenience closing
The convenience closing feature lets you close the windows from outside the vehicle as follows:
x Manual locking: lock the vehicle with the vehicle key bit in the driver door and keep the key turned
in the locking position to close all windows
x Vehicles with Keyless Access: hold your finger on the lock sensor surface on the outside of the
door handle for a few seconds until the windows close
WARNING
Improper use of power windows can result in serious personal injury.
x Never let anyone get in the way of a power window when closing it.
x When locking the vehicle from the outside, make sure that no one, especially children,
remains in the vehicle when the convertible top is closed. The windows will not open in case
of an emergency.
x Always take the key with you when you leave the vehicle. You can still use the power win-
dows for several minutes after the ignition is switched off as long as the driver or passenger
door has not been opened.
NOTICE
The windows must go down slightly when you unlock the vehicle. Otherwise the windows and
seals could be damaged when opening the doors.
If the power windows malfunction, the one-touch feature, as well as pinch protection may not
work properly. See an authorized Volkswagen dealer or authorized Volkswagen Service Facility right
away.
If convenience closing of the power windows from the outside requires removing the cover cap of
the lock cylinder on the driver door, the cover cap must be reinstalled after the vehicle is locked 266.

NOTICE
Objects with sharp edges or that cause scratches or dirty components can damage the con-
vertible top or the rear window.
x Never remove snow and ice with sharp objects or objects that can cause scratches.
x Only open and close the convertible top when it is clean.
NOTICE
If the convertible top is opened frequently when it is damp or it is left open for several weeks at
a time, it may develop creases and pressure marks and could be damaged.
x Do not leave the convertible top open for long periods of time.
x Only open the convertible top when it is completely dry.
When parking the vehicle with the convertible top open, the vehicle interior is not protected
against unauthorized access.
x Always close the convertible top and lock the doors and luggage compartment before leaving the
vehicle.
x Always store objects left in the vehicle in the locked luggage compartment.
The convertible top will only open or close when the luggage compartment lid is completely
closed. Do not open the luggage compartment lid when the convertible top is opening or closing.
Indicator lights

Lights
up Possible cause Proper response
X Convertible top is opening or closing. Wait until the convertible top has fully opened
or fully closed.


Flashes Possible cause Proper response

The convertible top opening or closing
process is not finished or there is a con-
vertible top malfunction.
Check if the opening or closing process has
finished. If necessary, end the process using
the convertible top button , Opening and
closing the convertible top.
Check if all technical requirements are met. If
not, take the necessary steps to meet the
technical requirements , General information.
Check if there is a convertible top malfunc-
tion. If necessary, correct the malfunction or
have the system checked by your authorized
Volkswagen dealer or authorized Volkswagen
Service Facility , What to do if the convertible
top will not move.

Opening and closing the convertible top

Fig. 30 In the roof console: convertible top button.
You can open or close the convertible top at speeds up to 30 mph (50 km/h). If the convertible top has
already begun opening or closing, it will stop if you exceed that speed. You can only continue opening
or closing the convertible top once the vehicle speed drops below about 30 mph (50 km/h).
For safety reasons, Volkswagen recommends opening or closing the convertible top only when the
vehicle is stationary and parked at a safe distance from moving traffic ⇒ .
Opening the convertible top
x Please note and follow the steps described in the checklists
x Switch on the ignition, if necessary
x Press and hold the button ⇒ fig. 30 in the roof console until all windows go down and the convert-
ible top is completely open ⇒ . A chime sounds and the indicator light in the instrument cluster
goes out when the process is complete. A message may also appear in the instrument cluster display.
x Secure the convertible top cover (boot), if necessary
Closing the convertible top
x Please note and follow the steps described in the checklists
x Switch on the ignition, if necessary
x Remove the convertible top cover (boot), if necessary
x Pull and hold the button until the convertible top and all windows close completely ⇒ : a chime
sounds and the indicator light in the instrument cluster goes out. A message may also appear in the
instrument cluster display.
Interrupting convertible top operation
Releasing the button interrupts convertible top operation ⇒ .

Not wearing or improperly fastening safety belts increases the risk of severe or fatal injuries. Safety
belts can work only when they are properly positioned on the body. An improper seating position
significantly impairs the protection provided by safety belts. This can cause severe or even fatal inju-
ries. Improper seating positions also increase the risk of serious injury or death when an airbag de-
ploys and strikes an occupant who is not in the proper seating position. The driver is responsible for all
passengers and especially children riding in the vehicle.
The following are only some examples of seating positions that will increase the risk of serious injury
or death.
Therefore, whenever the vehicle is moving:
x Never stand up in the vehicle.
x Never stand on the seats.
x Never kneel on the seats.
x Never ride with the seat backrest reclined.
x Never lean up against the instrument panel.
x Never lie down on the rear seat.
x Never sit on the edge of the seat.
x Never sit sideways.
x Never lean out the window.
x Never put your feet out the window.
x Never put feet on the instrument panel.
x Never rest your feet on the seat cushion or back of the seat.
x Never ride in the footwell.
x Never sit or stand on the armrests.
x Never ride without your safety belt properly fastened.
x Never ride in the luggage compartment.
WARNING
Contact with parts of the vehicle interior can cause serious personal injury in a crash.
x Always make sure that all vehicle occupants stay in a proper seating position and are
properly restrained whenever the vehicle is moving.
x Improper seating positions increase the risk of serious and fatal injury, especially when an
airbag deploys and strikes a passenger in an improper seating position.

Windshield made of heat-insulating glass

Fig. 76 Heat-reflective windshield with communications window (blue shaded area).
Please first read and note the introductory information and heed the WARNINGS
Windshields made of insulating glass have a transparent metallic infrared-reflecting coating. There is
an uncoated area (communications window) just above the inside rearview mirror ⇒ fig. 76. This
serves as a communications window for transmitting signals to and from electronic components and
accessories.
The uncoated area must not be blocked on the inside or outside or covered with stickers because this
can cause the electronic components to malfunction.