boot VOLKSWAGEN TRANSPORTER 1990 T4 / 4.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine
DO-IT-YOURSELF-SERVICE
IB25-325I

Front
turn
signal / parking
light
bulb/

front
side
marker
light
bulb

• Remove
the two
Phillips screws
and

take
off
the lens cover.
• Pull
out
bulb holder and push down
the

rubber boot.
•
Press
spring clip inward
and
take
out

bulb holder.
• Give bulb
a
left
turn
and remove.
• Replace bulb
and
reverse
the
above
procedure
to
install bulb holder
and
lens

cover.
Rear
turn
signal, stop /
tail
/
back-up
light
bulb

• Remove
the
four Phillips screws
and

take
off
lens cover
with
bulb housing. • Squeeze
the two
side springs inward

(arrow)
and
lift
out
the bulb housing.
•
Press
defective bulb
into
bulb holder

turn
left
and take
out
bulb.
• Replace bulb
and
reverse
the
above
procedure
to
install bulb housing
with
lens

cover.

132


www.westfaliaT3.info - a useful website for owners and enthusiasts of VW Westfalia T25 / T3 Campervans

Downloaded from www.Manualslib.com manuals search engine
DO-IT-YOURSELF-SERVICE

Rear
side
marker
bulb
• Remove the two Phillips screws and
take off lens cover.
• Pull out bulb holder and push down the
rubber boot.
•
Press
spring clip outward and take out
bulb holder.
• Give bulb a
right
turn
and remove. • Replace bulb and reverse the above
procedure to install bulb holder and lens

cover.
Interior
light

• To remove lamp, press against spring
clip on
left
side and
lift
out the housing.
• Take out bulb from between the two
spring contacts and install new bulb.
• Install lamp by inserting switch side of
housing
into
cut-out
first.

• Then press in the other side
until
spring
clip engages. License
plate
light
bulb

There is one bulb housing on each side of the license plate. Only if both bulbs are
operative is the license plate properly illuminated.
• Take the bulb housing off by pulling it
down.
• Remove the two Phillips screws and
take off lens cover.
•
Press
bulb
into
housing,
turn
left
and
take out.
• Replace bulb and reverse above proce­
dure to install bulb housing and lens cover.

Make
sure the spring clip on each side of
the housing is securely engaged in the
cutouts provided at upper edge of cross
panel.

133


www.westfaliaT3.info - a useful website for owners and enthusiasts of VW Westfalia T25 / T3 Campervans