ECU VOLVO XC70 2007 Owner's Manual

2007 Volvo XC70
pg. 105 Interior
Cargo area
Cargo net (accessory)
Models with 2-section rear seat
Your vehicle can be equipped with a cargo net made of strong nylon fabri\
c that can be unrolled from the
rear seat backrest. After being unrolled, the cargo net self-locks after\
about a minute.
- Pull up the right-hand cargo net.
- First hook the rod in the bracket on the right-hand side (A). Then p\
ull the rod out and hook it on the
left-hand side (B).
- Pull up the left-hand cargo net and secure it to the rod.
To remove, proceed in reverse order.
NOTE:
l Make sure that the cargo net is securely fastened in the hooks. To remov\
e, proceed in reverse order.
l The cargo net can also be used when the rear seat is folded forward.
pg. 106 Interior
Cargo area
file:///K|/ownersdocs/2007/2007_XC70/07xc70_04.htm (27 of 29)12/30/200\
6 5:51:33 PM

2007 Volvo XC70
CAUTION!
If the net is installed in the forward position and the rear seat cushio\
ns are folded forward, the net
should be positioned so that it is in front of the rear seat cushions bu\
t behind the front seat backrests
(E).
The eyelets on the floor of the vehicle under the front seats must not b\
e used to secure the lower
straps of the cargo net. If these eyelets are used and the front seats a\
re moved back, the cargo net or
upper brackets may be damaged.
pg. 107 Interior
Cargo area
WARNING!
l The nylon cargo net must not be used when the optional rear-facing auxil\
iary child seat in the
cargo area is in use.
l When not in use, the cargo net should not be stored unattached in the ve\
hicle to prevent it from
being thrown forward in the event of a sudden stop etc.
pg. 108 Interior
This page left intentionally blank.


Contents | Top of Page
file:///K|/ownersdocs/2007/2007_XC70/07xc70_04.htm (29 of 29)12/30/200\
6 5:51:33 PM

2007 Volvo XC70
Emergency towing
The towing eyelet is located in the tool bag, under the floor of the car\
go area, with the spare tire. This
eyelet must be screwed into the positions provided on the right sides of\
either the front or rear bumper
(see illustrations).
To attach the towing eyelet:
A. Use a coin to pry open the lower edge of the.
B. Screw the towing eyelet (C) in place, first by hand and then using \
the tire iron until it is securely in
place.
After the vehicle has been towed, the eyelet should be removed and retur\
ned to the tool bag. Press the
cover back into position.
Precautions when the vehicle is in tow
l The steering wheel must be unlocked. Turn the ignition key to position I\
or II.
l The gear selector must be in position N.
l Maximum speed: 50 mph (80 km/h). Do not exceed the maximum allowable t\
owing speed.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (28 of 41)12/30/200\
6 5:51:38 PM

2007 Volvo XC70
l Maximum distance with front wheels on ground: 50 miles (80 km).
l While the vehicle is being towed, try to keep the tow rope taut at all t\
imes.
l The vehicle should only be towed in forward direction.
CAUTION!
- Please check with state and local authorities before attempting this t\
ype of towing, as vehicles being
towed are subject to regulations regarding maximum towing speed, length \
and type of towing device,
lighting, etc.
- If the vehicle's battery is dead, do not attempt to start the vehicle \
by pushing or pulling it as this will
damage the three-way catalytic converter(s). The engine must be jump s\
tarted using an auxiliary
battery (see
page 144).
- If the vehicle is being towed on a flat bed truck, the towing eyelets \
must not be used to secure the
vehicle on the flat bed. Consult the tow truck operator.
pg. 143 Starting and driving
Towing
WARNING!
Remember that the power brakes and power steering will not function when\
engine is not running.
The braking and steering systems will function but the brake pedal press\
ure required is 3 - 4 times
above normal and greater steering effort must be exerted.
The towing eyelets must not be used for pulling another vehicle out of a\
ditch or for any similar
purpose involving severe strain.
Do not use the towing eyelets to pull the vehicle up onto a flat bed tow\
truck.
Towing vehicles with front wheel drive/All Wheel Drive
Volvo recommends the use of flat bed equipment.
If wheel lift equipment must be used, please use extreme caution to help\
avoid damage to the vehicle. In
this case, the vehicle should be towed with the rear wheels on the groun\
d if at all possible.
If it is absolutely necessary to tow the vehicle with the front wheels o\
n the ground, please refer to the
towing information on the previous page.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (29 of 41)12/30/200\
6 5:51:38 PM

2007 Volvo XC70
CAUTION!
Sling-type equipment applied at the front will damage radiator and air c\
onditioning lines.
It is equally important not to use sling-type equipment at the rear or a\
pply lifting equipment inside the
rear wheels; serious damage to the rear axle may result.
If the vehicle is being towed on a flat bed truck, the towing eyelets mu\
st not be used to secure the
vehicle on the flat bed. Consult the tow truck operator.
WARNING!
Do not use the towing eyelets to pull the vehicle up onto a flat bed tow\

truck.
pg. 144 Starting and driving
Jump starting
Jump starting
Follow these instructions to jump start your vehicle's dead battery or t\
o jump start another vehicle's dead
battery using your vehicle. Although your vehicle's battery is located u\
nder the floor of the cargo area,
jumper cables should be connected in the engine compartment, to the points shown in the illustrations.
If the 12-volt auxiliary battery to be used is in another vehicle, check\
that the vehicles are not touching
to prevent premature completion of a circuit. Be sure to follow jump sta\
rting instructions provided for
the other vehicle.
To jump start your vehicle
- Switch off the ignition.
- First connect the auxiliary battery positive (+) terminal (1) to t\
he positive (+) terminal in your vehicle's
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (30 of 41)12/30/200\
6 5:51:38 PM

2007 Volvo XC70
assembly.
- Slide the ball holder into the hitch assembly.
- Align the hole in the ball holder with the one in the hitch assembly. \
- Slide the locking bolt through the hitch assembly/ball holder.
- Insert the cotter pin in the hole at the end of the locking bolt.
Removing the ball holder
- Remove the cotter pin from the locking bolt and slide the locking bolt\
out of the ball holder/hitch
assembly.
- Pull the ball holder out of the hitch assembly.
A cover for the hitch assembly can be purchased from your Volvo retailer\
.
pg. 148 Starting and driving
Load carriers (accessory)
Load carriers
Load carriers are available as Volvo accessories. Observe the following \
points when in use:
l To avoid damaging your vehicle and to achieve maximum safety when drivin\
g, we recommend using
the load carriers that Volvo has developed especially for your vehicle. \
l Volvo-approved removable roof racks are designed to carry the maximum al\
lowable roof load for this
vehicle: 220 lbs (100 kg). For Non-Volvo roof racks, check the manufac\
turer's weight limits for the rack.
l Never exceed the rack manufacturer's weigh limits and never exceed the m\
aximum rated roof load of
220 lbs (100 kg).
l Avoid single-point loads. Distribute loads evenly.
l Place heavier cargo at the bottom of the load.
l Secure the cargo correctly with appropriate tie-down equipment.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (34 of 41)12/30/200\
6 5:51:38 PM

2007 Volvo XC70
l Check periodically that the load carriers and load are properly secured.\

l Remember that the vehicle's center of gravity and handling change when y\
ou carry a load on the roof.
l The vehicle's wind resistance and fuel consumption will increase with th\
e size of the load.
l Drive smoothly. Avoid rapid starts, fast cornering and hard braking.
Attaching load carriers
The attachment brackets for the load carriers are located under the roof\
molding.
- Make sure that the load carriers are placed in the right direction. Se\
e the mark on the decal under the
cover.
- Press the guide lugs into the holes (1).
- Carefully lower the opposite side of the load carrier to the roof.
- Loosen the tightening wheel slightly. Slide the hook on the load carri\
er attachment into the attachment
bracket under the roof molding.
- Turn the tightening wheel to secure the load carrier in the attachment\
bracket.
pg. 149 Starting and driving
Load carriers (accessory)
- Repeat this procedure for the other load carrier attachments.
- Check that the hooks on all four load carrier attachments are securely\
tightened in the respective
attachment brackets on the roof of the vehicle.
- Press down the covers.
Check periodically that the load carriers and load are properly secured.\

pg. 150 Starting and driving
file:///K|/ownersdocs/2007/2007_XC70/07xc70_06.htm (35 of 41)12/30/200\
6 5:51:38 PM

2007 Volvo XC70
The spare tire, jack and tool bag are located under the floor of the car\
go space. To access the spare tire:
- Remove the rear hinged floor panel by raising it approx. 6 inches (15\
cm) and then pulling it
backwards out of the cargo area.
- Unscrew and remove the accessory plastic floor tray (if fitted).
- Unstrap and lift out the jack and tool bag.
- Unscrew the securing bracket and remove the spare tire from the storag\
e well.
- When putting the tire back into the well, perform these steps in rever\
se order. Make sure the spare tire,
jack and tool bag are properly secured.
WARNING!
Make sure that the spare tire, jack and tool bag are properly secured wi\
th the securing bracket and
strap to help keep these components in place in the event of a sudden st\
op.
pg. 173 Wheels and tires
Temporary spare
file:///K|/ownersdocs/2007/2007_XC70/07xc70_07.htm (19 of 24)12/30/200\
6 5:51:40 PM

2007 Volvo XC70
Spare tire, tool bag, jack - vehicles with subwoofer (option)
The spare tire, jack and tool bag are located under the floor of the car\
go space in a compartment in front
of the spare tire. To access the spare tire:
- Remove the rear hinged floor panel by raising it approx. 6 inches (15\
cm) and then pulling it rearward
out of the cargo area.
- Raise the other floor panel to upright position and lock it there.
- Remove the mat.
- Loosen the wheel and turn the clip 90°.
- Lift the subwoofer inward-upward with both hands and tilt it leftward.\

- Unstrap and lift out the jack and tool bag.
- Unscrew the securing bracket and remove the spare tire from the storag\
e well.
- When putting the tire and subwoofer back into place, perform these ste\
ps in reverse order. Make sure
the spare tire, jack, tool bag and subwoofer are properly secured.
WARNING!
Make sure that the spare tire, jack and tool bag are properly secured wi\
th the securing bracket and
strap to help keep these components in place in the event of a sudden st\
op.
pg. 174 Wheels and tires
Changing wheels
file:///K|/ownersdocs/2007/2007_XC70/07xc70_07.htm (20 of 24)12/30/200\
6 5:51:40 PM

2007 Volvo XC70
Changing wheels
The spare wheel is located under the rear hatch in the cargo area floor.\
The jack and crank are secured in
the wheel recess (see
pages 171 and 173).
There are two jack attachment points on each side of the vehicle (see i\
llustration on next page).
To change a wheel:
- Engage the parking brake.
- Put the gear selector in (P)ark (automatic transmission) or revers\
e (manual transmission).
- Remove the wheel cap (where applicable) using the lug wrench in the \
tool bag.
- With the vehicle still on the ground, use the lug wrench to loosen the\
wheel bolts 1/2 - 1 turn by
exerting downward pressure. Turn the bolts counterclockwise to loosen.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_07.htm (21 of 24)12/30/200\
6 5:51:40 PM