light YAMAHA GRIZZLY 125 2005 Notices Demploi (in French)

1
1. Headlight bulb1. Ampoule de phare1. Billas del faro
8-89
4. Remove the defective headlight bulb by
pulling it out of the socket.
w
A headlight bulb is hot when it is on and
immediately after it is turned off. Wait for the
bulb to cool before touching or removing it.
You can be burned or a fire could start if the
headlight bulb touches something flamma-
ble.
5. Install a new headlight bulb into position.
6. Install the bulb holder by pushing it inward
and turning it clockwise.
7. Install the bulb holder cover.
8. Install the cover at the rear of the headlight.
1C5-9-61-08 9/4/04 9:30 AM Page 8-90

1. Bulb holder1. Fixation d’ampoule1. Portabombillas
1. Bulb 2.Bulb holder
1. ampoule 2.Fixation d’ampoule1. Bombilla 2.Portabombillas
8-91
EBU00861
Tail/brake light bulb replacement
1. Remove the bulb holder (together with the
bulb) by turning it counterclockwise.
2. Remove the defective bulb from the bulb
holder by pushing it inward and turning it
counterclockwise.
3. Install a new bulb in the bulb holder by push-
ing it inward and turning it clockwise.
4. Install the bulb holder (together with the bulb).
1
qw
1C5-9-61-08 9/4/04 9:30 AM Page 8-92

8-93
EBU10890
Headlight beam adjustment
cC
It is advisable to have a Yamaha dealer make
this adjustment.
To raise the beam, turn the adjusting screw in
direction a.
To lower the beam, turn the adjusting screw in
direction b.a
b
1
1. Adjusting screw1. Vis de réglage1. Tornillo de ajuste
1C5-9-61-08 9/4/04 9:30 AM Page 8-94

8-97
w
Do not smoke when checking the fuel sys-
tem. Fuel can ignite or explode, causing
severe injury or property damage. Make sure
there are no open flames or sparks in the
area, including pilot lights from water
heaters or furnaces.
1C5-9-61-08 9/4/04 9:30 AM Page 8-98

9-9
3. Clean the drive chain thoroughly and lubri-
cate it. (See page 8-59.)
4. Lubricate all control cables.
5. Block up the frame to raise all wheels off the
ground.
6. Tie a plastic bag over the exhaust pipe out-
let to prevent moisture from entering.
7. If storing in a humid or salt-air atmosphere,
coat all exposed metal surfaces with a light
film of oil. Do not apply oil to any rubber
parts or the seat cover.
8. Remove the battery and charge it. Store it in
a dry place and recharge it once a month.
Do not store the battery in an excessively
warm or cold place (less than 0°C or more
than 30°C).
NOTE:
Make any necessary repairs before storing the
machine.
1C5-9-61-09~11 9/4/04 9:29 AM Page 10

10-5
Model YFM125G
Shock absorber:
Front Coil spring/Oil damper
Rear Coil spring/Oil damper
Wheel travel:
Front 70 mm
Rear 80 mm
Electrical:
Ignition system DC. C.D.I.
Charging system A.C. Magneto
Battery type/voltage, capacity 12N12C-4A-2/12V, 12Ah
Headlight type: Bulb
Bulb volgate, wattage ×quantity:
Headlight 12V, 30 W/30 W ×2
Tail/brake light 12V, 5 W/21 W ×1
Indicator light:
Neutral 12V, 1.7 W ×1
Reverse 12V, 1.7 W ×1
Fuse: 15A
1C5-9-61-09~11 9/4/04 9:29 AM Page 16