torque YAMAHA GRIZZLY 450 2012 User Guide

8-34
8
2. Remove the tailpipe by pulling it out of the
muffler.
3. Tap the tailpipe lightly, and then use a wire brush to remove any carbon deposits from the
spark arrester portion of the tailpipe and inside
of the tailpipe housing. 4. Insert the tailpipe into the muffler and align the
bolt holes.
5. Install the tailpipe bolts and tighten them to the specified torque.
1. Tailpipe bolt
2. Tailpipe
1. Tailpipe
2. Spark arresterTightening torque:Tailpipe bolt:10 Nm (1.0 m ·kgf, 7.2 ft· lbf)
U1CT61E0.book Page 34 Wednesday, April 20, 2011 6:36 PM

8-44
8
1. Remove the footboard by removing the bolts
and nuts.
2. Loosen the locknut. 3. Turn the adjusting bolt in or out until the brake
pedal height is within the specified limits.
4. Tighten the locknut.
5. Install the footboard by installing the bolts and nuts, and then tighten them to the specified
torques.
1. Footboard
2. Bolt22
21
1. Locknut
2. Adjusting boltTightening torque:Locknut:7 Nm (0.7 m ·kgf, 5.1 ft ·lbf)
21
U1CT61E0.book Page 44 Wednesday, April 20, 2011 6:36 PM

8-45
8Adjusting the brake pedal free play
The brake pedal free play should measure 20.0
mm (0.79 in). If the free play is incorrect, adjust it
as follows.
TIPThe brake lever free play and brake pedal height
must be adjusted before adjusting the brake pedal
free play.1. Loosen the locknut.
1. Footboard bolt A
2. Footboard bolt BTightening torques:Footboard bolt A:4.0 Nm (0.40 m ·kgf, 2.9 ft· lbf)
Footboard bolt B: 7 Nm (0.7 m ·kgf, 5.1 ft ·lbf)11
2
1. Brake pedal free play
U1CT61E0.book Page 45 Wednesday, April 20, 2011 6:36 PM

8-60
8

Tapered nuts are used for both the front and rear
wheels. Install the nuts with their tapered side to-
wards the wheel.
3. Lower the ATV to the ground.
4. Tighten the wheel nuts to the specifiedtorques.
1. Arrow mark
1
1. Tapered nutTightening torques:Front wheel nut:55 Nm (5.5 m ·kgf, 40 ft ·lbf)
Rear wheel nut: 55 Nm (5.5 m ·kgf, 40 ft ·lbf)
U1CT61E0.book Page 60 Wednesday, April 20, 2011 6:36 PM