cooling YAMAHA KODIAK 450 2018 User Guide

8-65
8Engine overheating
WARNING
EWB02291Wait for the engine and radiator to cool before removing the radiator cap. You could be burned by
hot fluid and steam blown out under pressure. Always put a thick rag over the cap when opening.
Allow any remaining pressure to escape before completely removing the cap. TIPIf coolant is not available, tap water can be temporarily used instead, provided that it is changed to the
recommended coolant as soon as possible. Wait until the
engine has cooled.
Check the coolant level in the
reservoir and radiator.
The coolant level
is OK.The coolant level is low.
Check the cooling system
for leakage.
Have a Yamaha dealer check
and repair the cooling system.Add coolant. (See TIP.)
Start the engine. If the engine overheats again, have a
Yamaha dealer check and repair the cooling system.
There is
leakage.
There is
no leakage.
UBB560E0.book Page 65 Friday, March 10, 2017 10:20 AM

12-2
12
MMain switch .................................................................... 4-1
Maintenance and lubrication chart ................................ 8-4
Maintenance chart, emission control system ................ 8-3
Model label .................................................................. 11-1NNeutral indicator light ..................................................... 4-2OOn-Command four-wheel-drive switch ......................... 4-7
Owner’s manual and tool kit .......................................... 8-2PPanels, removing and installing ..................................... 8-8
Park indicator light ......................................................... 4-2
Parking ........................................................................... 6-4
Parking on a slope ......................................................... 6-5
Part locations ................................................................. 3-1RRear brake, adjusting the lever and pedal ................... 8-40
Rear knuckle pivots, lubricating .................................. 8-49
Reverse indicator light ................................................... 4-2
Riding your ATV ............................................................. 7-1SSafety information .......................................................... 2-1
Seat .............................................................................. 4-13
Self-diagnosis device .................................................... 4-6
Shock absorber assemblies, adjusting the front and rear ............................................................................ 4-15
Spark arrester, cleaning ............................................... 8-33
Spark plug, checking ................................................... 8-15
Specifications .............................................................. 10-1
Speed limiter .................................................................. 4-9 Stabilizer bushes, checking ..........
............................... 8-49
Starting the engine ........................................................ 6-1
Start switch .................................................................... 4-7
Steering shaft, lubricating ............................................ 8-50
Storage .......................................................................... 9-2
Storage compartment .................................................. 4-14
TTail/brake light bulb, replacing .................................... 8-61
Throttle lever ........................................................... 4-8, 5-4
Throttle lever free play, adjusting ................................ 8-36
Tires ............................................................................... 5-4
Troubleshooting ........................................................... 8-63
Troubleshooting charts ................................................ 8-64VValve clearance ............................................................ 8-36
V-belt case drain plug .................................................. 8-35
V-belt cooling duct check hose ................................... 8-35
Vehicle identification number ...................................... 11-1WWheel hub bearings, checking .................................... 8-48
Wheel, installing ........................................................... 8-62
Wheel, removing .......................................................... 8-61
Winch pre-wiring .......................................................... 4-17
UBB560E0.book Page 2 Tuesday, May 9, 2017 5:32 PM